The Glash tte watch has an abnormal sound, what is the reason for the abnormal noise of the Glash tt

The following is an introduction to the five common reasons for the inaccuracy of the watch time

1: Insufficient power reserve: You need to check whether the power is sufficient, if the amount of exercise is small, the power reserve may be insufficient, you can supplement the power by manual winding, and then observe whether it continues to have the phenomenon of fast and slow.

2: Insufficient power: If the quartz watch suddenly finds that it is slowing, it is likely to be caused by insufficient battery energy, and you can send the watch to a special maintenance point to check the power.

3: The watch has been hit or impacted: the watch is very tight, if it is hit or hit, it may cause loose damage to the internal parts, and it may also cause the problem of running time. This is to be dealt with in a timely manner.

4: Need maintenance: The lack of oil in the movement or the wear and aging of the internal parts may cause the problem of running time, which needs to be maintained, and needs to be sent to the designated maintenance point for maintenance services.

5: In addition to the above common situations, some ambient temperatures affect the watch by magnetism: if the balance spring of the watch is magnetized, the watch will not be accurate.

The working principle of a mechanical watch is:

The pendulum in the mechanical watch, through the back and forth movement of the human arm, drives him to rotate the winding to produce elastic deformation, and then the mechanical setting controls the amount of recovery of its elastic deformation, that is, the movement of the second hand. The interlocking of the gears forms the relative position of the hour, minute and second hands, and the time can be displayed.

There are many parts inside the watch, gears, springs, screws, and shafts.

If you feel an abnormal noise, or the watch has stopped, it is likely that the parts are loose or have fallen.

Maintenance Method:

1. Wearing a watch, hand sweat is corrosive to the band, steel case, because it is nickel-chromium alloy, corrosion resistance, semi-steel copper case, and sweat, easy to corrode long-term contact, should often use a professional watch to clean the machine watch or pad the plastic watch to prevent it from being eroded by sweat.

2. Do not open the back of the watch at will, so as not to sound the dust movement of the normal operation of the watch.

3. Don't put your watch in the closet, mothballs will spoil the watch oil.

4. Do not put the watch on the amplifier, stereo, TV, so as not to magnetize.

5. If you store a mechanical watch that you don't wear for a long time, you should exercise regularly for a short period of time every month, and the automatic movement watch should gently swing back and forth on your wrist for a few minutes or a period of time. Therefore, this part will not be stationary for a long time to guarantee the normal operation of the performance of the watch.

The winding is light, and the winding is not enough, so it is obvious that the mainspring is broken. The upper chord makes an unusual snapping sound, which may be due to a worn tooth.

Loose parts, parts falling off, parts breaking, lack of oil slippage, etc., the specific cause is better to detect.

The winding is light, and the winding is not enough, so it is obvious that the mainspring is broken. The upper chord makes an unusual snapping sound, which may be due to a worn tooth.

If there is an abnormal noise in the watch, it is mostly caused by the internal gear of the watch not fitting well.

It is estimated that it has not been maintained for a long time, and the gears inside are slippery and the parts are loose, so it is good to take it to wash the oil and maintain it.

When you can't continue to turn the handlebar, it means that the mainspring is completely full and the upper mechanism is working normally. If there is an abnormal sound of chirping or slipping of the top teeth when turning the shank head, it means that the upper bar mechanism is faulty.