How does the German CHIRON machining center run DNC?

It's been a long time since I opened Frank, remember that the approximate steps should be in DNC mode--- select the device--- select the memory card--- update the program ---, at this time there will be Arabic numerals in front of each program, select the number in front of the program, press DNC directly, start, and that's it.

The machining center has a help button that describes the DNC operation steps.

The old man pinched his fingers and counted your surname Gao.

The NC setting processed using the memory card DNC is only set to 4 for the IO channel, and the parameter 138 7 is set to 1

Then select the program number, DNC setting;

You already have the d logo on the left side of the picture, so press the program start button to show that the program has started to run on the program screen, if it has not succeeded at this point. Then you need to take a look at the parameters 0022 and 0023, change it to 4, and try the settings of the background output device of the memory card. When the machine is measured, when the 0023 parameter is changed to 4, it can be processed by CF card DNC.

Select DNC for mode, not auto mode, and select the program number.

Can't you start it directly? Try again after importing your computer.

Dial to DNC mode, press the program to start and you're done.

Either way! But I'm more optimistic about CNC machines. Because:

First, the demand of CNC talent market.

In developed countries, CNC machine tools have been widely used in large quantities. There is a big gap between China's manufacturing industry and the international advanced industrial countries, and the numerical control rate of machine tools is less than 2 for the limited number of CNC machine tools (most of which are imported products) in China at present, and they have not been fully utilized. There are many reasons, and the lack of CNC talents is undoubtedly the main reason.

First, because numerical control technology is the most typical, the most widely used mechatro-optical integration integrated technology, China urgently needs a large number of technical personnel at all levels from research and development to use and maintenance.

The demand for CNC talents is mainly concentrated in the following enterprises and regions:

1. Large and medium-sized state-owned enterprises, especially the current economic efficiency!

DNC (Distributed Numerical Control) is called distributed numerical control, which is the link to realize the integration of CAD CAM and computer-aided production management system, and is another form of machining automation.

Networked processing, connected to computer processing).

If the inside of your bed is sufficient, you can read the program directly from the memory card or computer in DNC mode.

It's the same as other systems.,The program is sent in.,Just start it in DNC mode.,If there's no DNC on the panel, open the connection.。

1 First, set the i 0 channel to 4 (i.e., parameter 20), parameter 138 7=1.

2 Copy the processing program to a memory card (you can copy multiple programs at once).

3 Select the [RMT] mode (i.e., DNC mode), on the program screen, press the right software key [ ] to find [card], and the file list in the memory card will be displayed.

Select the sequence number of the program to be machined, press [dnc-cd], and then press [dnc-st] (if [dnc-cd] cannot be found, how many presses.)

The secondary software key [ ] until the software is found).

4 Press the cycle start button on the machine's control panel to perform DNC machining.