-
Anonymous users2024-02-071. Back up and collect data, use Huawei backup and other software.
2. Restore the factory settings once to reduce the error rate after flashing.
4. Unzip the ROM package, get a dload folder, and save the folder to the SD card.
5. Open the mobile phone [Settings] - [System Upgrade] - [Local Upgrade], it will automatically flash into the ROM package and return to the original system.
-
Anonymous users2024-02-06If your Huawei Honor phone has entered the flashing page, you can try the following steps to restore your phone:
Try restarting your phone. Sometimes all it takes is a simple reboot of the phone to fix the problem.
Try to enter recovery mode using the hardware key. This will allow you to enter the recovery menu on your phone, where you can perform the relevant operations.
Try to use the phone assistant software for recovery. This method usually requires the use of mobile phone assistant software on the computer to connect the phone and then perform the recovery operation.
Hopefully, these suggestions will help you solve your problem.
-
Anonymous users2024-02-05Root is not recommended.
1. After rooting, it may not be able to reach the best working state, and some software and hardware functions may not work normally. At the same time, because the third-party firmware is not fully tested, there may be compatibility problems, and the system security cannot be guaranteed, which is susceptible to virus invasion and may be implanted with some malicious programs, resulting in loss of personal information or property damage.
2. Root may also bring unforeseen negative effects, please operate with caution.
2. You can check the address entrance of after-sales outlets at the bottom of the page of Huawei** official website;
-
Anonymous users2024-02-04It is definitely not possible to restore the original system, and the original system has been cleared when flashing, so it's not that simple.
1. Mobile phone flashing and factory reset are both to clean up the mobile phone data and erase all the mobile phone data.
2. Mobile phone flashing refers to the installation of a new system, just like the computer reinstallation system, Yuanzhou can brush a variety of systems suitable for mobile phones.
-
Anonymous users2024-02-031: Prepare an SD card with a capacity of 4G or more, it is recommended to use Sandisk, Kingstone, or KingMax.
2: Use a computer to format the SD card (it is recommended not to choose quick formatting, format it according to the normal program, you can skip it).
4: Make sure that there are files in the dload directory, and then copy the entire dload to the root directory of the SD card. (Note: It must be the root directory, otherwise it cannot be flashed).
5: When the phone is turned off, insert the SD card, press and hold the volume up button + volume down button + power on button at the same time, and the volume up and down buttons continue to press for more than 10 seconds, at this time the phone will enter the SD card upgrade process, and then start the upgrade.
6: When "OK" appears on the screen"When the words are written, it means that the upgrade phase is over, and after completion, restart and wait for a while!
You can see if you can enter the configuration interface of the router, go in to see if the router has uplink and downlink packet traffic, no traffic or very little traffic, this means that the router is not connected to the external network, you just establish a LAN relationship with the router.
From the point of view of encryption effect, I recommend LBE, because LBE has encrypted ****, you can't view it through the mobile phone album, and many other encryption software, after encrypting **or**, you need a password to view it from the file management, but you can still view it from the mobile phone's own album.
Hello, Skywhisper Bumblebee Courage Edition v9 Main Hardware: >>>More
If your phone freezes, you can do it by following these steps: >>>More
After the bracelet is turned on, Bluetooth is in a pairable state by default. >>>More