The broadband connection is always disconnected What s going on

One is that the distance of your line is long, the second is that your line has connectors, the third is that your line is aging, the fourth is that the computer has a virus, and the fifth is that the ASDL equipment has a problem, etc.

Cause: There is a procedural error in the computer system, which causes the broadband connection to be abnormal, it is recommended to restore the computer to an earlier normal stage to solve the problem.

Workaround: <>

2.Then select Recover System Settings and Computer in the next interface. If your computer doesn't have the restore feature turned on, you may need to turn it on;

3.Then open System Restore, that is, click the button shown in the figure, if there is an account control, there will be a prompt, pass;

4.Then the wizard that restores the files and settings will begin, all you need to do is follow the wizard's prompts. Click Next directly;

5.Then, in the System Restore Point option, select a restore point, make sure that the selected restore point is the restore point when the system was normal before, because if it is an abnormal restore point, there will be problems;

6.After you make sure that it has no errors, click the Finish button to start the system restoration, and then the system will restart, and then enter the relevant restore operation during the boot process, and the broadband will run normally.

1. It may be caused by DNS error, the solution is to select the "DNS Preferred" tool in the toolbox of Tencent PC Manager, click "Detect Now", after the detection, you can see the average value of DNS, the lower the average value means the faster the DNS response, select the "Enable" with the smallest average value.

2. If the distance from the router is too far away or the wall is too much, the signal strength is low, and the small fluctuation occurs, which will lead to instantaneous disconnection and reconnection (generally difficult to detect). You can see the speed and strength of the connection status, if it is very low, it may lead to the inability to access the Internet, please adjust the distance or placement of the machine and the router, of course, you can also equip a high-gain directional antenna to amplify the signal.

3. The roadfinder has set security measures such as IP address restriction or MAC address binding, please check whether the router has set IP address restriction or MAC address binding.

4. Reconfigure your wireless router.

5. If there is no problem with the above settings, then you need to reinstall the wireless network card driver.

6. If it is still invalid, it is recommended to back up important data and reinstall the operating system. Blind nucleus.