What should I do if my household electricity trips every day?

First, the electricity at home turned out to be normal. But recently, the old trip, often boiled water and jumped, and in the past, there was no problem with turning on multiple electrical appliances at the same time? What is the reason?

Answer, the possible reasons are: the switch is faulty, the line is leaking, one or several electrical appliances are leaking or damaged, you have added high-power electrical appliances, etc. Second, in addition, I have always felt that the electricity at home is not normal, only using refrigerators, TVs, water heaters, electric kettles and other electrical appliances, electricity consumption has been very high, generally there are three, more than five or six, is it normal?

Answer, to give you a simple way to check whether there is a problem with your electrical circuit or watt-hour meter: 1. Turn off all electrical appliances and unplug the power plug; 2. Observe the watt-hour meter and take note of the readings. At this time, its red characters should not jump, otherwise, it means that your home line is seriously leaking, or someone else's electrical appliances are connected to your home circuit.

3. Plug a 100-watt incandescent lamp into any outlet in your home and let it work for 5 or 10 hours. 4. Looking at the reading of the watt-hour meter, it should only be more than the previous reading or 1 degree. Otherwise, your watt-hour meter is not accurate.

Third, the problem added: The first problem occurred a week ago, that is, the socket switch in the kitchen had to be turned off, and it tripped as soon as it was connected. Later, I checked several lines of the kitchen socket, and after removing the line of the range hood, it was okay to turn on the kitchen socket switch.

But now the electricity load is slightly larger, and it will trip, boil water alone, or use a microwave oven, etc., it will trip. Answer, suggestion: You disconnect all the electrical appliances in your home, unplug them, and turn them on one by one, you should be able to judge that it is the best problem.

Fifth, should the low-voltage protector be replaced first? How do I change it? Do you want to replace the whole or one of the lines?

Answer, ask the technical staff of the power supply and viewpoint department to handle it for you, and listen to him on how to do it.

In the past five years, the decoration of the house wires is enough no problem, the main switch of the distribution box is a little bigger, 2 air conditioners at home are 3kw, a rice cooker - 1 refrigerator - 1 freezer - induction cooker a total of 3kw, plus other electrical appliances 1kw, the whole house is a total of 7 kilowatts and 35 ampere current, then your main switch should be installed to 50 63A, and it will trip if it is less than 50A.

Look at how safe the air opening of your home is, maybe the air opening is too small, the household appliance line is generally 4 square to 6 square is enough, and the air conditioner should not be mixed with other electrical appliances to use a separate socket.

Because in the home so electrical appliances, the air conditioner and induction cooker have the largest power, when they work at the same time, they exceed the maximum current allowed by the leakage warranty, so they will trip, you can replace the rated power and large leakage warranty, but you must check whether your household wires can withstand the impact of large current. Wires should also be replaced appropriately. Wish.

The wires are overloaded! It is recommended that each air conditioner be erected with a separate safety brake and it will not trip!

Hello dear, I am happy to answer for you, there may be several reasons for tripping every morning, 1, cooking in the morning is the use of more high-power electrical appliances at the same time, resulting in overload tripping 2, the situation that the shed line and other people's homes are shared, and more electrical appliances are used at the same time, resulting in overload tripping If there is no tripping during the day, it should be caused by these two situations, it is recommended to check the line, or staggered peak electricity, and pay attention to the safety of the town.

Dear, the reasons for tripping the electricity at home for a period of time are as follows: 1. The circuit is overloaded, and it is necessary to check whether the power of the Tuanshen electrical appliances at home exceeds the value specified by the bus or old voltage at home. 2. The wire is too thin, resulting in a large current to the point that the heat of the wire is too high, exceeding the maximum current allowed by the strength of the wire, so the first loss trips.

3. If the electrical appliance itself fails, it will cause a short circuit when the electrical switch is opened and closed many times, and it will also lead to tripping. 4. The meter itself is faulty, resulting in the meter being unable to measure the amount of electricity, and the trip protection measures are triggered.

Tripping, can be divided into short-circuit jumping, overload jumping, loss of voltage jump, household can not have a loss of voltage coil, excluding loss of voltage jump, short-circuit jump is not powered, you try to unplug all the electrical appliances on the socket, if not jump proves to be a problem on the socket, you can plug in one by one, if the electrical appliances on the socket are all unplugged and jumped, then it is not the lamp is caused by the aging of the line, (especially recommended, I have encountered, the ballast of the fluorescent lamp has such a phenomenon after aging) The line also depends on the bright line or dark line, The bright line is very simple, the dark line problem is more than the pipe elbow, tee, or joint, the last one may be overload, overload is caused by the sudden increase in the power of your home electrical equipment, in there is, the tripping circuit breaker or leakage protector can not reach the original rated current for a long time, the possibility is very small.

There are several possibilities.

1.Too many electrical appliances.

Causing overload. Solution - Replace the larger air switch.

2.The line is broken.

Causing leakage. Solution - Get an electrician to come and check the wiring.

Home circuits always trip, what are the reasons for tripping? Thanks to the experience sharing of old electricians, the knowledge is increased.

Summary. The circuit is in normal use, but it will automatically trip after a few hours of use, there are two situations, the first is the circuit load use, that is, the power is too large, your power supply can not bear it, the fuse will respond directly, and there will be tripping. The second is that there is a problem with the electrical circuit, which will cause a short circuit after a long time, which will lead to tripping.

The solution, change to another place to use electrical appliances, there is no trip description is a problem with the circuit, find a circuit company to replace the circuit that can withstand greater power, you can solve it, in addition, you should also check whether the wire is damaged, which is also the cause of short circuit tripping. There are several possibilities: 1. There is a problem with the empty opening itself, and the quality is not up to par. 2. If the empty opening you buy is small, it will often trip if the power consumption is large.

3. If there is a virtual connection in the circuit or electrical appliance, it will trip after a long time. You can first check whether your electricity consumption is overloaded, and then check to see if there is any overheating of the wiring, or whether the electrical appliances are igniting or squeaking!

Dear, it is caused by these reasons.

The circuit is in normal use, but it will automatically trip after a few hours of use, there are two situations, the first is the use of circuit load, that is, the power is too large, and the power supply of your old letter can not bear it, the fuse will respond directly, and there will be a tripping situation. The second is that there is a problem with the electrical circuit, and there will be a short circuit after using the chamber wheel for a long time, which will lead to tripping. The solution, change to another place to use electrical appliances, there is no trip description is a problem with the circuit, find a circuit company to replace the circuit that can withstand greater power, you can solve it, in addition, you should also check whether the wire is damaged, which is also the cause of short circuit tripping.

There are several possibilities: 1, it is a problem with the empty opening circle itself, and the quality is not up to par. 2. If the empty opening you buy is small, it will often trip if the power consumption is large. 3. If there is a virtual connection in the circuit or electrical appliance, it will trip after a long time.

You can first check whether your electricity consumption is overloaded, and then check to see if there is any overheating of the wiring, or whether the electrical appliances are igniting or squeaking!