How deep is it good to use a deep well as drinking water in rural areas? Can it be changed every few

People living in cities or towns have been accustomed to the convenience of water and electricity, because there is tap water to the home, so we no longer need to use wells to maintain the water for life as before, and in some remote rural areas, we will still dig a deep well, when cooking or laundry, draw water from the well for use, so today we will talk about the deep water wells that operate drinking water in rural areas when drilling wells, how deep is it better, and whether it can be replaced every few years.

When we go to the countryside, we often see that every household has a well, but how to dig the well, or how deep it is, you may not be very clear, in fact, this depth is not a unified standard, but according to the local water quality conditions and soil conditions.

We all know that the water in the well does not come from the water plant, but from the groundwater under the soil, so when drilling a well, it is better to decide how deep the well is according to the depth of the groundwater from the measured surface of the ground.

On the other hand, after choosing the location of the well and the depth of the well, there is also a criterion for judging whether the water source near the selected area is polluted, and if the water quality is polluted, then even after the well is drilled, the water that floats up cannot be used by the family, otherwise it will cause damage to the body.

As for the second question, whether the deep-water well can be replaced every few years, in fact, the demand for changing the well is determined according to the amount of water source, assuming that a well is used for three years and five years, the groundwater gradually decreases, then it is bound to be replaced with another well to use, but generally people will measure the capacity of groundwater before drilling the well. In this way, there is no need to spend energy and financial resources on digging wells frequently, after all, although draft is essential to life, but there are too many things to solve in life, draft is only a small part of it, there is no need to spend too much energy.

People living in rural areas will choose to dig a well in their own home, and with a deep well, it will be very convenient to use water. The matter of digging a well should be chosen according to the terrain, not that it can be drilled deeper and deeper. Digging a well is not as simple as you think, and if you want to know how deep you want to dig, you must pay attention to the following issues.

The first thing is to see if the water is flowing vigorously, and once there is, you can choose to dig a well here. The second is to observe the level of the groundwater level to see if it meets the conditions for digging wells. The third is whether there is a source of pollution in the nearby river, and bad water is seriously harmful to the body.

If you want to dig a deep well for drinking water, you must make sure that the water quality is good. Depending on the level of the water table, it is best to determine how deep the well should be drilled. You can't rely on luck to do anything, you must do some substantive research.

If there is a spring nearby, you will save a lot of effort, and you don't even have to dig a well. You can choose to make some water rivers in the place where you live, and you can drink real mountain spring water every day. If you don't do research, even if you are technically good, you will do some useless work.

Wells need to be replaced when they dry up, but they don't need to be replaced when water is available. The water is turbid and you can't continue to eat, and there is no way to meet your daily drinking. It is very troublesome to change the well, so you should pay attention to the observation when choosing to drill the well.

You can't change your clothes once a day, like washing clothes, unless you see that the amount of water is not enough. <>

In general, in rural areas, there is not like running water as soon as the water pipe is turned on in the city. They will find ways to store some water in their homes, even if the water is out. Sometimes it is necessary to plant rice, and the rice fields need to be fully watered.

If you have water in your well, you can choose to pump it in time. It is very convenient and there are no problems with it, and people in rural areas will choose to dig a well.

As long as the deep water wells drilled in the countryside are well managed, they will generally not be broken, and the deep water wells in our village are about 80 meters, and they have not broken for decades.

Deep-water wells should be managed in this way:

First, after the well is drilled, the wall of the well is equipped with a wall protection pipe, there are cement pipes and plastic pipes, and the cement pipes are more durable than the plastic pipes, so as to prevent landslides and rockfalls, and make the well more durable.

Second, try to avoid sandy land and silt land, which have complex terrain structures and are easy to collapse and deform. Choose a plot with a slightly harder address. Good terrain structure is also an important factor for the long service life of the well.

Thirdly, large trees should not be planted, because these trees have strong roots and can easily enter the well, causing deformation, and the powerful water pump cannot be launched, causing the well to break.

Fourth, cover the well to protect the house, so that debris does not enter the well, thunderstorms, floods can not be washed away.

In short, it is not easy to dig a deep well in the countryside, and it will cost you money, so you must pay attention to protection, so it will be used for many years.

This should be determined according to the specific environment, under normal circumstances, there is 10 meters, this does not need to be replaced, unless there is no water.

The depth of the general well is about 5 meters, but there are also wells of 20 meters. It is not possible to replace the well at will, because changing the well at will may cause the water pressure to be unstable.

Kiss! Hello, glad to answer for you. The well water of about 90 meters is drinkable.

Drinking well water, generally shallow wells within 90 meters. The 20-meter well is a shallow well, and the water source is mainly shallow groundwater, which is basically shallow well water, and the water quality of the source is relatively easy to be affected. There is no rule on how many meters of well water can be drunk.

In places with a good environment, surface water can be drunk. Whether the well water can be drunk or not depends on the local geological conditions and the safety of the surrounding environment. If there is a large amount of sewage pollution, the well water is undrinkable, no matter how deep.

The depth required for mineral water wells is based on drilling through the rock aquifer, some are more than ten meters deep, and some are even more than 100 meters. In order to ensure that the drilling and the well pipe are in line and prevent surface water from seeping into the aquifer through the well pipe, the wellhead must be sealed and it is forbidden to connect to the surface air. Therefore, mineral water wells cannot be measured by depth.

The alkali in the well water is very large, but the water quality is actually excellent. The substances that cause excellent water quality are mainly magnesium hydroxide and calcium bicarbonate, which are not good for people to drink for a long time. Hope mine can help you!

To drill a well, it is necessary to dig it to a depth of 50 meters.

Under normal conditions, there is clean water when you hit 30 meters, but it is best to hit 50 meters deep under the rock layer, and the water quality in this layer is the best and cleanest.

Precautions for drilling wells:

1. Choose a place as far away from sewers, sewage pipes and rivers as possible.

2. When drilling wells, it is necessary to imitate the lining of swimming bricks in time, and the deeper the lining, the more necessary it is to prevent collapse.

3. When using the culvert pipe as the inner tank, you can dig to the depth at one time and start to release the pipe. However, the soil must belong to the geological area that is not prone to collapse.

4. The depth of drilling the well must be dug until there are obvious water traces in the soil below to stop.

5. The back cover must be made of clean stones or large stones that are not easy to weather.

6. All processes must pay attention to safety, especially the excavators below must wear safety helmets, and there must be equipment to press air from above to a certain depth. Personnel who were found to have landslides were evacuated immediately. In general, there will be no landslides in geology. <>

It is best to keep a distance of more than 10 meters between drinking water wells and sewage wells in rural areas, and in order to ensure the safety and sanitation of rural water supply and drainage systems, a certain distance should be maintained between drinking water wells and sewage wells, and it is generally recommended that the distance between the two should be more than 10 meters. This is because the sewer well will contain a large number of harmful bacteria, viruses and other harmful substances, including feces, urine, waste water and garbage, etc., if the sewer well and the drinking water well are too close to the mu, the drinking water well may be polluted, resulting in unsafe water quality and may endanger human health. If the spacing of more than 10 meters cannot be guaranteed, other measures can be considered, such as setting up impermeable walls around the sewer wells or using other technical means, such as installing filtration, disinfection and other treatment equipment, to ensure the quality and hygiene of drinking water in rural areas.

At the same time, regular inspection, cleaning and maintenance of wellheads and wellbore, and taking preventive measures to prevent pollution sources from approaching, are also effective measures to control well water pollution.

There is no one answer to the depth standard for drinking water wells in rural areas.

Cause; Headwaters.

There is no relationship between quality and depth, it depends on the internal quality of the water. If the groundwater is polluted, even if the depth of the well reaches 100 meters, it is useless. The quality of water is directly related to the environment. Therefore, the well you want to dig is the depth you want to dig to meet the standard of eating.

Wells] are engineering structures mainly used to extract groundwater. It can be vertical, oblique and a combination of different directions, but generally vertical can be used for water intake and drainage, and can also be used for water injection. According to the buried distribution of groundwater and the lithological structure of the aquifer, humans have created a variety of well types.

Wells are of great significance to the development of human civilization. It is also possible to accumulate water.

History] The earliest water well that has been discovered in China is the well of the Mudu Ancient Cultural Site in Yuyaohe, Zhejiang, which is about 5,700 years old. It's a fairly elaborate square wooden well, with a depth of two meters and a side length of 2 meters. From this, the appearance of the primitive form of the well was much earlier.

Types of water wells] engineering construction dewatering wells, water source air conditioning wells, ground source heat pump wells, installation of water air conditioning and air coolers, machine drilling deep wells (factory special wells), stone wells, drinking water wells, farmland wells, foundation precipitation treatment, old well transformation, maintenance of deep water pumps, large foundation pits, sewage pipelines, tunnel precipitation, factory production water, mechanical cooling water and domestic water, etc. Tube wells, deep well precipitation and light well point precipitation were adopted.

In the past, five meters was enough, but now it seems that the water level is low, and it is estimated that it will take one or twenty meters.

Drilling rig drilling: drinking water wells. (100-500 meters, spiral iron pipe, cement welded pipe) farmland wells.

30-120 meters, special cement pipe).

Precipitation wells. 5-30 meters. special cement pipe).

How deep should be the wells for drinking water in rural areas. The question is related to the landscape where you are. Is the water good.

And not how deep. And what to do if the drinking water well is contaminated with a dead dog. For this question, you need to go to the medical school for a test.

It's too small to be usable.

: No one has an answer with a depth criterion. The reason is that the quality of the water source is not related to the depth, it depends on the quality of the water. If the groundwater is polluted, it is useless to drill wells to a depth of 100 meters.

Our rural well water is generally rarely useful, it is tap water is fast and convenient, worry-free, and there will be more water for bathing and laundry in summer, and much less in winter. There are also some who use tap water to water small vegetable gardens, and some use well water to wash clothes in winter, and the temperature is just right. Normally, 50 square meters of water a year is about the same, just for reference, good luck.

The water output of a well is not equal, some wells produce a very large amount of water, which can reach about 20 cubic meters a day, while some wells produce relatively small water, which is only enough for a family.

In rural areas, a well generally uses about 10,000 cubic meters of water a year, and the water consumption of a well is generally calculated according to the number of water users.

Rural hands are generally used, how many square meters of water is used in a well a year, and the average amount of water in rural areas depends on the number of people, and if there are few people, it is generally about 15 million. If there are too many people, it is not worth that much.

It cannot be said that a well can only be used in a year to calculate their water consumption based on the population, not according to the water feature.

How many cubic meters of water is used in a year for a well? Rural water is generally used by a well, and its consumption is still relatively small, because the rural water consumption is relatively small.

It depends on how many people there are in each village, if there are few people in the village, he will definitely be able to use it, if there are many people in the village, it will definitely be much more useful.

How many cubic meters of water is used in a year for a well? If a well of rural water is used by a single household, it may only use about 300 cubic meters a year, but if it is used by the whole village, it is still difficult to count.

There is no way to calculate the well water, there is a spring in the well, which is generally inexhaustible, and it is generally not dry to pick by hand.

This man is basically tens of thousands of dollars a day.

Do you have a submersible pump or a centrifugal pump in your home? It should be stagnant, just go down and dig for it.

The well water in the countryside is generally Fan spring water. This one can't be used up, and when it's used up, it will flow out again.

If it is normal domestic water, instead of irrigating crops, there are six or seven square meters of water a month, 100 square meters a year, which is enough.

In rural areas, the average household uses about seven or eight tons a month, and a year it should be about seventy or eighty tons.

How many cubic meters of water is used in a year for a well? This is not easy to assess, and it is sometimes used in rural areas to irrigate vegetable gardens.

There is no accurate number for this, it depends on where the family uses water.