After my computer is set up with a router, only my computer can t connect

First of all, make sure that your Internet access method is PPPoe, and whether you use the dial-up software that is specially used by Yu Yu! In some places, the network is commonly used in the DHCP+ method, which requires the use of special dial-up software, which requires the purchase of a dedicated Netcom router.

There is also a situation where the PPPoE dialing rules are modified, and the username can only be accessed after the conversion of the dedicated dialing software, you can ** a username conversion program, calculate the real username, and then add it to the router, without a dedicated router. To determine if the username has been converted, you can create a PPPOE dial-up link yourself, fill in the username and password, if it prompts the username and password is wrong, it is the conversion town has done.

There is also a situation where the other party binds your MAC address, modifies the MAC address in the router to be the same as the host, and then modifies the MAC address of your own host, which is different.

You can also call the other party, say I changed the network card, and then report the MAC address of the router to him, at this time, keep using the router connection, don't change back to the computer, so as not to find out the **mac

ps:I've been against Netcom for many years.,It used to be dhcp+.,I ** a crack client that can be shared.,Later, it was changed to pppoe to convert user names.,The manually established link honestly prompts the wrong username.,I went online to find a username conversion program.,Netcom is so treacherous!

DNS doesn't matter, it's good to be automatic, if you have to set it, Yundong can be set to the IP of the router, foolproof!

Let me ask you a word first! Have you ever used Netcom's dedicated client! That's what Netcom My World!!

After resetting the router, you need to set the relevant parameters again to use the network normally.

Please refer to the following method to set up the router.

1.Plug the broadband modem or home network cable into the WLAN port of the router, and then connect to the computer through the network cable or wireless network.

3.After entering the page, the stove cavity will be prompted to enter management, which also needs to be found in the manual, and the general password is admin.

4.Click the Setup Wizard, follow the prompts on the page to set up broadband without PPPOE dialing, and enter the broadband password.

5.According to the prompts on the page, check the box to turn on the WiFi network, and set the password, when finished, click Next, and the device will automatically restart.

The router is set up, and the computer needs to be set up as well. Even the gateway of the computer to access the Internet should also be within the range set by the router.