Apple earphones are low in water, and there is a way to make the sound louder

This will happen if the water is not dried after the earbuds are in the water, and if the water is still dry, it is recommended to contact the after-sales service and send it for repair.

The water inlet treatment method of the earphones is as follows:

1.Because of the structure of the earphones, they are afraid of high temperatures and vibrations. The best way is to place it in a naturally ventilated place to dry slowly, and after drying, use a hair dryer to blow through the hole where the headphones are flooded, and the high and low bass will come back.

2.Put the earphones in a sealed bag along with the absorbent tissue and place them in an environment of about forty or fifty degrees. The principle is to create a sauna-like environment, and when the water is steamed, the tissue will absorb the water.

Remember to change your facial tissues regularly. Pay attention to the observation, be sure to grasp the temperature, don't get too high.

Blow on the headphone hole that you think is small (mouth to blow) to block a few air intakes, you can hear it when you blow, the sound of patting, can reset the eardrum, blow a few times and it can basically recover, but the premise is to dry, so do I, put it in the washing machine, and now it's good.

1. First of all, of course, the whole machine should be disassembled, and the corresponding screwdriver should be prepared before that.

2. When removing the screen, pay attention to gently separating the chiplet connected to the motherboard from the motherboard.

3. Before removing the metal shielding isolation layer, tear off the network access card and the card slot sticker under the network access card.

4. The last is to take a hair dryer to dry, but don't blow on the screen for a long time, such a high temperature will destroy the screen, even if the screen has a watermark, you can use the phone normally, the water in the screen will generally dry in two days, and you will see that the watermark inside is getting smaller and smaller.

5. Blow the front and back of the motherboard to ensure that there is no moisture residue, and try to blow out the water at the earpiece and buttons.

6. Finally, put the disassembled mobile phone in a dry and noisy place, preferably about two days, and then install it.

The sound becomes smaller when the headphones are in waterMethod:

Method 1: After the earphones are rinsed with water, when the water intake is large, the earphone cavity will be filled with water, blocking the movement of the diaphragm, resulting in a smaller sound. Here's how to deal with it: Control the water inside the headphones. drain the water; Dry the water with a hair dryer; Hang it in a ventilated place for about 2 days.

Method 2: After washing the earphones, if the water intake is small, a water film will form in the earphone cavity, resulting in a smaller sound. The treatment method is as follows: insert toilet paper or sanitary napkin into the ear hole to absorb water; It is placed in desiccant for about a day, sealed, and hygroscopic.

Method 3: The above two methods cannot restore the earphones to normal, and you need to go to the electrical repair shop such as the earphones for repair.

Introduction: The time of wearing the earphones should be controlled at 30-40 minutes each time. Wear headphones for no more than 3 hours a day, and minors are recommended for no more than 2 hours to avoid damage caused by headphones.

Do not wear headphones in noisy environments In buses, subways and other environments, the background noise is high, and if you use headphones, you will unconsciously increase the volume of headphones.

Moreover, it is also easy to bring traffic safety hazards. Gong Shusheng said that in a quiet situation, the damage to hearing caused by headphones is relatively small, but in a noisy environment, the damage to hearing caused by headphones is relatively large. Therefore, it is not recommended to wear headphones in noisy environments.

If you have experienced symptoms such as tinnitus and hearing loss after wearing headphones for a long time, it is not recommended to wear headphones again.

Apple earphones can still be used if they get into the water.

Apple earphones can still be used after falling into the water. The best way to deal with it after falling into the water is to place it in a naturally ventilated place, and after it is dry, use a hair dryer to dry the hole where the headphones entered the water, and the sound will come back. If you can hear the sound, when one voice is loud and the other is small, then you should use a hair dryer to blow on the headphone jack, usually the original Apple headphones are fine.

Special attention should be paid to the fact that you must not hurriedly insert the Apple earphones into the Apple mobile phone as soon as they are fished out of the water to check whether they are broken, because if the earphones are not dry after entering the water, it is likely that the chips inside will be burned, and the earphones will be scrapped.

Precautions for the use of Apple headphones:

Inside the charging case, there is a pinhole-sized indicator, which helps users know the status of the AirPods.

When paired with a device, you only need to put on one earbud to connect and use all AirPods functions as normal, such as double-tapping to call Siri, taking off the earbuds to pause**, etc. Therefore, when we are walking or driving, we only need to wear one earphone, and the other ear is idle to listen to all directions.

When wearing AirPods, you can know how much power your AirPods have left by asking Siri. In addition, you can also place the AirPods in the charging case, open the lid, and the iPhone screen will pop up the remaining power of the AirPods earbuds and the charging case.