The temperature of the machine is too high. Is this configuration of such a temperature normal?

The temperature of the motherboard is too high, 50 degrees is normal, everything else is normal, my core is only 50 degrees, hehe, good luck.

Abnormal·· Absolutely, it's your poor heat dissipation. It can't be that high. The temperature of the CPU and motherboard is high, the graphics card is slightly higher, and the rest is normal.

Suspect something is wrong with your motherboard. Two days ago, my motherboard was like this, the CPU temperature was too high, and I couldn't open it after a month, and I checked that the motherboard was broken, and it couldn't be repaired, so I had to return to the factory and replace it with a new one.

The heat dissipation of the main chassis is not good, either remove the side panel to blow, or install a small fan.

Spend 20 yuan to buy 2 silent case fans in the computer city, and the convection heat dissipation will be very powerful, and your motherboard temperature is very high! Usually the CPU and graphics card temperature is the highest.

It's okay, but your motherboard seems to be a bit on the high side.

It's almost, it's not too bad, and the normal temperature is about 30 degrees plus the indoor temperature.

It's almost best to install a case fan.

Why is the temperature of the motherboard so high?

The temperature of the machine should be below 20 °, that is, the temperature of the end cover of the motor exceeds the ambient temperature should be less than 20 °, the direct cause of the motor heating is caused by the large current of the judgment wheel in the hole, which may generally be caused by short circuit or open circuit of the coil, demagnetization of the magnet or low efficiency of the motor, etc., and the normal situation is that the motor runs with high current for a long time.

1. Under normal circumstances, the fan speed cleans up the dust accumulation of the radiator and the dust accumulation of the power supply, and part of the heat depends on the negative pressure of the chassis caused by the power supply fan to suck out of the chassis, and the cold air mainly enters the chassis from the side or directly in front of the chassis, so that the cold circulation system comes out, if there are debris on the side of the chassis, the temperature may rise slightly, and there is a possibility that the improper position of the fan or the wrong direction of the fan during the heat dissipation process of the modified chassis may suck the hot air flow into the chassis and cause poor heat dissipation.

2. Remove the processor and check whether the processor heat dissipation grease has no silicone grease or failure semi-failure caused by condensation, non-viscosity or natural volatilization, which can also cause the temperature to rise, you can replace the heat dissipation silicon, apply it evenly, and you can't see the true color of the processor's metal shell.

Three. Check the actual voltage of the processor and the external frequency, whether it exceeds the normal range, check whether the BIOS has changed, some people because the battery has no power, or the static electricity caused by disassembly and maintenance of the BIOS resets the default, and some motherboards will have BIOS and processor parameters do not match, which is also a reason for the high temperature of the processor.

Hope it works for you. Hope or ask. In order to save time, many people keep asking, and everyone keeps saying, so I copy it and use it to answer the heat dissipation problem. If you don't understand, you can ask, and I will answer the questions I know for you as soon as possible.

Mine too, I'll use an electric fan to blow it again.

It's good for fans to buy a better overclocking three.

I guess it's a fan to buy a CPU, so let's change to a professional fan.

If it is hot when not playing games or compressing and decompressing, you can consider changing the CPU fan.

It may be that the thermal stability of the memory is poor, and it can work normally when it is booted, but when the memory temperature rises to a certain temperature, it will not work normally, resulting in a crash or restart. Replace the memory Or: Due to poor heat dissipation of the chassis and CPU, the reasons for poor CPU heat dissipation are:

The material of the radiator has low thermal conductivity, there are foreign objects between the contact surface between the radiator and the CPU (mostly warranty post), the fan speed is low, and the fan and the radiator accumulate too much dust, etc. In addition, the temperature measurement probe under the CPU of the P2 P3 motherboard is damaged or the temperature measurement circuit inside the P4 CPU is damaged, the BIOS on the motherboard has a bug, the temperature measurement is inaccurate under a special condition, and the CPU protection temperature set in the CMOS is too low, etc., which will also cause a protective restart. First, for AMD CPUs, this temperature should not be too high.

Because I also use AMD, it often exceeds this temperature in the summer. And my motherboard is designed for AMD, and there is temperature protection for the CPU in the BIOS. Among them, or to set several temperatures such as 65, 70, 75, 80, 85, etc.

The minimum can only be set at 65 degrees. If you set it to 65 degrees, then the CPU temperature will automatically restart if it is higher than 65 degrees. Since the minimum is set at 65 degrees, it seems that your temperature is not too high, and my computer often exceeds this temperature, but it is fine until now.

Second, my optical drive is also very hot when reading discs. This is due to several reasons, one is that the optical drive is not very good. Mine is like this, because I don't have much money to buy a computer, and the boss said that other aspects of this optical drive are okay, but the temperature is high, but it can be used.

2. The disc is not good, which makes it very difficult for the disc to read the disc and makes the temperature very high. So, it is advisable not to use discs that are too poor quality. If the temperature of the optical drive is only hot, it is a normal phenomenon, if it is too hot, it is recommended to change the optical drive (the newly bought computer, it should be possible to change it for free).

3. The high temperature of the hard disk is also the same as the optical drive, and the quality is not very good. When we buy a computer, we tend to focus too much on performance and ignore its quality. However, 50 degrees is a bit higher in summer, but it is not too much.

I guess it's still a bit difficult to read the data. 4. Ghost time, slow. Or is it because of the difficulty of reading.

Same reason as above. 5. Power supply problem, it is recommended to change the power supply. It is estimated that the quality of welding and other aspects inside is not good.

The overall recommendation is to change the power supply first. That is, the power supply problem can be solved, and the problems in the first 4 aspects may also be caused by the power supply, if so, the problem is all solved. In other respects, it is normal and not a problem.

It's just that the temperature is slightly higher than normal, which belongs to the quality of the product, not bad. So it is not recommended to change. No, you can change the optical drive.