4 people share a router, how to form a local area network

First, to ensure that the connected network cable is unblocked, 8 lines in the 1236 four wires on the line, if you are not clear about the order, pull out the RJ45 crystal head, see the end of the copper sheet, from left to right number 1 2 3 6 these four lines, remember which colors, it is best to have a line tester to test whether the line is unblocked.

3. The guest user of each machine is enabled every day, and do not set a password.

First of all, the first one: right-click on my computer -- Properties -- Computer name -- Change -- Change the name of the workgroup to mshome -- Change the name of the computer (the name of each computer should be different, but the workgroup should be the same).

Once everything is set up. Share it to see.

It depends on what brand of route you use, but the settings are basically the same.

Routers share the Internet with routers, which implements the sharing function. Specifically, it should be done step by step according to the instructions on the router (the routing functions and settings of different brands and models are not the same), after setting, you should be plugged into the network cable to access the Internet, and the PC on the network does not need any settings.

Sharing a router has already built a local area network, the default is a workgroup, you can click on the network to view the computer in the workgroup to see other machines.

Turn on the Control Panel-User-Guest, and you can access each other.

You run a small home or office network on each machine.

Based on the first three digits of the router IP, you can set the IP addresses of your four machines.

Example: The IP address of the router is:

The four machines are set to:

The last digit is any integer that is not 0 or 1.

That's the problem with your system. Generally, broadband router ports are connected. Directly connected.

Is there a working group set up the same?

The specific steps are as follows:

1. First of all, select "Set up wireless temporary network" in the setting connection or network, as shown in the figure below, and then go to the next step.

<>3. Then, after completing the above steps, in the pop-up window, name the LAN and set the password, as shown in the figure below, and then enter the next step.

4. Then, after setting up, wait patiently for a while, as shown in the figure below, and then move on to the next step.

5. Finally, after completing the above steps, the prompt "LAN is already available" appears, which means that the LAN has been successfully established, as shown in the following figure. In this way, the problem is solved.

The connection method of multiple routers has learned how to accelerate networking, so that the whole family can have full signal coverage.