Problems with the Roller Skating Flying Eagle SKT300 Enhanced

I've got to be like you, and that's been the case before. But it doesn't matter, adjust the position of your tongue, and you'll be fine after a long time. It won't hurt forever. Shoes are not entirely suitable at first. After a long time, you will get used to your foot shape, hehe, don't worry.

The common problem of hard-shell shoes is that people with high insteps will press very painfully, it is recommended to cut off the edge of the hard-shell, and then use fire to soften and break it up - my fr1 has used this method, I don't know if the eagle's can As far as I know, the common problem of SKT100 is to press the instep, and it will generally be better for a while.

When you wear shoes, pay attention to adjust the position of the tongue to the most comfortable position, and remember to wear long socks, which will be much better; This is what I was told by the ** store where I bought roller skating.

The difference between the basic brake and the general shelf is nothing more than the difference between the shape and the material, and the hardness of the material is about 5500-6000. If you buy it alone, this shelf will cost about seventy or eighty yuan.

In addition, I would like to give you some knowledge of knife holders:

H: The so-called flat frame, the old Michael version of Seba-H, black gold and red gold, FRM and shoes GTX are all this, the European version of Migao has more such shelves, the shelf shape is like X or like an H, the hardness is moderate, it is a little heavier than the V frame, and the flat brakes are all-in.

V: That is, the V frame, which was used for the high-end KSJ, and later after the SEBA-H upgrade (in fact, the tool holder has changed) is called SEBA-HV, the tool holder is lighter than the HV, and the strength is also higher, some people say that the center of gravity is low, but the personal feeling is not much different; Some say that the height of the nail hole is different, and the same big wheel has a banana effect, which is purely misleading, and the H frame is the same, the nail hole is flat.

Commonly found in PS EVO knife holder, fine workmanship, and high material density, light knife holder, banana configuration, with the same large wheel with banana effect, flat flower is preferred, but **expensive. And the length is a little shorter, which is more flexible.

There is also a common one that is folded, which was first on RB, and later was copied by the majority of the people, and the effect is similar to that of H frame (SKT's actually belongs to this).

Another kind of flat flower is the M frame, which is commonly found in Westwood's shoes, a bit like a V frame, with two kinds of flat holes and banana holes, with high strength, more flexible short frames, ** is also moderate, and the appearance is also good.

Generally speaking, the flat frame of 243 can be equipped with 4*80, and the knife holder of different specifications is different, some are 233 with 4*76, and 219 with 4*72.

Flying Eagle SKT300 flat flower brakes can easily cope with it.