Bad internet every morning. What s going on?

This phenomenon arises from three reasons: First, the responsibility of the operator (failure of transmission and switching networks).

Operators must ensure that the signal quality to the user (bandwidth, bit error rate, signal-to-noise ratio, transmission rate, signal level, input and output impedance, signal stability, input and output impedance stability) in line with national standards); Specific**: Telecom 10000 Netcom 10060 Tietong.

The other ** is very good, and a certain ** is particularly bad, which is the problem of ** itself, and has nothing to do with the operator and the user. Copyright Statement: This answer is harmonious and original, and no one may steal it!

Three: the user (responsibility) The following factors will lead to your current state, if there is no problem with the above-mentioned operators after testing, the next is your user's own problem; If you don't have the following problems, you can directly call the operator** and ask the operator to deal with the operator's own related matters. Copyright Notice:

This answer is original and original and must not be stolen by anyone! The cause and treatment of this phenomenon by the user are under the premise that the user's device settings must be correct: 1:

Power supply with a multimeter.

Check if the power supply is stable? Are AC voltage fluctuations within the allowable range? Is it more than 5% of the rated voltage?

Is the ripple coefficient (checked with a millivoltmeter) acceptable after the power supply is converted? Is the temperature rise of the power supply abnormal? Do the voltage regulation characteristics meet the specifications?

Do the voltage regulation characteristics and ripple coefficient meet the technical specifications under rated load? When replacing a large fan, is your power capacity up to the requirements? The power supply of general auxiliary equipment (routers, network switches, cats, etc.) is a rectifier power supply, without voltage stabilization function, with a large ripple coefficient (which may be caused by the drying up of the filter capacitor), and the load capacity is also poor; Fever.

As a result, the equipment does not work, and special attention should be paid to monitoring during operation. Due to the overvoltage of the equipment (like feeding a child, more can hold up) and low voltage (like feeding a child, less will cause malnutrition.

Excessive voltage fluctuation (such as feeding children, hungry and full meals), overcurrent, heating, resulting in overheating protection action to cut out of fault and exit the equipment from operation (i.e., slow, delayed, repeated start, delay, disconnection, disconnection, automatic shutdown, crash and other appearances), etc.; Is the overcurrent protection and overtemperature protection of the power supply operating correctly? Is the movement sensitive?

2: Check the network cable and crystal head (R45): whether the crystal head and the socket are plugged in (loose)?

Is the contact good? What is the contact resistance? Is there any dirt accumulation?

Is it oxidized? Is the mechanical latching of the crystal head and seat locked? Is the latch secure?

Is the network cable and the plug pressed tightly and in good contact? The inter-line insulation resistance of network cables.

I use a 100V shake meter.

There are many factors that determine the slow network at home, involving terminals, lines, equipment and other aspects.

1. The network itself is a problem, the server bandwidth is insufficient or the load is too large.

2. Network cable, optical fiber problem, network cable connector loose or network cable quality is not good, the crystal head should be compacted, if there is a problem, directly change the crystal head to do it again, the optical fiber bend is incorrect (optical fiber, leather cable should not turn straight), the optical fiber adapter socket is loose or dusty (unplug and wipe with alcohol), resulting in poor contact and large attenuation.

3. Terminal equipment problems, the optical modem or router is not ventilated, the power is not interrupted for a long time, the router is overheated for a long time, and the quality of the router is not good, resulting in slow network speed.

4. Problems with mobile phones and computers, mobile phones and computers have been used for a long time, the memory occupies a large amount, the response is slow, the reception network signal is poor, and the mobile phone or computer is cleaned up.

5. Operator problems, the general operator to the user is a secondary splitter, and now the operator purchases the splitter with low pressure, resulting in poor quality, long time, plus dust and other factors caused by attenuation and larger, the network can be connected, and the Internet is slow or unusable.

The network is not good, first of all, you need to check the problem on the side of the business, you can call **consultation, such as the mobile can dial 10086, and you can also test how many megabytes the network is on the computer. If everything is fine, then restart the router at home.

If the internet is not good every morning, it means that there are too many people using mobile data in the local area, or there are people playing games on broadband.

It may be a problem with the network cable and optical fiber, the network cable connector is loose or the quality of the network cable is not good, the crystal head should be compacted, and if there is a problem, the crystal head should be changed and redone, the optical fiber bend is incorrect (optical fiber, leather cable should not turn straight), the optical fiber adapter socket is loose or dusty (unplugged and wiped with alcohol), resulting in poor contact and large attenuation.

If the network is not good every morning, it may be a problem with your network router or cat. Restart and then turn it back on again to see if it might get better.

Every morning the network is not good, it may be a problem with the connection, just start it again.

The network is not good every morning, what's going on? If the Internet speed is slow, the first thing to check is the line, is the plug not plugged in properly? Is there any looseness? It's still a problem with the cat, if these are all right, you have to shut down and restart.

If the network is fine, you can restart the router, or restart the phone, and the network should be better.

Check the network connection to make sure the router and the cat are working properly!

Because there are a lot of people, because after a night's rest, they get up in the morning and open their eyes to look at their mobile phones as soon as possible.

What's wrong with bad internet every morning? Do you see if it's a problem with your wireless router? You can turn off the router and restart it or restart the phone, it may be too long and you need to lose power.

What's wrong with bad internet every morning? There are two reasons why my mobile phone has a bad network, one is that I don't have a good Internet connection, and now it's fine.

This is not necessarily, it mainly depends on what the network is in your area? If only your home network is poor, it is recommended that you call ** to the mobile or telecom company.

Very good! Because of ignorance, I can go online and be more able to enrich and strengthen myself.

The internet speed is not good and the phone is too much junk and you can deal with it from these two aspects.

There should be something wrong with your computer, our usual network application should receive much more data than the data traffic sent, and there will generally be an order of magnitude difference, and yours is the opposite, should be teased that the check is that your computer has a virus or something that affects the data being sent, it is recommended to check and kill the virus or even redo the system.

1.Multiple computers share the Internet, and the computers in the shared network may have ARP viruses;

3.You are using P2P software, for example, Thunderbolt, Express, Whirlwind, Network Studio Calendar Accelerator, etc., P2P works on the principle that in addition to your own files, you also have to upload to the host, through the content of automatic uploading, so as to complete the resource sharing between netizens. If your P2P software is self-starting, it will be automatically uploaded once the computer is turned on, and if you upload a large amount of data, the greater the impact on the network of playing games and sending emails, thus silently devouring network traffic without the knowledge of netizens.

There are many reasons for slow network speed, if it used to be normal, it has only slowed down recently, it may be that the computer needs to be cleaned or **, and there are more and more programs. The following methods are recommended:

1.To turn off System Restore, My Computer Properties System Restore turns off System Restore on all disks.

2.Turn off system hibernation, desktop properties screen saver power hibernate and remove the checkmark before initiating system hibernation.

3.Turn off virtual memory, my computer properties advanced performance settings advanced change Select C disk, which is the system disk, select no sub-page, and then set the virtual memory to its disk, and want the disk with more disk space left, such as d, e, f and other disks

4.Clean up hard drive junk and registry junk with Optimizer.

5.Clean up the IE temporary folder, IE properties delete cookies, delete files.

7.To delete system logs and program logs, My Computer Control Panel Management Tools Computer Management Event Viewer Application, right-click Clear Events, and then Clear System Logs.

8.Clean the system cache: 2000 system is: C: Winnt System32 all files under DLLcache.

XP system is: C: Windows system32 DLLCay under all files to search and rent to clean the system cache. Turn on my computer, Tools. File & Folder option and then put the hidden protected system files.

Note: You can directly run the purgecache command to automatically delete it.

9.Clear the ** station.

10.Worms, which constantly copy junk files and occupy space on the system disk, cause the system to be paralyzed, so it is recommended to kill the virus.

11.Delete the C: Windows Software Distribution Download under Wen Shiqing Zhao.