What is the problem with the Menak motherboard showing E13?

Fault description E01 Inverter unit protection E31 Abnormal DPRAM E02 Acceleration overcurrent E32 CPU abnormality E03 Deceleration overcurrent E33 Elevator speed abnormality E04 Constant speed overcurrent E34 Controller logic fault E05 Acceleration overvoltage E35 Shaft self-learning data abnormality E06 Deceleration overvoltage E36 Running contactor.

Fault E07 Constant Speed Overvoltage E37 Brake Detection Switch Fault E08 Control Power Failure E38 Encoder.

Signal Abnormality E09 Undervoltage Fault E39 Motor Overheating E10 System Overload E40 Elevator Operation Timeout E11 Motor Overload E41 Safety Loop Fault E12 Input Phase Loss E42 Door Lock Disconnection in Operation E13 Output Phase Loss E43 Upper Limit Disconnection in Operation E14 Module Overheating E44 Lower Limit Disconnection in Operation E15 E45 Simultaneous operation of the upper and lower strong change switches E16 E46 Releveling.

Abnormal E17 Encoder Signal Verification Abnormal E47 E18 Current Detection Fault E48 Door Opening Fault E19 Motor Tuning Fault E49 Door Closing Fault E20 Encoder Fault E50 Group Control Communication Fault E21 Synchronous Encoder Wiring Fault E51 CAN Communication Fault E22 Leveling Signal Fault E52 External Summoning Communication Fault E23 Short-circuit Fault to Ground E53 Door Lock Shorting Fault E24 E54 E25 Controller Data Abnormality E55 If the door opening of this layer is not in place, the layer is changed and stopped at E26 E56 Control board overspeed e27 e57 e28 e58 e29 star sealing contactor feedback abnormal e59 e30 elevator position abnormal e60

Jeddah Honda Elevator E13 Fault Answer: If it is a Menak elevator, the fault of E13**: E13:

Output side phase loss fault level: 4Fault cause: 1

The output wiring of the main circuit is loose; 2.motor damage; Fault solution 1Check the wiring; 2.

Check whether the output-side contactor is normal; 3.Troubleshoot the motor;

Failure Cause 1The output of the main circuit is grounded or short-circuited; 2.The connection of the traction machine is too long; 3.overheating of the working environment; 4.The internal wiring of the controller is loose.

Is the signal cable plug-in on the dashboard loose? Is the interface of the interface board loose? Is the dashboard broken? Check them one by one.