How to partition 120 and 160G hard drives

The most reasonable partition.

120GC disk, 20GB, FAT32 (reason is good for system rate) D disk, 30G, NTFS (put some programs, games, etc., most of them are installed in this disk) E disk, 50G, NTFS (put some large files, movies and songs, etc., NTFS is good for the file system).

F disk, 20G, NTFS (for P2P** tools, such as BT, electric mules, etc., because P2P** needs to read and write the hard disk repeatedly, so that the hard disk is damaged, too much**, especially at the same time** multiple files are easy to cause bad sectors of the hard disk, if it is serious, it will be a physical bad sector, leaving 20G of special ** space, which is conducive to reducing damage. . . .

20+30+50+20=120g

The same goes for the 160g one.

C disk: 20g

D disk: 40g

Disk E: 80g

F disk: 20g

20+40+80+20=160g

This depends on your use, generally 120g is divided into 4 zones, c: 15g d: 30g e:

55g f:20g is fine, 160g c:20g d:

40g e：80g f:20g。

That's how I usually divide other people's districts.

It is divided into four areas, the first area is a little smaller, it is recommended not to exceed ten g, which is convenient when reloading. The size of the other three areas is according to the need, and I divide them according to work d, entertainment e, and backup f. The e-disk is the largest.

If you need to, if you don't install Vista, you can do it with less than 20g on the C drive. It is better for 30 g if I put なま. The rest can be divided into two or three districts. The size is according to your needs.

Agree with the first floor,In addition to the 20G C disk,According to your own needs, divide it into 2-3 partitions on the line,Generally, the D area is to put some commonly used software or something,I often use the E area to place large files such as movies,So I will divide E into a larger one。

The hard disk is marked with, or select all the drive letters, right-click one by one to see the capacity and home, 120G is about 108000MB

SSD SSD.

The best choice is to divide into one zone, because more partitions mean more wasted space, and multiple partitions can easily lead to misaligned partitions, and the performance of disk areas at the partition boundary will also be affected.

1t HDD.

It is recommended to divide into 2 or 3 partitions to reduce the number of partitions so that it does not look cluttered.

There are also a few ways to improve the performance of SSDs:

1. Upgrade the firmware.

Firmware belongs to improving the performance of SSDs from the software level, which belongs to the "after-sales service" of SSD companies, and is also the key to improvement.

2. Turn off the system disk index and paging.

The purpose of disk indexing is to speed up the entry into the corresponding folder.

and catalogs, but the response time of the solid-state product itself is very low, only level, which is a hundred times faster than traditional hard disks, so there is no need to do indexing, too many indexes will only reduce the life of the SSD in vain.

3、trim

In order to solve the problem of hard drive slowdown, Microsoft.

TRIM was developed in cooperation with major SSD manufacturers. If the SSD supports the TRIM command, the SSD can be used for a long time without slowing down.

4. CPU energy-saving settings.

If you enable CPU power saving and power saving management, the CPU will automatically reduce the frequency and affect the performance of the SSD.

First of all, it should be explained that whether it is a mechanical disk or an SSD, it must be partitioned before normal use, but the so-called "non-partitioning system" refers to only one area. The SSD of 120 can be divided into only one zone, which has the highest space utilization, and it is recommended to choose a hard drive with a small capacity.

From a security point of view, if the SSD of 120 separates the system from the data, it is recommended to divide it into two areas at most, one for the system and one for the program and data. Usually that's enough.

The SSD can be divided into two partitions, one 50-60G partition is used as the system partition (C drive), and the other partition is used to install games.

1T HDD can be divided into three partitions, one 50-60G, ready to use as a system partition when using HDD alone, and the other two partitions can be evenly matched.

There are two SSDs, and three are recommended for mechanical disks depending on the demand.

SSD is divided into two, one is installed in the system, there is a 30-40G is about the same, and the rest is used to install important programs that need to be accelerated.

SSD performance can only be reduced by stupid operation, it is impossible to be improved by superb operation, what grade of SSD you buy, normal use is what speed.