What are the risks when the PE wire wiring is loose?

The risk of loose PE wire wiring is easy to cause safety accidents, so it is necessary to tie the PE wire tightly to check whether there are potential safety hazards and reduce unnecessary losses.

The risk of being misaligned by the first line or loose diagram is mainly the neutral point offset, which will cause high voltage and damage to equipment and electrical appliances.

According to the regulations of the factory and industry, it should be grounded. Grounding is often not for personal safety, but also for protecting the equipment from other sources of interference.

If the ground wire is loose and touches the case of the device, it may cause electric shock.

Hello, the risk of this situation is the safety of electricity to people.

Electric shock accidents may occur.

What are the main safety risk control measures for "loose parts"? 1.No less than 4 times a month, the catenary walks are inspected to check the loosening of the bolts of each component. 2.In the maintenance operation, the lock plate, locknut and red paint are installed to prevent loosening.

There is a risk when the PE wire is loose, and the wire is relatively empty, which is prone to fire. The second is that the signal is unstable.

Like this Pixian Jiasong, it is easy to have a risk of leakage, and there is a special danger in the case of leakage, so we must pay attention to the wiring method of this Pixian County.

When this line is loose, there is a risk that the machine will not operate properly and stop suddenly.

The risk of loose PE wire wiring is easy to cause safety search accidents, so it is necessary to tie the PE wire tightly to check whether there are potential safety hazards and reduce unnecessary losses. If the ground wire is loose and touches the shell of the device, it may create a leakage chain and become a deception.

1. Class of equipment refers to equipment that not only relies on basic insulation for protection against electric shock, but also includes an additional safety measure, that is, connecting the easily accessible conductive part to the protective (grounding) conductor in the fixed wiring of the equipment, so that the easily accessible conductive part will not become a live part when the basic insulation fails.

2. Therefore, the PE line is gone, and it is easy to be electrocuted.