How do I open the air conditioner cover for cleaning? Hurry, hurry

1.Before removing the aircon filter, carefully open the aircon case. Generally, the air conditioner enclosure has two small card slots.

Stay, gently pull the outer cover outward. 2.After opening the outer cover of the air conditioner, there are often two buckles inside, which need to be opened gently to make the outer cover fully open.

And then. In terms of filters, it is easier to get filters, but it is stuck in a few card slots. Push the filter up first, and the lower end of the card slot.

After that, remove the filter by gently dragging it down. 3.After removing the filter, some air conditioners will have black particles with enhanced filtration, which should be removed separately for cleaning and drying.

4.Then carefully rinse the strainer several times with clean water, brush it several times with a soft brush, and finally leave it in a ventilated place to dry. until it dries.

When cleaning, make sure not to bend the filter. Although elastic, the plastic ones do not stand up to bending.

Cleaning an air conditioner can be carried out in the following steps:

1. Disconnect the power supply; to prevent electric shock. Before cleaning the air conditioner, it should run in the state of air supply for 2 to 3 hours, turn off the power supply, open the air conditioner cover, and remove the filter.

2 Clean the filter. The air conditioner filter is best cleaned with clean water, or you can use a vacuum cleaner to clean the dirt on the filter, which can be cleaned with a small amount of neutral dish soap, and the action should be gentle when cleaning the filter, so as not to damage the fiber of the filter. The cleaned filter must be dried before it can be replaced.

3 Vacuum the dust to absorb it. Some fine dust on the skeleton of the air conditioner or the evaporator can be adsorbed with a vacuum cleaner. Since the aluminum sheet of the evaporator is relatively fragile, do not touch it hard when dusting it with a vacuum cleaner to avoid damage to the aluminum sheet, and you can also wipe it with a professional air conditioner cleaner.

After the internal dust removal is completed, wipe the shell of the indoor unit with a clean wet towel, especially the vents with a lot of dirt. After the air conditioner is cleaned and installed, the air supply device of the air conditioner is activated for about 20 to 30 minutes after 10 minutes to dissipate the moisture in the machine. Do not disassemble the internal components of the air conditioner without authorization.

Special tip: Residents on the ground floor can use water to flush the outdoor unit of the air conditioner, the main flushing is the fin part of the outdoor unit, and other parts should not be washed with water without authorization. It must be cleaned once a year before use in summer or after use in autumn, and a comprehensive overall cleaning and maintenance should be done by a professional every 3 years.

In addition, it is best not to let the air conditioner stop for a long time during the idle period, and it should be started once every one or two months, so as to avoid failure when it is turned on suddenly.

The left and right sides of the air conditioner panel can be gently lifted up by hand, and then the two filters can be pulled off, and then gently wipe off the parts inside with a damp cloth, and then clean and dry the filter and install it. It's very simple to not need to find a professional master, unless you clean the machine.

Filter cleaning with a clean filter brush brush, brush most of the dirt attached to the filter screen, and then soak in a mixture containing special effect air conditioner cleaning liquid or homemade cleaning liquid or dish soap and soap powder, soak for 10-20 minutes, depending on the dirtiness of the filter, after soaking with a bottle brush gently brush the filter screen, so that each filter hole is clear and transparent, no traces of dirt blockage, and then wipe dry with a special cleaning cloth, check that it is intact, and install the filter screen to the body, depending on whether the operation is normal.

Below is Gree air conditioning.

As an example, here is how to open an air conditioner cover

1. First find the power plug of the air conditioner, then unplug the power plug and disconnect the power supply.

2. After disconnecting the power supply, find the grooves on the left and right sides of the air conditioner (general air conditioner panel.

There are some easy-to-operate structures all around, such as snap grooves).

3. Place your fingers on the grooves on both sides of the air conditioner with your fingers at the same time, pull outward, and use a little force, because there is a buckle that will jam the panel and it is not so easy to open.

4. After the panel is opened, don't peel it up too hard, and open it about 60° at most.

First of all, open the cover of the air conditioner room, take out the filter screen, brush most of the dirt attached to the net with a clean brush, and then soak it in the cleaning solution for 10-20 minutes, and gently brush the filter screen with a brush after soaking, so that each and every filter hole has no traces of dirt blockage.

1. You can hold the buckle at the bottom end of the side near the wall with both hands and lift it up to open the inner panel, and you can easily remove the filter screen after opening the panel.

2. Open the cover of the inner machine shell first, there are open places on both sides and lift it hard, there are three screws on the edge of the lower edge of the guide plate, first remove the three small covers on the top to see, and then there are two screws next to the display board, and there is an outer cover of the electric board box next to it, and a screw on the top can be removed, so that the entire outer cover can be removed.

3. The outer cover of the indoor unit, the general air conditioner cover can actually be marked on both sides of the open cover, press and hold it up and turn it a little hard to open it.

1. You can hold the buckle at the bottom end of the side close to the wall with both hands and lift it up to open the inner panel, and you can easily remove the filter screen after opening the panel.

2. Open the cover of the inner machine shell first, there are open places on both sides and open it hard, there are three screws on the edge of the lower edge of the guide plate, first remove the three small covers on the top to see, and then there are two screws next to the display board to remove, and there is also an electric board box cover next to it, and a screw on the top can be removed, so that the entire outer cover can be removed, it is not too easy to remove a few bayonets on it, and you can lift it hard from below, so that the entire inner cover is down.

3. The outer cover of the indoor unit, the outer cover of the air conditioner like a spring can actually be seen on both sides of the open cover, and it can be opened by pressing and holding it up and turning it over a little hard.

Whether it's warm or cool, every home needs air conditioning. During the use of the air conditioner, the power supply will be turned on and off frequently, and the air conditioner may be damaged for a long time. At this time, it is important to open the casing of the air conditioner and repair it.

Of course, the biggest reason why many people open the air conditioner to flush the shell is that they want to clean the dust pollution inside the shell, so as to ensure the cleanliness of the air conditioner. Warm reminder, under normal circumstances, cleaning the air conditioner can be solved by yourself. How to open the air conditioner shell and cleaning method Air conditioner relocation is a professional air-conditioning technical work, and the seemingly simple air-conditioning relocation work has different operation results in the hands of different air-conditioning relocation personnel.

When you need to relocate the air conditioner, try to choose a company authorized by the manufacturer to relocate the air conditioner, otherwise it will cost more money and bring damage to the air conditioner. The relocation of the air conditioner is divided into two parts: disassembly and installation.

The evaporator and roller inside the air conditioner are the dirtiest, and it is necessary to ask professionals to use professional chemicals to clean them, from an economic point of view, they can be cleaned once a year, and it is best to clean them professionally after the end of each air conditioning season. 1. First of all, turn off the power socket. It is best to unplug the socket directly, which is very important to avoid electric shock and leakage accidents.

2. Open both ends of the shell of the air conditioner, with a small amount of force, if you can't open it by hand, you can use a screwdriver to help, you need to master the skills, otherwise it is easy to damage the shell. 3. Open the shell, and then lift the shell above the air conditioner, which can be automatically stuck and fixed, so you don't have to worry about falling off. 4. You can see that there are 2 plastic frames inside, one on the left and one on the left.

Inside this frame is a fiber mesh, which is the part that hides the most dirt as if it was burned to filter the air conditioner. 5. Gently push up with your hand, remember that a frame has 2 places to fix, and you need to push up on both sides. Remove the filter.

6. Take it to the toilet or a place with a water source, put it on the ground, rinse it directly with water, and then gently brush it a few times with a brush. 7. Finally, use laundry detergent, or add with detergent, and then brush with a brush a few times, and finally it is very clean, use a clean dry rag to absorb the water, and there is no need to deal with it too dry, there is no problem. 8. Finally, according to the above method, in turn, push down, get stuck, and finally close the air conditioner shell to complete.

We only need to follow the steps described above to gently open the air conditioner housing. Note that it is best to bring protection when we open the air conditioner shell. Gloves, slag should not be too hard to prevent damage and damage to the air conditioning components.

When connecting the power supply voltage of the air conditioner, it is best to use a three-hole socket, so that there will be no damage to the voltage conveniently. In addition to the indoor air conditioning unit needs to be cleaned, the outdoor air conditioning machine also needs to be cleaned frequently. As a reminder, use baking soda to clean the air conditioner.

1. Before disassembling the air conditioning filter, carefully open the air conditioning shell, generally the air conditioning shell is stuck with two small card slots, and gently open the outer cover.

2. After opening the outer cover of the air conditioner, there are often two buckles inside, and it is necessary to gently open the outer cover to fully open. Then it is to take the filter, the filter is relatively easy to take, but it is stuck by a few card slots, first push the filter up, and then gently drag the filter down after the card slot.

3. After removing the filter, some air conditioners have black particles that strengthen the filtration, which should be taken off separately for cleaning and drying.

4. Then carefully rinse the filter screen with clean water several times, you can scrub it with a soft brush several times, and finally dry it in a ventilated place until it is dry. Be sure not to bend the filter when cleaning, although it is elastic, but the plastic one can not withstand bending.