What s important to start? How do you start a car when it is out of power?

Start, Run, Type msconfig, Enter;

Click on the Startup tab and cancel the program that you don't need to start.

Note: It is best not to cancel the startup of the security software.

Install a 360 directly, and then enter the software management, and you will see a boot acceleration, which will stop the unnecessary startup.

Of course, you can also prohibit the software from starting through the service that comes with the system: start running, enter "msconfig", and then pop up an interface, there is a "start" tab, remove the tick in front of the program that does not start, and only keep a "ctfmon", which is the input method, and then make sure that the computer will restart.

Installing security software generally has this item.

For example, 360 has startup management in it.

If it's manual, it's too much trouble to find places.

Generally, the "Settings" directory of each software can be used to choose whether to boot or not. If the landlord can't find it, you can click on the desktop "Start" - "All Programs" - "Start" The programs under this directory are all programs that start automatically at startup. If it's still not easy to use, you can next "Security Guard360", under the "Advanced" menu, there is a "Startup Item Status", which lists all the programs that are started with the system, and the landlord only needs to disable the programs that do not want to start with the system.

One-click optimization is also available.

I hope it helps.

The simple project approval procedures are relatively simple, and the complex is the determination of a series of matters before the project is established, which requires you to do a lot of basic preparation work and determine some key indicators before you can apply for it.

For example, if you have a good idea, but you don't have the funds, and you need to find an investor, you can't go to the project first, because the investor can't find it, and the funds are not clear, so you can't set up the project. And then to whom is the project established?

Who is the main body of the project? If you set up a company and the project approval procedures are completed for your company, what if the investor does not agree? The change of investment entity is a major change, so you can only reverse all the procedures you have gone through in the early stage.

Change the implementation subject today, re-establish the project, and tomorrow there will be disagreement with the investor on the construction content, and then go to the new one, and the day after tomorrow there will be problems with the construction site, and then go to the ......... againDo you think that's possible? It's just that you don't get bored, do state organs have this time to play with you? Now that the online platform is submitted for approval, once the project is approved, the data is transmitted to the national ministries and commissions step by step, do you think it is so simple to change?

Therefore, it is okay to have good ideas, but you can't be in a hurry, you must do all the preliminary preparations solidly, otherwise you will be uncomfortable in the end.

The problem of the U disk is that it would be nice to change it to another one, mine is that the X key has no effect.

First, let's talk about how the car starts. Due to the presence of a torque converter in automatic transmission models, the gearbox is not rigidly connected to the engine, so it is not possible to start the car by pushing a cart. This situation can only be started with an external power supply.

This external power supply can be a normal vehicle or an emergency starting power supply. The specific steps to start the external power supply are as follows:

1. Connect the positive pole of the battery of the rescued vehicle to the positive pole of the rescue vehicle;

2. Then connect the negative pole of the rescue vehicle to the iron position of the body of the rescued vehicle (metal position such as body screws). Note: Beware of short circuit in contact between the positive and negative electrodes! Must be connected in strict order!

3. After getting into the car, take off the hitching in the order of first positive and then negative.

First of all, for the automatic transmission model, do not start the cart, it is recommended that it is best to carry a portable charger with the car, in case of emergency, you can use a portable charger to charge, after connecting the charger with the positive and negative ends of the battery, set the charging parameters, start charging, and then start the ignition after charging, you can use it normally.

In addition, there are jumper cables in the car, if conditions allow, you can ask for help from passing cars or relatives and friends, and find a normal car to come and help. Connect the positive pole of the battery of the car to be rescued with the positive pole of the battery of the car to be aided with the jumper wire, and then connect the negative pole of the battery of the two cars, and then start the car by igniting the assisted car. It is worth noting that after the car starts, first disconnect the negative connection wire, and then disconnect the positive connection wire.

In general, for automatic transmission models, when there is no power, if you are not equipped with it, it is recommended to call the emergency ** for help, so that professionals can come to the rescue. Of course, the vehicle should be inspected more often to prevent the occurrence of power failure.

How do you start a car when the automatic transmission key is out of power? The remote control key is out of power, in addition to opening the door is not so convenient, in fact, it will not affect the start of the engine, after opening the door with the mechanical key and entering the car, usually you put the remote control key on the ignition switch, you can sense and identify the key, and then press the brake pedal as usual, and press the ignition switch with the key to start.

When the remote control key is about to run out of power, the instrument will generally pop up the electronic low power information, prompting you to replace the electronic as soon as possible, sometimes you may be busy ignoring this information, delayed not to replace the remote control electronics in time, this situation may have been encountered by many people, if you usually have to read the car manual, in case of emergency, these emergency measures, you can deal with it very calmly.

And the key is out of power, mainly by pressing the remote control can not be locked and unlocked, you pull out the mechanical key on the back of the remote control key, the first step is to open the door, after opening the door, you can start the engine according to the above method, when the engine is started, go to the store in time to replace the remote control electronics.

How to start the car without power cannot start normally. In this case, the emergency can be rescued by using the battery of another car, this insurance is also safe, known as lap start. It is suitable for cars with peers, and when there are jumper cables on the car, you can also use the battery lap method to start the vehicle.

In this case, the two vehicles are brought close together until the jumper cables are sufficient to connect the positive and negative poles of the two batteries. Care should be taken to ensure that the two vehicles are not in contact and only cables with sufficient load carrying capacity and insulated sheath are allowed. If the battery providing the power supply is not installed in a position on the vehicle that is convenient for direct jumping, the battery must be removed using a tool.

Determine the positive and negative electrodes of the two batteries, and use cables to connect the positive and positive electrodes, and the negative and negative electrodes respectively. It is necessary to pay attention to the positive and negative poles of the battery, and to ensure the reliable connection of the cable. Arrange the direction of the cable to prevent the cable from scratching with the tape or fan when starting.

Turn off all ancillary electrical equipment on the vehicle, start the vehicle where the battery providing power is located, and let the engine run for a few minutes to ensure that the battery is fully charged. Then start the non-electric vehicle in the normal way, and gently press the accelerator pedal after starting to make the engine run at 2000r min for a few minutes. Then turn off the ignition switches of the two vehicles, carefully remove the cables, and be careful to avoid the positive and negative cable joints colliding.

There are also two emergency methods, but both of them are not recommended to use because they are damaged to the car.

1.Cart start, trolley start is the most familiar and effective emergency starting method, but this is a means of self-control, can not be used often, because this has a certain damage to the engine and clutch, automatic transmission vehicles especially to avoid using this method to start. It usually takes more than two people to start the cart, and it is difficult to start it if there is only one driver.

Before starting the cart, we should first observe whether the road conditions of the vehicle parking position are suitable for the cart to start, you can increase the speed with the help of the downhill road, if the front of the car is an uphill road, then the forward cart will be very tired, and the speed is difficult to increase, so you should turn the head of the cart downhill direction. Try not to start the cart on a road section with a lot of vehicles and pedestrians, so as to avoid accidents caused by improper response by the driver after the vehicle is started.

The ignition should be turned on before the vehicle is pushed, and when the vehicle reaches a comparable speed, the transmission should be put into gear, and then the clutch pedal should be quickly released and refueled. Once the engine starts, you should quickly press the clutch pedal while controlling the throttle so that the engine does not turn off, and then stop slowly.

2. Car traction starts.

The method and principle of car traction starting are similar to those of cart starting, but the difference is that car traction is often much more labor-saving and trouble-saving. The specific implementation uses a tow rope of appropriate length, and the two ends are tied strongly. Before towing, drivers of the front and rear vehicles should first determine the contact signals, such as whether to start and stop with a horn or a gesture, so as to coordinate and cooperate.

To start slowly, the driver of the vehicle in front should pay attention to the traffic conditions on the road at all times, in addition to the direction of the vehicle behind him. The driver of the rear vehicle should signal the vehicle in front in time after the vehicle starts, and the two vehicles should slowly approach the side of the road to stop.

Find another car, open the engine compartment covers of both cars, connect the battery with a wire, connect the positive pole to the positive pole, and connect the negative pole to the negative pole, and then start the dead vehicle.

If you are familiar, you can click Start-Run-Enter msconfig

In the window that opens, select the Startup tab.

Or 360 or something like that.

You can use the boot optimization in 360 Security Guard or Kingsoft Guard, If you don't have these software installed, you can also enter "msconfig" in the "Start" menu "Run" to start the tab, you can see the program started at boot, and disable the unwanted ones.

The method of not asking for people (do not use third-party software): enter "msconfig" in the run box, click the "start" page, remove the check in front of the program you don't want to start randomly, OK, restart according to the prompts, and enter the system interface to OK

With 360 Security Guard, there's an advanced tool option inside. Find the Boot Acceleration item. You can set it up there.

With 360 Security Guard's boot acceleration function, you're all set.

Do you use a security guard?,There's a system optimization in it.,You can optimize it with one click Some unnecessary ones can also be set up to cancel the boot start-up.。

I also recommend you to use 360 Security Guard.

Open your phone's settings to turn it off.

The forty-third episode of the fake Li Kui cut the path to rob a single black whirlwind Yiling to kill the four tigers.