What should I do if the induction cooker of the UPG gas and electric stove is broken? A little induc

1 Explosion - burn fuse and IGBT.

The specific performance is that there is no response when the power is on, and the whole machine does not work. When we disassemble the machine, we will find that the insurance has exploded, and it has exploded so badly that the glass walls of the insurance have exploded black. If we check further, we will find that the IGBT under the large radiator is also broken, and sometimes the rectifier bridge is also burned, but the rectifier bridge is much stronger than the IGBT, and in general, only the IGBT is burned.

What to do if the induction cooker is broken.

What to do if the induction cooker is broken.

In this case, we should not rush to replace the parts and test the machine. Also check if there are any other bad parts. When I encounter this situation, I will measure all the resistance of the large resistance value in the circuit, as well as the two triodes (8050, 8550) that drive the IGBT, and then see if the 300V filter capacitor and resonant capacitor are bulging.

If that's all right, replace all the bad parts except the IGBT. At this time, the power test machine is used to test whether the B pole 0V of +5V, +15V or +18V and IGBT is normal. Only when these voltages are normal, can the IGBT be installed.

This eliminates most of the explosion faults.

What to do if the induction cooker is broken.

2 The whole machine is unresponsive, but there is no explosion.

Test machine, the whole machine does not work, disassemble the induction cooker, and find that the fuse is intact.

In this case, the power conversion chip of the induction cooker is burned out, it generally produces 18V voltage, and then becomes +5V voltage for the CPU to work through 7805, without +5V, the CPU does not work, and the whole machine does not work. This kind of chip in induction cooker generally uses VIPER12A, VIPER22A, THX203H, etc. Test the periphery of the power conversion chip to see if there are any damaged small devices, and if so, replace them.

3 Can turn on, but shows fault**.

This kind of fault should first clarify the meaning of **, and then repair it purposefully. There are many induction cooker failures on the Internet**, and we can make full use of them. This kind of fault is generally the resistance change value of those with large resistance value and large body, which can be measured one by one, and the variable value is replaced.

Also check the transformer, the 300V 5UF capacitor, the thermistor and the potentiometer that is the only one in the induction cooker. As long as these places are found, this kind of fault can generally be eliminated. A small number of cases may also be caused by damage to LM339, which can be verified by substitution.

4 The function is out of order, and some press the power button but it doesn't respond.

This kind of fault is best repaired, generally the key is broken, or the key board is dirty and leakage, changing the key or cleaning the key board can solve this kind of problem.

If this kind of induction cooker is broken, it is best to check the cause of the break, if it can be repaired, and the cost is very low, it can be repaired or can continue to be used, if there is a short circuit, or other phenomena that burn out the circuit board, do not repair it.

If the induction cooker is bad, replace it with a new one, and if you repair it now, its ** is also relatively high. You might as well buy a new one.

The induction cooker can be used for a long time, don't worry.

If the induction cooker of the Youmeng gas and electric stove is broken, it can be repaired or replaced directly with a new one.

Whether the induction cooker is old for 2-3 years mainly depends on the number of times you use it.

Yo, what should I do if my cute wife's electric stove and induction cooker are broken? If you use this for two or three years, it will be old, then you can change it to a **, or such a professional master will help you repair it!

What to do after the induction cooker is broken, a little induction cooker is very old after two or three years of use, and it may need to be repaired in that area.

Normal should be OK, the refrigerator and air conditioner are automatically shut down to the temperature, and the power of the induction cooker is 2000W. However, the current of the air conditioner or refrigerator will reach the maximum at the moment of starting, and there is a danger of overload tripping, which may also cause damage to the electrical appliances.

1. If it is a pure copper wire, it is possible. 4 square copper wire, the current that can pass is more than 20A, the total power of the air conditioner and induction cooker is about 3000W, that is to say, the working current is about 13A, so it is possible, 2, if it is an aluminum wire, it is not.

Because: rice cooker 700w + air conditioner 2500w + induction cooker 2000w = 5200w, again: voltage 220 volts.

While: p (power) = u voltage * i current.

5200W 220V = 24A current.

The plug-in board generally bears 10A current, 24A is greater than 10A, if it is opened at the same time, the line is overloaded, resulting in a short circuit!

So you can't open it at the same time! Thank you for your understanding!

In order to solve this problem, I took the physics books I learned more than ten years ago and turned them over! And you should learn from the past! Ha ha!

It is not possible to use the air conditioner at the same time to pull a wire to make a separate outlet! When the induction cooker and air conditioner are used at the same time, the power is more than 5,000 watts! The general power strip can't be worn at all, and it is easy to heat up.

In this way, depending on the size of your home's power cord, including the wiring in your wall, it is generally calculated according to 1 square meter and 4 currents, and the air conditioner is more than 1100 watts, about 5 currents, depending on the power of your induction cooker.

When affected, the current is generally larger when the air conditioner starts, and generally as long as the diameter of the power cord in your home is enough, the others are not a problem; Generally, the air conditioning socket is 16A, if it is a national standard socket, it is best as long as the voltage is stable, the voltage drop between 198 and 244V (the instantaneous voltage value when the air conditioner starts), the wire diameter is enough, and it is no problem to use it together.

Electric water heater, direct heating type 10 kW, at least 40 currents or more.

Induction cooker is generally about 3000W, and air conditioner is generally about 1500W (horsepower), and induction cooker consumes more electricity than air conditioner.

How many p-air conditioners? How much power is an induction cooker?

The crux of the problem is that the air conditioner and the induction cooker take a long time, I use the induction cooker to fry and stew for more than 20 minutes, stir-fry for more than ten minutes, and turn on 1300 watts for stir-frying, and the air conditioner I come back at noon for two hours, and come back at night to open overnight.

It depends on how many watts the power of the induction cooker is.

For example, the power of the commonly used induction cooker is 2100 watts, and the power consumption for one hour when the maximum power is used is the degree, and if it is used at low power, the power consumption will be less.

The heating input power of an air conditioner is generally between 650-850 watts, and the power of auxiliary power is generally between 600-1000 watts, which can be roughly calculated according to one kilowatt-hour and one kilowatt-hour. Because the amount of electricity consumption is not only related to the amount of power, but also has a lot to do with the size of the room and the quality of sealing and thermal insulation conditions, the temperature of the outdoor environment and the level of indoor temperature regulation. Usually, when the air conditioner is heating work, the average hourly power consumption is generally between degrees.

It depends on whether the air conditioner and induction cooker will be used at the same time.

If the induction cooker and the air conditioner are not turned on at the same time, the 4 square national standard line is enough, if it is often turned on at the same time, it is recommended to use the power supply line with 6 square meters or more of the national standard line to avoid safety problems.

Yes, but the socket wire needs to be large enough, and the power of the induction cooker is about 2000w, so the wire connected to the socket is at least above the square to be safe.

1P air conditioner is generally 1000-1200 watts, even if it works non-stop for an hour, it will be electric, and the induction cooker can reach up to 2100 watts, which is kilowatt-hour electricity. As for who consumes a lot of electricity, it depends on how you use it.

The input power of 2P air conditioner is 1470W, and the power of the general induction cooker is about 1800 2100W.

Of course, it is an air conditioner, and it should be 2p, and the power of the air conditioner should be at least about 3500.

The maximum power of the induction cooker is only 2000

Yes, the electricity consumption of air conditioning heating and cooling is also different, and the electricity consumption will be larger when heating, and some air conditioners also have electric heating, so it will be more powerful than induction cooker! When refrigerating, the temperature is adjusted to about 24 degrees, which is the most energy-saving, and the use of inverter air conditioning will also save some electricity.

It's okay, I'm an electrician, I'll explain that when the air conditioner is first started, it runs at maximum power, and when it reaches the set temperature, it will automatically adjust to the minimum power to operate, which is about the same power as a desktop fan, and at this time, you can guarantee that there is no problem with an induction cooker.

There is also the fact that the meter can withstand a lot of power The key is that the leakage protection switch does not know if it is high-power If it is not, it is tripped at most, and you can continue to use it if you push it up, and it has no effect on the wire meter.

If you can use an induction cooker, you can use a 1P air conditioner.