If you don t have water pressure, you can use a fully automatic washing machine, and does a fully au

The automatic control of the washing machine is independent of the inlet water pressure, so it is completely usable. It is because of the long time to release the water, so the whole laundry process will be longer.

The main function of the automatic washing machine water level switch is to control the water level of the washing machine.

Under normal circumstances, the water level switch of a microcomputer automatic washing machine has only 2 inserts. When not subjected to water pressure, the contacts of the two tabs are disconnected. After selecting the washing program and selecting the water level, the washing machine begins to work, advanced water, when the water level reaches a certain height, the air pressure in the air chamber of the bucket reaches a certain value, and the air pressure is transmitted to the rubber sealing ring of the water level switch through the air duct, and the force of the spring and torsion spring of the water level switch is overcome to promote the action of the rubber sealing ring, so that the two insert contacts are connected, so that a signal is given to the microcomputer, indicating that the selected water level has been reached.

The same selection of dehydration program, after the washing machine drainage, when the water level recedes to a certain height, due to the action of the spring, the rubber sealing ring of the water level switch is restored, and the two contacts are disconnected, giving the microcomputer an action signal, after a period of drainage, the microcomputer controls the motor to run and begins to dehydrate.

So your method is feasible, the height distance is not very important, the important thing is that the amount of water entering the water meets the requirements of the automatic washing machine. If the bucket is not big enough, you have to fill it with water.

You can use a fully automatic washing machine, and if the water pressure is particularly low, you can use a small booster pump at home, which is powered by 220V voltage, which can save time.

Yes, as long as there is water flowing out of the pipes.

As long as the water level is high enough, the water can flow into the washing machine and you can use it.

Not all washing machines don't need water pressure, Siemens does.

<> automatic washing machine has requirements for water pressure, and the general washing machine will mark that the water pressure requirement is greater than that. If the inlet pressure of tap water is too small, the water flow will be relatively slow, and the water level and water volume time will become longer when the water level switch is set for washing.

Do not open the lid when the washing machine is spinning or when the spinning bucket does not completely stop spinning to avoid danger. At the end of use, the power plug must be unplugged to avoid leaving the washing machine in standby mode for a long time and causing heat.

Forming a hidden danger of failure.

When there is no running water, the automatic washing machine can only be used by pouring water into the bucket.

As soon as the water level is reached, the washing machine works, but this becomes a "semi-automatic washing machine."

Finish. However, this method is only suitable for washing machines.

Front-loading washing machines are not a no-no.

Drum washing machine.

Originated in Europe, the laundry method is designed to imitate the principle of a stick hammer hitting clothes. The drum washing machine is made of a stainless steel inner barrel, a mechanical program controller, a triple protected shell by phosphating, electrophoresis, and spraying, and a number of bulky cement blocks to balance the huge centrifugal force generated when the drum rotates.

Do repetitive exercises and add laundry detergent.

and water work together to make the clothes clean.

Hello, the solution is as followsNormally, without running water, the fully automatic washing machine is not usable. However, if it is a wheelie washing machine and there is water stored at home, it can be washed manually by pouring an appropriate amount of water into the washing cylinder, as long as the water level is reached, the washing machine will start, but water must be added every time you wash it.

The reasons why a fully automatic washing machine does not drain are as follows:1. Mechanical failure causes the washing machine to not drain, usually the failure can be divided into two situations, they are the drain valve and the drain solenoid, these parts are loose, or the drain valve core of the tension spring is broken.

2. The brake is not released, and the motor cannot be started due to too much load, and the buzzing sound can be heard at this time, and the drain pull rod can be adjusted. Some models should check whether the tractor cable is loose from the drain valve; If the nut is not loose or the cable is not loose, the retractor may be damaged and cannot open the drain spool, at which point the retractor should be replaced.

3. If there is debris blocking in the drain valve, open the back cover of the washing machine, make the washing machine enter the dehydration program, and observe whether the drain valve is pulled apart by the tractor, if not, it may be a computer board failure or a tractor failure; If you observe that the drain valve core is pulled open, but does not drain, it is a blockage of the drain pipe, and in most cases, the drain valve inlet is blocked, and the debris can be removed to eliminate the fault.

How can I use a fully automatic washing machine without running water? Hello dear, Yu Tsai to follow the following content: washing, put in the clothes, open the washing machine door, then press run, and then start adding water, when the water level, automatically start washing.

When there is no running water, the automatic washing machine can only be used by pouring water into the bucket.

As soon as the water level is reached, the washing machine works, but this becomes a "semi-automatic washing machine". However, this method is only suitable for washing machines with wheels, not for drum washing machines.

The drum washing machine originated in Europe, and the washing method is designed to imitate the principle of beating clothes with a stick hammer. The drum washing machine is made of stainless steel inner barrel, mechanical program controller, phosphating, electrophoresis, spraying triple protection of the shell, and a number of bulky cement blocks to balance the huge centrifugal force generated when the drum rotates to do repetitive motion, plus the joint action of washing powder and water to make the clothes clean.

If you want to synchronize, you can design a circuit yourself and use the electrical signal of the solenoid valve to drive the pumping motor. But I guess you...

There is a kind of water supply equipment used in rural areas that do not need to build water towers, as long as there is a well that can be pumped with a motor, about one meter 5 high, about one meter in diameter, and can be put on the ground at will, 500 yuan can be done, there are pressure equipment and water shortage automatic start switch, etc., about the pressure start, close, the water pressure is quite large,

Install an automatic water pump without a water tower, and you can drain the tap water pipes at home, so that all the places that need water can be used more, just like tap water.

It seems like there's no better way to do that than by building a water tower and putting a tank on top of it.