TP Link Wireless Router 54m Why does it disconnect when playing Warcraft True 3 after playing for a

It's a stability problem of the router, unplugging the power supply is to restart the router, so the network will be normal after restarting, you can reset the wireless router and set it up again, you can also upgrade the router firmware to try, if it doesn't work, only change the router can solve it.

The stability problem of the router may be that the temperature is high and it crashes, so return it for repair or replacement.

Continuously ping the IP address of your route to see if there is any packet loss.

If so, the NIC and route may be incompatible.

Upgrade or downgrade the NIC driver and try again.

WR8 series has a lot of this problem, my friend 840N is also disconnected within an hour, the status light is always on or off, the normal should be flashing, take it back to the factory, it will take two weeks, I don't know what the result will be.

This answer you have to adopt!! Medicines to cure the disease!! Teach you how to set up TPLlink to update Warcraft!!

1. First go to the router (if not modified) 2, and select "**Rules" in the left menu - Virtual Server

3, and then click "Add New Entry" to add 5 entries in turn (no order requirement) The first one: service port number 1119-1120

Protocol: all

Status: Active.

Second: Service port number 3724

Protocol: all

Status: Active.

Third: Service port number 4000

Protocol: all

Status: Active.

Fourth: Service port numbers 6112-6114

Protocol: all

Status: Active.

Fifth: Service port number 6881-6999

Protocol: all

Status: Active.

Give it points!!

It is estimated that you need to modify the MTU value of the desktop NIC to 1500 by default, which is generally changed to 1496. The link here is not easy to send, you go down to "solve the problem of disconnection by modifying the mtu".

Restart the router and change the signal frequency band, the commonly used is 1 6 11. Some books may not be able to find the signal, and there is also whether the router is encrypted, and others may not have encrypted the channel, which is not easy to connect. If it is encrypted, there should be several encryption methods, such as WEP WAP encryption.

If it doesn't work, see if there is a new router firmware and upgrade it. In the end, if it doesn't work, you have to upgrade the computer network card driver. If it doesn't work, contact to change the router, and you don't need to check the problem to affect your normal Internet access.

Is there a password for unlimited routing? It is recommended to turn on the firewall to see if there is an ARP attack,If there is nothing,It should be signal interference indoors,Full signal does not mean that there is no interference,It is recommended to delete the network card driver of the notebook win7 and reinstall it。

The laptop's wireless card is not driven correctly or the wireless card is damaged.

There are many possibilities, which need to be checked one by one:

1. For line problems, call for repair** and let Telecom help you see;

2. There is a problem with the separator;

3. The garbage cats sent by telecom are not good;

4. The cat or router is overheating.

It's mostly a computer setup problem that hardware is rarely seen.

The problem is a wireless signal problem.

Solution: 1. Check whether there are interference sources around, such as: mobile phones, other nearby routers, etc.;

2. Check whether the router is overheated, if it is overheated, place it in a ventilated place;

3. Adjust the transmitting frequency segment of the wireless router, generally the transmitting frequency segment of the wireless router used by everyone is 6, it is recommended that you adjust it to 11 or 13 to avoid interference;

4. Enter the wireless management interface, adjust the settings of the wireless router, and select the normal dialing mode and "automatic connection, automatic connection after booting and disconnecting" in the WLAN port setting of wireless parameters

5. Check whether the power supply is unstable, whether the plug is loose and other reasons.

The above is a personal experience, refuse to copy and paste. Hope it helps you and good luck.

Upstairs presents one of the most likely scenarios. There is also a possibility that one of your computers has been infected with an ARP virus, affecting other hosts on the intranet. Therefore, it is recommended to unplug all wired computers and only connect them to computers without wireless, and see if the connection is still dropped, and if the connection is returned, it should be the situation mentioned upstairs.

If you don't get disconnected, you're computer poisoned. The next step is to use antivirus software.

1.Check if your wireless router is overheating, if it is overheating, this will happen; Place the router in a ventilated place.

2.Kill the virus completely, and it will be like this if the virus is hit;

3.If you are using WPA encryption, it is better to use WEP encryption if you change your encryption method, and use a number without 0 as the password.

Turn off the router PIN.

Same question, waiting for answer.

It's possible that you've set the maximum connection time in your wireless router, and if so, just set it a little longer, and the rest may not be said.

I've had this issue as well. If it's your own wireless router go check the antenna of the router hehe, is it a little loose, my one is like this, it's tight, hehe.

Borrow someone's laptop and try it: it's okay, change the laptop wireless network card; If there is something, change the router.