The newly bought freezer has just been plugged in and has not put anything in yet, so it starts for

The refrigerator will start and stop for a while, because there is a problem with the compressor starter, which causes the overheating protector to work. When the temperature drops to a certain point, it will restart, but it will jump again.

Lack of adjustment thermostat.

Because during operation, the internal temperature will change, if it is not adjusted for a long time, it may cause the refrigerator to shut down because the temperature is too low, and the user needs to adjust the refrigerator temperature according to the actual situation.

Thermostats are out of order, especially in hot environments, where refrigerators tend to shut down and need to be replaced with new thermostats.

The temperature of the surrounding environment is too high, because the refrigerator needs to dissipate heat when it runs, and if the heat dissipation is not good, the temperature will exceed 32 degrees, and it will shut down, and the position needs to be adjusted to ensure that the heat can be dissipated.

During the operation, the temperature in the freezer does not reach the set temperature, it may be that there is a leak in the refrigeration system, or the string air pipe is blocked, or the filter screen is blocked, at this time, you need to check the refrigeration system to ensure that it is normal, and then remove the filter screen to clean, dry it and reinstall it back.

No power is a power socket.

Failures, the second is refrigerator failure, power aging, compressor failure, etc., the cause should be determined first, and then dealt with.

Why did the newly bought empty freezer stop for a while? Because after the freezer is set to the temperature, it will start refrigeration, and when it reaches the set temperature, it will stop running, once the temperature of the freezer is higher than this set temperature, the freezer will start to refrigerate again, so it will stop and play sometimes.

Normal. There is also heat in the air and liner insulation in the freezer. It also needs to be run to lower the temperature. At the same time, the insulation layer does not completely block the entry of external heat into the freezer.

The refrigerator generally reaches a certain level of refrigeration, and the refrigerator will not run again after reaching a certain temperature, so it will be stopped, and then continue to run after a period of time.

Smart control it, mine too, stop for a few minutes and start automatically.

You can find after-sales service, they are responsible for the warranty period.

Hello dear and happy to answer your <>

The reasons for stopping the freezer are as follows: 1. The liquid crack barrier of the refrigerator is mainly manifested as stopping as soon as it starts, and then starts again after cooling for a while, and it will be broken in two or three seconds, and the compressor starter has a problem, resulting in the overheating protector working. When the temperature drops to a certain point, it will restart, but it will jump again.

2. There are two main reasons to consider, one is the failure of the starter, and the other is the failure of the overheating protector. There is also a lack of voltage caused by the voltage, but the current voltage should be no problem, so the main fault point is on the starter and overheating protector, the biggest fault point is the starter, it is recommended that you call the refrigerator after-sales service ** repair. I hope this service can help you, you can click on my head to bury regrets like following me, and if you have any questions in the future, you can consult me again, and look forward to serving you again.

Wishing you well; Happy life, everything goes well [warm] [warm].

1. Refrigerator compressor.

After operation, there will be an imbalance between the high-pressure pressure and the lower pressure in the pipeline, if the power is cut off, the power will be turned on immediately, the compressor will not start under the action of pressure, or the starting current is too large, which will burn the compressor winding and damage the compressor.

2. After the refrigerator has a power outage, wait at least three o'clock before it can be powered on again. This is true not only for refrigerators, but also for air conditioners.

If this happens, you should unplug it immediately, wait for the power to come, and then plug it back in, as long as it is working properly and the refrigeration is normal, then there is no problem.

It doesn't matter much, as long as the call comes, there is no problem to continue working, but it is best to remove the plug and be able to send power after five minutes, and it can't be turned on immediately after the power is cut off.

There was a power outage just one or two hours ago, and it may be because this refrigerator is out of order, so I think it should be possible to explain it to the merchant, and this should be able to ask him to change a refrigerator for you, which should also be possible.

If it's stopped, wait a while and it will be turned on, normal. If it's a power outage, it's fine, it's equivalent to a refrigerator shutdown.

The new fridge had just started up and the power went out in an hour or two. There will be no serious consequences for the refrigerator. Unless it's a repeated power outage. It will cause damage to the refrigerator compressor.

What is the reason why the freezer starts to crack and stops as soon as it stops, dear! 1. The temperature of the refrigerator is set too high, and the internal temperature has reached the orange degree of the temperature set at the high level, so it is not started. 2. There is a possibility that the refrigerator is out of order.

3. Check the external power supply and compressor input voltage, check whether the power supply and compressor input voltage meet the standard requirements (187V to 242V), and use the multimeter AC file external power supply and compressor input voltage to see if it is within this range. 4. The ambient temperature is too low. If the refrigerator is manually compensated, you need to turn on the compensation switch at this time, if the magnetic temperature compensation switch, you need to check whether the magnetic switch is normal, I hope to help you!