But there will always be traces of water after injury. How?

Hello, if you hurt me, there will always be traces, which means that you have hurt him, and now he can't help it, you can say that I will wait for your traces to be repaired.

If you have been hurt, there will definitely be moisture, so when you have really been hurt, you will find traces or it is very clear.

If you have been hurt, you will leave traces, but if you want to recover, there is a way, it depends on how you do it, you have to find the right material to make the water trace smaller or disappear, you he, you are willing to pay a hundred times more effort to smooth out this trace to struggle, I think as long as you are a person with a heart, you will move forward steadily, do it seriously, and the future is bright.

But there will always be traces of water after injury. Then you and him, since you have been hurt, there will already be traces in your heart, but as long as you repent, be good to her, and treat her wholeheartedly, these traces will slowly disappear.

That's how you say that there will be traces of water after the injury, and you will wipe it clean.

But if you have been hurt, there will always be water agent, if you want to come back, that is to say, if you have been hurt, you will definitely have to leave some traces, and there will be some trauma in the soul, but people must learn to look forward and learn to forget.

But there will always be traces of water if you have been hurt, if your feelings have been hurt, then you can reply to him and let time erase the wounds in your heart!

You can reply to the other party, and indeed as long as you have been hurt, there must be traces left, and you can't erase them.

There must be traces of hurt, but you have to erase the traces slowly, don't let the traces stay in your heart, so that you will be unhappy, and making yourself happy is the ultimate goal.

If it were me, I would have him, as long as this thing happened, it wouldn't be gone, and there would be no trace of how much it would leave some impression in my heart, just to see if I could make up for it later, and earn back the impression a little bit.

You can do this: not everything has traces, and some things can be wiped clean if they have been done.

I think that there will always be traces of water that have been hurt, and you should say that those who have been hurt will definitely leave traces, and its scars can be filled with warmth.

However, there will be traces of water after injury, there may be traces, but there are no certain.

Yes, there are always traces after a heartbreak, and even if the relationship gets better, that trace will never be removed.

There will always be traces of this injury, you can be the other party, after a long time, you will forget it, and you will not be able to remember it slowly.

Then I had to sit on a small rag and wipe the water stain dry, so that it would no longer have scars, no more sadness, no more sadness, and everything would change with me.

Then it means that as long as it is a person who has been hurt, then there must be a wound in that place.

However, if there is water in the water, then it can be dried slowly.

I think you can reply to the other person. Some injuries are invisible. It can be said to be an internal injury.

But how can there be water if you have loved deeply, that is possible, and it is really difficult for you to recover to Yang Mi if you have hurt people.

In this case, the meaning of its words is what it seems.

Yes, if you have been hurt, there will definitely be traces, so when you see traces, you have already been hurt once, and there will be a second time.

The high concentration of calcium, magnesium ions and carbonate ions in water (water is too hard) is precipitated due to the evaporation of water during the boiling process, and comes into contact with carbon dioxide in the air, forming calcium carbonate and magnesium hydroxide that are difficult to dissolve in water, which is the water stain (scale) we see in our daily life.

How to remove limescale.

Slight scale: pour the same amount of water and vinegar into the spray bottle, spray the vinegar solution on the surface of the scale, let it stand for a few minutes and wipe it off;

Stubborn scale: Pour the vinegar into the kettle with water stains, add water and boil and let it stand for about 10 minutes, then pour out the vinegar solution and wipe it clean.

How to prevent the formation of scale: put the peel scraped off when eating the potato into the kettle, add water to boil and pour it out, which can play a role in preventing the accumulation of scale;

TipsIn general, water stains formed by the high content of calcium and magnesium ions in the water are not harmful to the human body.

It means that your local water is harder, that is, there are more minerals, or you haven't washed the kettle for a while

Squeeze some toothpaste and rub it to see if the toothpaste may be more effective.

It is normal for the toilet to leave a part of the water in it after each flush. You can buy some hydrochloric acid and soak it in the toilet bowl for 10 to 15 minutes (to cover the toilet) to clean it. (Pour 5 6 ml, but in the toilet bowl with an appropriate amount of water).

First of all, it is necessary to distinguish what causes the water spots (stains) not to dry.

If there is a large amount of water under the stone (e.g., after the paving is completed, use a cutting machine to add water to cut the ground; The ground is saturated with moisture before paving; After installation, a large amount of water infiltrates into the joints, etc.), so that the cement pavement that should be dry peaks and sockets is saturated with water, and the ground should be air-dried, or after a long period of natural drying, the water in the cement in the paving layer evaporates, and then the stone itself is treated. If you blindly clean with chemicals at this time, it will often aggravate the phenomenon of immersion.

The reason is simple, cleaning is done with water, and water can never wash off the water, only evaporation is reasonable. Some people use the method of heating, if the hot air drying method is used, it is okay, but it is not suitable for a large area to be used a lot; And the use of fire, lamp baking and other methods, its effect is not ideal, this kind of method can quickly increase the temperature of the stone surface and can not increase the temperature of the cement layer for a long time, the evaporation effect of water will not be too obvious, and the negative effect is very large. Due to the rapid heating will make the stone swell, and the cement layer layering will cause hollowing, sometimes it will cause the stone to warp, resulting in a cut, the consequences are difficult to control artificially, it is recommended not to use.

According to our treatment experience, in the case of a clear understanding (it can be clearly understood through investigation and detailed analysis) that the cement layer is indeed not in a water-saturated state, the appropriate granite cleaning agent can be selected to mix the marble deep cleaning agent with the ratio of l:1, and then mix it with clean water according to l:1, and use a heavy-duty scrubbing machine to clean it comprehensively, so that the chemical solution can enter the water crystals and metal salt crystals between the stone decomposition crystal cracks and cleavage, and wash them with water within half an hour to 2 hours.

There are two points to pay attention to in this method, the first is that too much chemical solution should not be leaked into the stone joint (if the amount is very small, it can be ignored), so as not to damage the cement layer; The second is that after cleaning with water, it must be dried in time, and the water content of the cement layer must not leak into the stone joints to increase the water content of the cement layer.

The principle of this method is also very simple: while destroying the water crystals and metal salts between the cracks and cleavage of the stone crystals, the micro-explosion effect opens the ventilation channel of the stone, accelerates the evaporation of water, and the stone is steamed off the water and dried, rather than washed and dried. This method generally has a further superficial effect within a few hours, and the reason is that the effect is obvious within 3-7 days.

If there is an effect, but it cannot be completely eliminated, it is necessary to further analyze two reasons: first, whether the water content in the cement layer is too high? Second, is the amount of chemical solution used insufficient?

Do it a second time.

I didn't go to the scene, I can't say for sure, but there are usually several possibilities for water seepage on the wall

1. Because the condensate formed by the cold outside the wall and the heat inside the wall causes the wall to be damp, this situation usually occurs in winter, and it is the whole wall, and the wall of your home can basically rule out this situation.

2. There is a leakage of the embedded water pipe in the wall, which causes the wall to be damp.

This includes whether there is a leak in the water pipes in your home and your neighbors (if the wall is next door to the neighbor), you can first determine if there are water pipes in the wall, and if there is no water pipe in the wall at all, you can rule it out.

If there are water pipes, there is a possibility of leakage, and the only way to do it is to chisel the wall to find the leak and repair it, and then rebuild the wall.

3. Water infiltration of the partition wall.

The waterproofing of the ground next door is not good, once there is water on the ground, it will slowly penetrate into you, in this case, only after finding the leakage point, re-waterproofing the ground next door, and then restore the wall and ground.

4. The wall is not dry when it is decorated, and now it is damp, if your home is not like this, it can be ruled out.

When looking for leaks, you can find the initial leakage points according to the humidity of the wall, and it is recommended to find experienced professionals, which will be safer.

If there is no pipeline in that place, it is estimated that the concrete has not vibrated and compacted, and you can handle it yourself.

Use a chisel to chisel the leaking place one or two centimeters, buy some Beijing Jintang water without leakage treatment (according to the instructions), it is very affordable, only about 20 yuan, and the effect is also very good.

Vinegar can not only be used as a condiment, but also solve a lot of troubles for us in life. For example, if the stainless steel in the home has a watermark, it can still be solved, and the specific method is as follows:

1.Dissolve one tablespoon of salt in two tablespoons of white vinegar, scrub the surface of the object, and rinse with water.

2. When wiping stainless steel utensils, take the orange peel and rub it with the inner layer to stain it with dirt powder, which can prevent the appearance of abrasion marks and make it look extraordinarily bright.

3.Soaking scouring a scouring wipe in beer and then rubbing stainless steel products can have a quick and clean effect.

How can it be? Stains are mainly water stains and soap stains, which are fundamentally different from the dirt and oil stains commonly found in the room and kitchen. Water stains are film-like residues formed after tap water splashes or stays on the surface of hard objects, mainly carbonate stains, with stable structure and strong adhesion.

Soap stains are made up of water stains, soap residues and oil on the human body mixed and dried, and it is difficult to remove them completely with ordinary cleaning products.

The water cup is placed in a damp place, and where there is water, there are microorganisms, and those water traces should be similar to moss or something, scale.

The cup becomes cold due to the heat transfer of the water in the cup (heat transfer is not only heat transfer, but also cold transfer, this phenomenon is called heat transfer). The air contains water vapor, and when the water vapor meets a cold cup, it liquefies when it is cold, and becomes small water droplets, which adhere to the wall of the cup.

It should be that the temperature difference between the inside and outside of the cup is too large, and the appearance of the cup is condensed with the moisture in the outside air.

The tap water we usually drink is filtered, and there must be certain substances in it. When the water on the wall of the cup dries up, there will naturally be a water agent.

Because the cup is hot, the air is cold, just like the lid of a stir-fry pot will have moisture on it.

If the cup is not cracked, there are traces of water because the temperature on the outside of the cup is quite different from the temperature on the inside.