How to deal with the dust of the Xiaomi Mi 6 speaker

You can use a cotton ball to clean up the dust, it's normal to get into the dust, don't worry too much, just clean it up a little.

For more obvious external dust, you can try to clean it up with some small soft brushes. For some imperceptible or fine dust, you can try to use double-sided tape with good viscosity, tear it into a ribbon, and then stick the double-sided tape on the microphone or speaker, and after easy smoothing, tear off the double-sided tape to stick out a lot of small dust that you haven't noticed.

Do not force the inside of the earpiece, otherwise the membrane inside may be punctured and the earpiece may malfunction or the sound will be distorted. If you have stubborn stains, you can use a cotton swab dipped in anhydrous alcohol to gently wipe them, and then use a brush to clean the dirt on them.

The loudspeaker is a transducer that converts electrical signals into acoustic signals, and the performance of the loudspeaker has a great impact on the sound quality. The loudspeaker is the weakest component in the audio equipment, and it is the most important component for the acoustics. There is a wide variety of speakers, and they vary greatly.

Audio electrical energy produces sound through electromagnetic, piezoelectric, or electrostatic effects, causing its paper cone or diaphragm to vibrate and resonate (resonate) with the surrounding air.

Low-grade plastic speakers have no sound quality at all because of their thin cabinets and inability to overcome resonance (some well-designed plastic speakers are far better than inferior wooden speakers); Wooden speakers reduce the sound coloration caused by the resonance of the cabinet, and the sound quality is generally better than that of plastic speakers.

Usually multi-loudspeakers are two-way two-way designs, with one smaller speaker responsible for the mid-treble output, while the other larger speaker is responsible for the mid-bass output.

1. Take a magnetic screwdriver and suck it out, and the sound will be fine.

2. Open the back cover of the mobile phone, brush out the dust in the speaker with a small brush or wipe it with a very fine needle with a cloth.

3. It's okay to eat leftover chewing gum, be careful not to stick to the speaker of the mobile phone, press it gently, and stick the dust out.

4. Another suggestion to prevent dust from entering: if there is a horn on the back cover, open the back cover, and clip a napp between the back cover and the speaker, and the sound will not become smaller. If the speaker is outside, you can buy a mobile phone case and then add paper.

The tools we need are also very simple, just a mineral water bottle and a straw are needed. The method is also very simple.

First, we cut off the top half of the bottle with scissors. In this process, we must pay attention to our own safety, do not hurt ourselves, in the future is to deal with the bottle cap, poke a small hole on the platform, not too big, if it is more difficult to do, you can bake the bottle cap with fire to soft, and then use a small wooden stick to pump a tube, and after it cools, cut off the protruding part outside the home. The hole should not be too big or too small, as long as it can fit just enough into the straw.

Next, stuff the straw into a part, only need 3 catties or about 2cm, not too much, plus the straw and bottle cap are firmly fixed, when the gap is blocked with glue, the effect will be better. After fixing, the suitable length left by the Jiangxi tube is OK, and the rest is cut off with scissors.

Then we need a relatively small vacuum cleaner, you can use the back of the hair dryer, we can find that only your back is transported from the outside suction alley, so here we can use the hair dryer, ID card, only need to turn on the cold air, not hot air. Let it slip over the bottle. Turn on the cold air and we can find that we can feel a strong suction force from the straw, and at this time in Jiangxi can aim at the holes that want to be angry.

It's as simple as that, just use a plastic bottle and straw to clean the speaker from dust.

1. Find a piece of double-sided tape or transparent glue and tear it into a ribbon.

2. Clean the double-sided tape or transparent glue at the earpiece and charging port of the mobile phone, and it is basically completed.

3. For the dust that is difficult to remove, you can use a toothpick to carefully poke the tape into the earpiece and clean it as close to the earpiece as possible.