If the wooden wall is broken, do you need to repair it, how to make it up?

1. Prepare the lid of a tinplate can as a liner with a diameter of at least about a centimeter longer than the hole in the drywall. Use a wire saw to cut horizontal narrow seams in the walls on either side of the hole. The length of the hole, plus the length of the slit on both sides, should be equal to the diameter of the lid so that you can insert the lid sideways into the hole.

2. Use an awl to drill two holes in the lid. Thread a wire or thread about 30 cm long through both holes.

3. Hold the end of the wire and insert the lid into the slit. Still holding the wire, pull the lid in your direction until it sits flat against the inside of the wall. To keep the lid in that position, it is necessary to place a broken wooden stick in the hole outside the wall and twist the wire tightly around the stick.

The lid of the jar should fit snugly against the inside of the wall.

4. According to the manufacturer's instructions, use a putty knife to wipe the pre-mixed drywall repair mixture on the drywall panel. (Don't use putty paste as it will shrink when it dries.) You can also mix plaster with water to make a sticky adhesive.

Apply the mixture or plaster to the liner of the hole and the back of the stick. Leave the mixture in the hole, cover the liner and fill the narrow slit, but don't let it spill onto the wall. You should make the patched area slightly less recessed and don't try to make it flush with the wall.

Allow the repaired area to dry until bright white, which usually takes at least 24 hours. When dry, cut off the thread or wire and remove the stick.

5. To complete the repair, you can fill the repaired place with some plaster or drywall repair mixture, so that the repaired place is flush with the wall. Let it dry, lightly sand the area with sandpaper, apply primer, and then paint again.

It depends on which wooden wall you have, so it's better to repair it.

How to repair a hole in the wooden board wall: 1. First cut neatly with a wallpaper knife or other knives, fill the wooden keel inside, cut the gypsum board that is as big as the hole and slightly smaller than the hole 2mm smaller, and then scrape the gypsum powder in batches, paste bandages, and scrape putty on it.

This method is the easiest, but it is repaired, the color will be different from the original, it is best to re-scrape the entire top surface with a hand all over the putty, and then roll the latex paint.

2. Remove the burrs on the edge of the gypsum board loophole, if the ceiling has been done, the holes of the gypsum board can be appropriately expanded, and the hidden child can be used to facilitate operation; Take a long strip of wood that is as wide as the diameter of the hole; On the side of the hole in the gypsum board around the back of the hole and the side of the wooden strip, brush the wood glue or white latex, and then glue the hole with a wooden board; After the glue is dry, use putty to scrape the front of the plasterboard flat.

This answer applies to most wall stove round repair methods.

Summary. Patching Method:

1. Use a cutting machine to make a suitable rectangle on the broken side.

2. Cut a board of the same size and add it.

3. Fix it firmly with nails.

How to repair the holes in the hollow wooden plank wall.

Hello. Is there any way to fix this?

Repair method: 1. Use a cutting machine to repair the broken side into a suitable rectangle. 2. Cut a board of the same size and add it. 3. Fix it firmly with nails.

This hollow nail is not easy to set,

I'm afraid that the board will break, no.

It would be nice to be lighter.

Can it be repaired with glue? Is there an easier way, or you can try it with glue, there will definitely be traces anyway.

Or you can find a sticker that looks like it and put it on.

You can also block it with an object.

Put a picture or something.