When washing in the Royalstar automatic washing machine, the spinning bucket follows, how to overhau

The possible reasons why a fully automatic washing machine can wash and cannot be dehydrated (cannot enter the dehydration program) are as follows:

Generally, the automatic washing machine cannot be dehydrated but can be washed, and the clutch assembly should be said to be not replaced. Because only one of the square wire holding springs inside is broken, the pulley of the washing machine cannot drive the outer shaft of the clutch during the dehydration program, so it cannot be dehydrated, but it can be washed normally. It's only 4 or 5 yuan to buy one, and it's easy to repair it yourself.

Put the washing machine on its side and you will see a large metal component (clutch) underneath the barrelUnscrew the nut at the bottom end, use one hand to pull away the metal arm next to it, and turn the plastic gear counterclockwise with the other hand, and you will see the square wire holding spring. When changing, pay attention to the fact that there is a small hook at one end of the spring, hook it into a small hole in the plastic gear, and then screw the plastic gear and the square wire spring back counterclockwise, and tighten the nut.

Also: Cause of failure: 1, the water level switch is broken. 2. The line is off. 3. The air bag of the water level switch is blocked.

Treatment: 1. Change the water level switch. 2. Connect the wire. 3. Clean up the airbag blockage.

Can't enter the dehydration program, always circulate the water washing state failure: can be set to the dehydration state, see if you can drain and dehydrate normally, if it is not normal, it is a computer board failure!!

When washing, the dehydration bucket rotates, usually because the clutch is faulty. During the inspection, it should be distinguished whether the dehydration bucket is rotating in a clockwise direction or in a counterclockwise direction, and then it should be repaired.

1. The cause of the failure and maintenance method of the dehydration bucket in the clockwise direction.

1) The brake band is loose.

Due to the loosening of the brake belt, the braking torque of the brake belt on the dewatering shaft is reduced, at this time, the brake belt should be disassembled and repaired, and it can be reinstalled.

2) The brake band is worn or damaged.

When the belt is worn or damaged, the braking effect on the dewatering drum is completely lost. At this time, the pawl position can be adjusted appropriately by rotating the adjusting screw, and the braking torque of the brake belt on the dehydration shaft can be increased.

2. The cause of the failure and maintenance method of the counterclockwise direction of the dehydration bucket.

1) The clutch torsion spring is damaged.

Due to the clutch torsion spring falling off, breaking or the torsion spring and the dehydration shaft are too loose and slipping, the torsion spring loses the function of non-reversal. At this time, the torsion spring should be removed and reassembled or replaced with a new one.

2) The clutch brake band is damaged.

Effective braking of the dewatering shaft is not possible due to loose, worn or broken clutch brake bands. Re-tighten or replace the brake strip at this point.

3) The clutch spring elasticity becomes weaker.

Weakened elasticity of clutch brake springs or fork springs can lead to dehydration and rotation, and the only way to replace them is to replace them with new springs.

Information**; Beijing Royalstar washing machine repair center.

The washing machine is one of the indispensable appliances in the family, which brings a lot of convenience to our lives. Some friends don't know much about the operation of the washing machine, such as how to use the dehydration of clothes, the following takes the Royalstar washing machine as an example, to introduce how to dehydrate the Royalstar washing machine, and the tips for daily use of the washing machine, I hope it will help you.

1. How to dehydrate the washing machine of Royalstar Brigade.

First, put the clothes that need to be dehydrated in the washing machine, and take care to lay the clothes flat in the drum and close the lid of the washing machine. Turn on the power, press the program standard key on the washing machine, press the dehydration function button until the indicator flashes at the dehydration place, and then press the start button, the machine does not respond at first, and after a minute or so, it will officially start dehydration.

2. Precautions for the use of washing machines.

1) Before installing the washing machine, it is necessary to connect the ground wire to avoid electric shock and protect the personal safety of the user;

2) Before putting the clothes in the washing machine, look at the pockets of the clothes, if the clothes contain hard objects such as keys, knives, coins, etc., it will affect the washing machine;

3) Pay attention to the weight of each laundry, not too much, if it exceeds the specific capacity of the washing machine, the excessive load is likely to cause motor damage;

4) If your clothes have been scrubbed with flammable liquids such as gasoline, you should never put them in the washing machine. It is also not allowed to pour gasoline into the washing machine in order to remove oil stains;

5) After the power is turned on, if you find that the motor does not rotate, pay attention to stop it immediately and check the power off, and then use it after the fault is completely eliminated.

6) Regularly check whether the power supply of the washing machine has a good insulation, and if it is worn out or aged, it should be repaired and replaced by a professional in time. The daily washing machine should be placed in a relatively dry and ventilated area.

The article concludes with the stool language: The method of dehydrating the Royalstar washing machine is introduced here for you, I hope it can help you. If you want to know more about related knowledge, please continue to pay attention to the Qeeka Home information platform, and more exciting content will be presented to you in the future.

The steps to spin a Royalstar washing machine are as follows:1Put the laundry in the washing machine, select the washing program and add the washing sensitizer.

2.After the washing is completed, choose the dewatering process. Royalstar washing machines are usually available with different spinning speeds.

3.Press the Start pause button and the washing machine begins to spin. 4.

Wait for the dehydration to complete, open the washing machine door and remove the laundry. Notes:1

Before dehydration, the laundry needs to be evenly distributed in the washing machine to avoid imbalance that can cause the washing machine to vibrate or stop running. 2.During the dehydration process, do not put your hands inside the washing machine to avoid accidents.

3.If there is an abnormal situation in the washing machine, such as abnormal noise, stop running, etc., stop using it immediately and contact the after-sales service.

There are generally two ways to dehydrate the Royalstar washing machine:

1.Automatic dehydration: After washing the laundry, the washing machine automatically enters the dehydration program. At this point, you can select the dehydration time according to your needs, then press the start pause button and the washing machine will start the dehydration operation.

2.Dehydration alone: If you need to dehydrate separately, you can take out the laundry first, select the dehydration program, and then press the Start pause button to start the dehydration operation.

Whether it is automatic dehydration or individual dehydration, users need to pay attention to the following points when operating:

1.Place your laundry evenly in the washing machine to avoid being too heavy or unbalanced.

2.Choose the appropriate dehydration time and speed according to the material of the garment and the thickness of the hole to avoid damage to the garment.

3.Before starting the dehydration feast, check whether the drain of the washing machine is unobstructed to avoid blockage.

Based on what I have learned, here are the general dehydration operation steps for Royalstar washing machines:

1.Make sure the washing machine has completed the washing program. If you haven't finished your washing routine yet, first select the appropriate wash mode, such as Express Wash, Standard Wash, or other modes that apply to your laundry, and follow the instructions.

2.Open the lid of the washing machine and distribute the laundry basket evenly, making sure that the laundry is not too concentrated or kinky.

3.Close the lid of the washing machine and find the option for spin mode. In Royalstar washing machines, there is usually a separate spin mode or a button for depotting.

4.Select the appropriate dehydration mode. Depending on your needs and the type of clothing, you can usually choose a different rate or time of dehydration.

5.Press the Start Dehydration button under your pants to start the dehydration program. The washing machine will begin the dehydration process, removing the water from the laundry.

1. The safety switch on the top cover of the washing machine is damaged.

Friends who often use washing machines must have this experience: if the top cover of the washing machine is opened when the washing machine is dried, the dehydration process will stop immediately, in fact, if the safety switch of the top cover of the washing machine is damaged, it can also cause the washing machine to not be able to spin dry.

Therefore, during the spinning process of the clothes, try not to open the top cover to avoid damage to the top linkage switch.

2. Foreign objects are stuck.

If the washing machine can not be carried out, there may be foreign objects stuck between the inner and outer barrels, you can open the door cover, dial the inner barrel clockwise by hand, if it can be rotated, it means that there is no foreign matter, otherwise, there are foreign objects, remove them.

3. Motor failure.

After the washing machine is turned on, if the motor speed is low or does not rotate, it is a motor failure, and the motor should be repaired or replaced.

If there is a humming sound that does not rotate, it means that the motor is short-circuited or damaged from turn to turn, or the capacitor is not connected to the motor circuit. At this time, cut off the power supply, remove the motor belt and restart it.

4. The solenoid valve is damaged.

This is one of the common reasons why the washing machine drying program does not work, the rotation of the inner barrel of the automatic washing machine is completed by the solenoid valve to convert the gear at the bottom, the solenoid valve is broken, the washing machine can not be dried, in this case the replacement of the solenoid valve can be solved.

5. The action of the motor thermal protector.

When the motor heats up, the action of the motor thermal protector will cause the washing machine to not be able to spin dry, and the reason for the motor heating is often overload, stalled, etc., at this time, as long as the thermal protector is reset, it can be used, and at the same time, pay attention not to put too much clothes when spinning dry.

How to dehydrate a Royalstar washing machine:

1. Put the clothes to be dehydrated in the washing machine, it is recommended to place the clothes evenly in the cylinder, and close the lid of the washing machine.

2. Plug in the washing machine and press the function button until the corresponding dehydrated light flashes separately.

3. Press the start pause button, and at this time, the machine will start to execute the single dehydration program.

4. It should be noted that the single dehydration is still a drainage procedure at first, so the machine does not respond at the beginning, and it will take about a minute before the rotating dehydration bucket will be started.

Precautions for Royalstar washing machine manual:

For washing, or single dehydration, you need to adjust yourself, in the Royalstar washing machine mode, there will be an indicator light display at the same time, for large items, underwear, etc., there is also a separate washing program, but in daily home use, it is generally mixed, or self-compiled. For these settings, depending on your own washing machine model, the manual of each model of Royalstar automatic washing machine may be different, but there is not much change in operation.

In addition, the instructions of the Royalstar washing machine are included with the purchase, if you accidentally lose or damage, you can go to the official website of the Royalstar washing machine**. For the initial operation of the washing machine, it is better to read the manual carefully, so as to avoid a lot of unnecessary trouble.

The steps for separate dehydration of Royalstar automatic washing machines are as follows:

1.Remove the laundry from the washing machine and make sure the inside of the washing machine is empty.

2.Open the lid of the washing machine and drain the water from the washing machine.

3.Close the lid of the washing machine and set the program selection knob of the washing machine to "spin" mode.

4.Press the start button of the rinser to start dehydrating individually.

5.Wait for the washing machine to complete the dehydration program and turn off the power switch of the washing machine.

Notes:1Be sure to remove the laundry from the washing machine before dehydrating it alone to avoid damaging it.

2.During the dehydration process, do not put your hands inside the washing machine to avoid accidents.

3.During the dehydration process, the washing machine will produce loud noise and vibration, so do not place the washing machine next to fragile items to avoid damage.

Summary. The Royalstar automatic washing machine spinning function is self-contained and can be used separately. On the control panel of the washing machine, select the "Dehydration" mode, then press the "Start Pause" button and the washing machine will start dehydrating.

The spinning time can be adjusted according to the settings on the control panel of the washing machine, generally it can be adjusted to 15 minutes, 30 minutes, 45 minutes, 60 minutes, etc. If you want a longer dehydration time, you can repeat the dehydration operation several times until you are satisfied.

How to spin the Royalstar automatic washing machine alone, every time you press it, it is integrated with washing.

The Royalstar automatic washing machine spinning function is self-contained and can be used separately. On the control panel of the washing machine, select the "Dehydration" mode, then press the "Start Pause" button and the washing machine will start to dehydrate the water. The spinning time can be adjusted according to the settings on the control panel of the washing machine, generally it can be adjusted to 15 minutes, 30 minutes, 45 minutes, 60 minutes, etc.

If you want a longer dehydration time, you can repeat the dehydration manipulator several times until you are satisfied.

Can you add, I don't quite understand it.

This can be due to a problem with the washing machine's control program, or a malfunction of the washing machine's control chain. Workaround:1

First of all, check if the control program of the washing machine is normal, if there is a problem, you can try to reinstall the control program of the washing machine to ensure the normal operation of the washing machine. 2.Secondly, check whether the control panel of the washing machine is faulty, such as the failure of the shed block, you can try to replace the control panel of the washing machine to ensure the normal operation of the washing machine.

Personal Tips:1Regularly check the washing machine's control program and control rock panel to ensure the proper operation of the washing machine.

2.If the washing machine fails, you can try to repair it yourself, but if you are not familiar with the structure and operation of the washing machine, it is recommended to find a professional to repair it as soon as possible.