How can a new laptop be connected to the Internet? What needs to be done, please elaborate

First of all, determine whether there is a network cable installation condition nearby, that is, the landline ** line;

At the same time, is your computer in place, that is, have you bought it home?

Then go to the operator, not buy and sell mobile phones of those small shops are operators, generally in small towns, divided into mobile Unicom Telecom Tietong, etc., telecommunications is the most common, to inquire about how much it costs to install network cables to open the network network, the network of various speeds around the world is not the same, ask yourself, if there is already a landline, then go directly to the payment office of the landline** to ask and open it.

If it is in some areas where the landline ** line does not pass, then the network cable can not be installed basically, and you can only buy a "mobile terminal" and use a network card to connect to the Internet, but the tariff is relatively expensive, and the signal is not necessarily good.

The network is over here.,After you install and open the network, the person who will explain to you how to access the Internet.,It's much more impressive than our netizens explain here.,It's basically over.。

I'll talk a little bit about the next steps, the person who comes to install and open the network will give you a 'small box', that thing is commonly known as [cat or modern], it is a network converter, with it and open the network, then you can connect to the network, with a two-socket network cable, one end to connect to the computer, one end to connect to the cat, open the broadband connection on the desktop, enter the password of your network cable (the installer will tell you what it is), so that you can achieve the network in the wired state.

The networking in the wireless state is slightly more complicated, it is recommended that if you want to use wireless, then buy a wireless router when installing the network cable, and let the person who installs it do it for you, so that the general smartphone can connect to the wireless network of the computer, and there is no need for mobile phone traffic, and the network speed is super good.

Because if you don't understand anything, like some very professional but simple things in the wireless router, you can't understand it when I say it, so it's better to leave it to the installer.

If there is a wireless point, there is a signal icon in the lower right corner, and then enter the router settings and password.

Open the opportunity? Is it wireless or wired? What system?

Taking Lenovo Xiaoxin notebook as an example, notebook networking can be carried out in two ways: wireless or wired. If it is wireless, then turn on the wireless function of the computer, search for the corresponding wifi name and enter the slippery password to connect to the Internet. If it is a wired connection, plug the network cable that can access the Internet into the network port of the laptop.

Here's how to set it up:

1. First of all, the network cable that can be found on the network cable of the laptop corresponding to the network port (pay attention to the card slot of the crystal head and the network port card slot of the notebook), as shown in the following figure:

2. Insert the crystal head of the network cable into the network port of the notebook, as shown in the following figure:

3. At this time, you can see the network connection sign in the lower right corner of the computer to show that it has been connected to the network and can access the Internet, as shown in the following figure

Summary. Yours, you can do it by following these steps:1

Wi-Fi Connection: - Turn on your laptop and make sure the wireless card is enabled. - Find the Wi-Fi icon on the system tray and tap to open Wi-Fi settings.

Find the list of available wireless networks and select the network you want to connect to. - If the network is password protected, the correct Wi-Fi password needs to be entered. - Wait for a few seconds until you successfully connect to the Wi-Fi network.

2.Wired connection (via Ethernet): Look for the Ethernet port on your laptop (usually an RJ-45 interface).

Use an Ethernet cable to connect your laptop to your router or modem. One end is plugged into the Ethernet port on the laptop, and the other end is plugged into an available Ethernet port on the router or modem. - Wait for a few seconds and the laptop will automatically recognize and establish a wired connection.

Yours, you can do it by following these steps:1Wi-Fi Connection:

Turn on your laptop and make sure the wireless card is enabled. - Find the Wi-Fi icon on the system tray and tap to open Wi-Fi settings. Find the list of available wireless networks and select the network you want to connect to.

- If the network is password protected, the correct Wi-Fi password needs to be entered. - Wait for a few seconds until you successfully connect to the Wi-Fi network. 2.

Wired connection (via Ethernet): Look for the Ethernet port on your laptop (usually an RJ-45 interface). Use an Ethernet cable to connect your laptop to your router or modem.

One end is plugged into the Ethernet port on the laptop, and the other end is plugged into an available Ethernet port on the router or modem. - Wait a few seconds for the laptop to automatically recognize and establish a wired connection.

Hello, make sure that the wireless network or wired network you are connected to is stable and working properly. If you're experiencing network issues, check that your wireless router or wired device is functioning properly and make sure you're entering the correct Wi-Fi password (if applicable). Also, make sure your operating system is updated to the latest version of the Cavebook, which can often provide better network connection support.