Local connection problems, can t get on the Internet. Urgent! 50

If the local connection is restricted, you can disable it first and try it.

Your local connection is incorrect.

AhhIf you can't get it automatically! Disable it in Enable Try if it still doesn't work!

Manually configured, are you sure that your IP is in the same network segment as the IP of the internal interface of the router? Whether the IP of the gateway, that is, the internal interface of the router, is set correctly! If that's right!

Enter cmd is to ping the default internal interface IP of the router here ping the internal interface IP of your router), if you can get through, you should be able to surf the Internet!

Ping the gateway to see if it can be pinged. It is estimated that in addition to the C disk (system disk), there are viruses in other disks of your computer. It is recommended that you kill the entire disk or simply redo the entire hard disk and then redo the system, (if you don't have a lot of hard disk data, you can take it)!

It must be that there is a virus in your USB flash drive or mobile hard drive, and of course there are many viruses.

See if you like to use something.,1Reinstall the system only reinstall the system folder All the files in the d,e,f haven't been changed.,Maybe it's a latent virus potential review.,Try it with a 360 first aid kit and add q:939372534

1.A computer can access the Internet, which means that the router is working normally, and the port problem is not ruled out, it is recommended to change the port to try.

2.If the problem persists after the port is replaced, it is recommended to open the start-run-cmd-ipconfig release of the notebook desktop after the release is over, re-enter ipconfig renew and then ipconfig has a default gateway = ip under the local connection (e.g. and then use the ping command (e.g. ping if passed. If ping or reply from **bytes=32 time=127ms ttl=55, you are ready to surf the Internet!

3.If you can't, it is recommended to remake the crystal head of the network cable!

If you have any questions, please feel free to send me a message!

You go into the router to see the settings.,Enter the password in IE if you haven't changed it, it's generally admin and the username is admin.

You go in and see if DHCP is working, and by the way, look at the ** of the traffic and so on.

It's not going to work.,Restart the router.。。 Or reset is factory settings, and configuring the router is very simple.

Turn off the router and modem, plug the line back in, don't change the cable, restart the router and modem and connect to the network again.

If you plug the cable into the laptop on the desktop and there is no problem, then it may be that your router interface is not connected correctly or is broken.

It's also possible that the line is broken.