Why can t I connect to broadband after broadband becomes wifi

Connect the computer network card with the LAN port of the router with a network cable and turn on the power of the router; Double-click the IE browser on the computer, enter the IP address of the router default settings page in the address bar, and press Enter; Enter the default username: admin, and the default password:

admin；Click OK. Click Setup Wizard in the left rail, click Next; Click on ADSL Virtual Dialing (PPPoE) and click Next; Enter the broadband, password, and click Next; Click Done. Many friends think that the dial-up connection is over after setting up, but in fact, there is still one point that is not completed.

Because the following settings are not completed, many friends encounter 691 errors in dialing, or can connect to the network, but it will be dropped after a short time. Let's continue with the setup: Click the MAC address clone menu in the network parameters menu on the left sidebar, click Clone MAC address in the interface that appears, and click Save.

At this point, the router will prompt you to restart the router, click OK to restart the router. After the router restarts, close the Internet Explorer. Connect the WAN port of the router with an incoming network cable, and then connect the computer to the LAN port of the router with a network cable to start surfing the Internet. Note" Some users have multiple computers at home, but don't know the MAC address of that computer to clone.

You only need to directly connect the cat (or home network cable) to the computer with a network cable, and then dial on the computer, which computer can dial up the Internet, and clone the MAC address of which computer. These processes are done and absolutely ready to use.

Your router isn't set up.

Hello, wifi signal regardless of whether there is a network mobile phone and other devices can be connected, the user can not use the network after connecting to wifi, first confirm whether the broadband line of your bench is smooth, you can check whether the indicator light of the broadband cat has LOS red light flashing, if there is a broadband failure, so the router's wifi can not use the network, at this time, the user can call the operator's customer service to report the fault, and there will be staff to come to the door to troubleshoot the fault after the fault report.

If the broadband modem can be connected to the network normally, then it is a problem with the router, and you can check whether the network cable is connected correctly. If the network cable between the broadband modem and the router is normal, then the user can restore the router to its factory value, and then reset the router parameters to see if the router can be restored to normal

2. Then open the browser and enter the management address and login password of the router.

3. After logging in to the background, click the setup wizard, and then fill in the corresponding parameters according to the wizard instructions.

<>6. After the wireless setting is completed, click Save, and then restart the router to use it normally.