How to route TEL402 to set up a fixed IP address for two computers to access the Internet?

Bind the IP address and MAC address of each machine in the router, so that the machine cannot access the Internet except for this IP address.

Your Internet IP is not fixed, it has nothing to do with your routing, and it is not something you can set.

See what your network operator is.

Like this number, just change the last 1 to it, change it to.

Inside a LAN it's not the same.

Outside the LAN not necessarily.

If it is ppoe dial-up Internet consistent.

NAT mode, it can be the same or not.

It's not the same, and the same words will prompt conflicts.

Not the same, if one of the computers has an IP, the other is a difference of 1.

The interior is not the same, between.

It's the same outside of the LAN and is your current network address.

If I understand what you mean, do you want to use a unit of inner **, with one connected to the computer, and the other connected to the mobile phone wireless?

If so, I can tell you a method I use, you can give it a try.

Spare parts: one wireless router and two to three network cables.

1. Connect the router to your computer and configure the router.

Select the Jingtai IP address for the WAN port, configure the WAN address of the router to be the same network segment as the company's intranet, and enable the Internet access permission of the IP address just assigned in the company's main route).

The order of the first and second steps cannot be wrong).

3. Plug the company's intranet cable into the LAN port of the wireless router you prepared, pay attention! It's not plugged in the wan port!

4. Use a short network cable to connect the LAN port and WAN port of the router.

5. Use another network cable to connect to the desktop computer from the other LAN port of the router.

6. Mobile phones and tablets can search for wifi and surf the Internet.

With the above method, wireless devices such as mobile phones do not need to register permissions on the main router to access the Internet. ）

Original network topology: Primary route ( -pc(

Current network topology: Primary route ( - Wireless router LAN port (

Wireless router WAN port (

__pc (

It's not good at drawing, I hope I can see it! Hehe!

It's simple.

Go to the wireless router settings.

Set the WAN port to a fixed IP address, fill in the IP assigned to you by the unit, and then keep the LAN port unchanged.

Turn on the DHCP service.

You can realize the computer, mobile phone, tablet and Internet access at the same time.

Hello,The conflict estimator is MAC address or ARP deception You set up a virtual beam in the route to bind the poor bend MAC address to assign the IP will not conflict View the original post".

OK. Can you send the router configuration page to the page? I'll take a look at it for you.

Enter the username admin and password is admin. According to prompts and requirements. Set the LAN type to Fixed IP. Set the address to the IP provided by Telecom.

Network configuration for other computers: The configuration of other connected computers is a bit more complicated. It is best to set each computer to a fixed IP ( , DNS server address is: Telecom provides your IP address.

Reply to me if you still have questions.

Yes, other settings are the same as PPPoE shared Internet access, but the Internet access mode is changed to a fixed IP

Yes, there is a fixed IP in the router

In general, it is possible.

The default router is set to DHCP function, and the address pool is, hehe, you automatically get an IP, for example, you configure one, for example, of course, the one you configure, to be in this address pool, and the gateway must be filled in correctly, such as the gateway is, and your DNS should also be set correctly, if the DNS settings are incorrect, you may only be able to chat QQ, can not open any web pages.