How to remove a piece of kitchen ceiling, how to remove kitchen ceiling Find out

The dismantling of the integrated ceiling is very simple, only three steps are required: suction, pulling, and dismantling. The specific steps are as follows:

The manufacturer will match a small tool, as long as you gently close it on the board, suck the air away, suck one of the corners, and then pull it out hard, pull out the four corners, you can disassemble the whole plate and clean the inside. When the outer panels are removed, the internal structure can be seen. Among them, each plate is equipped with an edge banding auxiliary keel around it, and the auxiliary keel plays the role of connecting the module and the light steel keel to ensure that each plate can be closely connected to each other.

Cleaning method. 1. Cleaning of the kitchen integrated ceiling: under normal circumstances, the kitchen gusset will choose to be roller-coated more, and a few of them are brushed, which is also a better process in the roller coating, not many people in order to save money when the film board, the former cleaning because it is in the kitchen, there will be oil stains, then use a small amount of dish soap, but there must be sufficient water to mix, to use a softer, better absorbent cloth to scrub after water, it doesn't matter if you can use force in the middle, but when you are around, Use light force.

In particular, pay attention to not hard cloth and cleaning balls and the like, as soon as you scrub it, it will leave a lot of small wires on the shiny panel, damaging the gusset, at this time, if it is a roller coating, it is not good, if it is a film, it is not good. Another point is that if you use the kind of cheap differential plate, heavy one, then be careful, because it has a lot of iron components in it, not an aluminum-magnesium alloy gusset, so after seeing water, it is easier to rust. When the first time with a soft towel soaked in water scrubbing, the second time with water to scrub it, open the window ventilation to dry naturally, if the ventilation and sunlight is not good, then use a better quality towel once.

2. Cleaning of the integrated ceiling in the bathroom: Generally speaking, there are no oil stains, it is easy to take care of and clean, often scrub with a soft cloth with water, a month or two months, use the method of cleaning the kitchen to do a care, the situation of the corridor is similar to the bathroom, or to explain that if it is the kind of poor board, then it is better to clean and take care of it less, and usually use a soft cloth to remove the dust, because the more you clean, the faster the rust will come out. It's no problem to have a good board for more than ten years, your cheap buckle board, only three years of chance, after three years, it will start to rust out from the side, and in the end the whole thing will be ugly, and you will regret that it was so cheap that dozens of yuan a square, it's not worth it.

1. If you want to disassemble it yourself, you can buy a suction cup first, and use the suction cup to stick to one corner of the square. (e.g. square aluminum gusset).

2. Then pull one corner of the aluminum gusset hard, and use the same method for the other three corners.

3. When installing, it is pressed one by one, and the last one will probably have a small seam of centimeters (such as: strip-shaped aluminum gusset).

4. Insert it along the gap with a wallpaper knife, draw back and forth a few times, find the position of the clip, gently pry downward, pry the middle first, and both sides will be deformed.