WHEN RESTORING THE SYSTEM, A GHOSTERR TXT IS PROMPTED, AND IT CANNOT BE RECOVERED

This is because you used a higher version of the ghost disk when you backed up, and you probably used a lower version of ghost when you restored, so I don't recognize it. Try restoring it from the same disk you backed up from the beginning, and it should be fine. Version issues.

I recommend that you use the same disc for the ghost system in the future. Or use a version of the lower point to do it, so that any kind of ghost can be restored in the future.

Prepare more versions of the ghost disk,What lite、Enterprise version,And Lin Mufeng,Pigs and cats,If it doesn't work,Just disassemble the machine,It is estimated that the memory has been increased,Unplug one in the system,Plug it back when it's done,If it doesn't work,Replace the optical drive with the optical drive you installed on the system,Replace it with the optical drive you installed in the system,Replace it back after installation。

The same machine sometimes uses a G disk to install 2 times, there is a situation you said, you try to change the disk first, you disassemble the machine and replace the optical drive, which is installed on the system, just use the optical drive of which machine.

Don't say anything, I'll be exhausted after reading your instructions.

Your CD-ROM disk reading ability is not good, basically has nothing to do with the disk!!

It may be that the optical drive is broken, and a file can't be read, you can use a good system to make a backup, and then save it with a U disk, and set it as the first startup item with this U disk, set it in CMOS, and guide the reply, but it really can't be added.

Optical drives, hard disks, and memory are all possible, try it yourself.

90% of the problems are problems with the optical drive, and 10% are problems with the ghost version.

1. The ghost disc is not burned well;

2. The ghost version is too low: For example, if you use it when backing up the ghost image, and you are using it to restore the image file, then the above problems will occur;

3. There is a problem with the disk, such as a partition error;

4. The partition capacity of the C drive is small (many people ignore this problem).

To solve the above problems, we recommend that you take the following steps to try to solve them:

1. Use ghost to check the image file or disk to see if there is a problem, as shown in the following figure (if you want to use a professional tool to detect, you can use the efficiency source hard disk detection and repair tool).

Usage] Select local check image file to check whether the ghost (gho) image file is correct. Or select local check disk to check if there is a problem with the disk.

Ghost 2: Use PQ (PQMAGIC) to check whether there is a problem with the partition.

attachment=8451]

3. Use PQMAGIC to adjust the capacity of the C drive, and the adjusted capacity should be greater than 10G.

4. If none of the above methods work, try to re-burn the disc. (It is recommended to use clonecd burning, the integrity of the software burning is quite good, and you can burn encrypted discs).

You are prompted to enter the PE system and then run ghost to manually clone.

This is just two problems: 1, CD 2, CD drive.

Your disc or optical drive is broken.

Change the disc first, and if it doesn't work, the disc will break.

This problem often occurs when making a system, which means that this system disk is not good, and it is recommended to try a different system disk.

Try changing the memory, I have encountered this kind of problem, after changing the memory, ghost succeeds.