Why not go after the Baojun 560 is launched

Hello, for the car, after starting must step on the clutch gear, and then you can go, if you just start the engine, the car will definitely not go, if you don't go after hanging the gear, it may be that the clutch is slipping.

Baojun 560 does not go after the car starts, it is very likely that you are not in gear, step on the accelerator, if you rule out the problem of your own operation, it is very likely that the problem of the gearbox.

In this case, consider the question of whether to operate, is the gear hooked? See if the handbrake is braking?

If the Baojun 560 does not go after starting, it may be that the gear is not in place, or the handbrake is not put to the end.

The first thing to confirm is whether you are in gear, and then see if the handbrake is in place, and the most serious problem is that the clutch is slipping.

Hello, in this case, it may be that there is no gear hanging, and you can try to hang the gear again!

Hello, this first of all, see if it has been put into gear, and whether the handbrake has not been released, basically these problems.

Hello, is your manual transmission or automatic transmission, manual transmission to confirm whether the gear has entered, if you enter and still walk, it is a problem with the clutch.

Hello, check whether the handbrake is loose, whether the gearbox gear is hooked, and then there is the brake system problem.

First of all, you have to look at whether the car is already in the forward gear, if not, it is still hung in the forward gear, and then see if the handbrake is pulled and released.

Hello, it is recommended that you first take a look to see if you have not let go of the handbrake, or to see if there is no gear.

First of all, verify the fault phenomenon of the vehicle, hit the ignition switch to the starting gear, the starter is running normally and running strongly, but the engine can not be driven normally, the preliminary judgment of the starting circuit and the starter is not a problem, observe the car instrument, and find that the engine anti-theft indicator light on the dashboard is on.

A quick scan was carried out with the special fault diagnosis instrument of Wuling Baojun, and it was found that there were two fault codes for the body control module BCM, which were B150129 key authentication failure and B150708 base station communication error. According to the fault code analysis, the B150129 key authentication failure fault code should be the main reason for the engine to not start, and the B150708 base station communication error fault code will be restored to the normal state after the key authentication is passed.

Combined with the fault code and fault phenomenon, it is suspected that the body control module cannot recognize the legitimate key, so as to control the engine ECU to disconnect the ignition and fuel injection, resulting in the engine can not start, and the body control module BCM sends information to the instrument through the CAN network and lights up the anti-theft indication on the instrument.

In order to quickly troubleshoot, the relevant information of Baojun 560 was consulted to understand the working principle of the anti-theft system of the car, as shown in Figure 2. The car engine anti-theft system does not have a keyless entry system (PEPS), is a low-profile vehicle, the car anti-theft system consists of a car key with an anti-theft chip, a control unit of the security anti-theft system, a body control unit (BCM), an engine control unit (ECM), an anti-theft signal receiving antenna and an anti-theft indicator in the car instrument.

From the analysis of the working principle of the anti-theft system, the main reasons for the failure are the failure of the anti-theft chip, the failure of the anti-theft antenna, the failure of the anti-theft module, the failure of the body control unit (BCM), the failure of the engine control unit (ECM) and related circuit failures. The anti-theft chip of the car is located in the key assembly, and the outside is encapsulated by a plastic substance. The anti-theft antenna is mounted on the outer ring of the ignition switch and is responsible for the transmission of signals between the body control unit (BCM) and the anti-theft chip.

The inside of the anti-theft antenna is an excitation coil, the coil generates a magnetic field after being energized, the excitation effective range of the coil is extremely short, only 2 3 cm away, only the car key with the anti-theft chip is inserted into the ignition lock cylinder to carry out chip reading and identification, which excludes the possibility that the information is intercepted or interfered with by other ignition keys (anti-theft chips) nearby. The anti-theft antenna integrates a LIN module.

The body control unit (BCM) transmits information via a LIN cable with the anti-theft antenna. The anti-theft module is the core component of the engine anti-theft system, and the engine control unit (ECM) is mainly responsible for exchanging and verifying information with the body control unit (BCM) to control the fuel system and ignition system. The control circuit of the anti-theft system is shown in Figure 3, and the anti-theft indicator is used to display the engine anti-theft certification, if the anti-theft system fails or the anti-theft authentication fails, the indicator will flash or stay on.

It should be repaired as soon as possible, because the engine cannot be started will affect the normal use of the car, so it should be repaired as soon as possible.

You should drive the car to the 4S shop, seek help from professional and technical staff, do not operate blindly, do not blindly disassemble and wash, usually replace the accessories in time, and do a good job of maintenance.

You should go to a professional car shop for corresponding repairs, so that you can get a particularly good protection, and you will also know what is wrong with a car.

Replace an engine immediately to get a particularly good improvement, and it will also make yourself extra safe while driving.

It may be that the car battery is out of power, it is best to tow the car to the 4S shop and check the battery of the vehicle.

Summary. Hello, the car can not start this situation, is divided into two aspects, the first aspect is that the vehicle starts without any response, then this situation.

1: First of all, you need to check whether it is caused by the loss of battery power? If the battery is out of power, you need to charge the battery or replace it with a new one.

2: In the case of making sure that the battery does not lose power, focus on checking whether the vehicle starter is a problem or whether the anti-theft is locked, 3: If there is a problem with the starter, you need to check the corresponding control circuit of the starter or replace the starter.

4: If there is a problem with the anti-theft system, you need to re-do the anti-theft matching.

The second major aspect is that the vehicle engine can rotate, but does not catch fire, then this situation focuses on checking, 1: whether the gasoline pump oil pressure is insufficient or the vehicle engine is not ignition, 2: if the pump oil pressure is insufficient, this situation needs to replace the gasoline pump.

Check the fuse or wiring of the gasoline pump.

3: If it is not ignited, focus on checking the crankshaft position, sensor and ignition coil.

The reason why Baojun 560 can't catch fire, what to do if Baojun 560 can't catch fire.

Hello, happy to answer your questions.

Your bureau believes that the car can not start this situation, is divided into two aspects, the first is that the vehicle starts without any response, then this situation 1: first of all, you need to check whether the battery loss of Tong Jian wheel electric caused by this phenomenon? If the battery is out of power, you need to charge the battery or replace it with a new one.

2: In the case of making sure that the battery does not lose power, focus on checking whether the vehicle starter is a problem or whether the anti-theft is locked, 3: If there is a problem with the starter, you need to check the corresponding control circuit of the starter or replace the starter.

4: If there is a problem with the anti-theft system, you need to re-do the anti-theft matching. The second major aspect is that the vehicle engine can turn, but it does not catch fire, so this situation is to focus on checking, 1:

Is it that the fuel pressure of the gasoline pump is insufficient or the engine of the vehicle is not ignition, 2: If the pump oil pressure is insufficient, the gasoline pump needs to be replaced in this case. Check the fuse or wiring of the gasoline pump.

3: If the sail is not ignited, focus on checking the crankshaft position, sensor and ignition coil. The above two aspects are the relevant reasons for the vehicle to not start, as well as the solutions, it is recommended to make a relevant reference!

The Baojun 560 does not catch fire, and it is manually transmitted.

Hello, if you can't catch fire, first do the corresponding investigation to see if the battery is out of power or the vehicle is anti-theft.

Engine certification failure is displayed.

The lights are all gone.

Check the battery first, if the battery is bad, it will lead to this failure, if the battery is destroyed to determine that the battery is not a problem, this is a vehicle anti-theft and argument locked, you need to use a special computer to re-do the anti-theft matching.

How to check if the battery is charged.

To check whether there is electricity in the battery, you need to find a special voltmeter to measure the battery, the focus is to measure the discharge voltage of the battery, which can not be lower than ten volts.

1. Whether the steering wheel is in a deadbolt state. The solution is simple, as long as you hit the steering wheel hard and twist the key at the same time, you can generally unlock the steering wheel lock quickly, and the ignition is an instantaneous thing.

2. Did you not return the gear to P gear when you parked? Think about it, if the D or R gear can be ignited, the jump of the vehicle at the moment of ignition is undoubtedly a huge safety hazard. Therefore, for automatic transmission vehicles (AT, CVT, AMT), manufacturers will preset this mode, and repeatedly inform in the manual:

Make sure the gear is in the P position when ignition.

3. One-button start sometimes encounters the trouble of power loss of the smart key, obviously the key is in the car, but the instrument always shows 'key matching error', this situation can be the first trouble, the smart key is power loss, and the starting system can not sense the weak radio waves emitted by the key. Therefore, it is recommended to pick up the smart key and put it on the start button, and then press the button to start.

4. Check whether the battery has electricity. If the ignition is not ignited, it may be due to the loss of power or the expiration of the battery life caused by the long-term headlights have not been turned off, and the battery is generally replaced in time according to the maintenance manual.

5. See if there is oil. If the fuel gauge shows that it has been disturbed below the red line, it will naturally not ignite. At the same time, pay attention to the quality of the oil. There have been car owners who found that there was water and mud in the fuel tank after disassembling the car, and with such oil, it is impossible for the car not to break.

6. No antifreeze is added.

Some car owners add water or inferior antifreeze to the car, resulting in a particularly cold winter, causing the entire waterway to be frozen, the engine to be frozen and cracked, resulting in the car water pump can not operate, can not catch fire, and injure other parts of the engine.

Hello 1Steering Wheel Lockout Steering wheel lockout is a simple anti-theft feature. When the car is turned off, rotate the steering wheel from the back to the right state to one direction at a certain angle, and the steering wheel will be"Click"Lock with a bang.

When the steering wheel is locked, the one-button start function will not work. Solution: Turn the steering wheel left and right slowly, and press the engine start button at the same time to release tension and unlock the steering wheel lock.

Insufficient battery voltage, no power or damage Generally speaking, a 60Ah battery supplies a radio with a voltage of 12V, with a power of about 10 watts, and if you count the standby power of other power supply equipment, the power consumption of the whole car does not exceed 30 watts. Theoretically, the radio is capable of listening continuously for 24 hours.

There are many situations when the car cannot catch fire: one is that the starter can be heard, but the engine cannot start. The other is that after twisting the key, there is no sound.

The first case is when the starter works, but the engine does not. This is complicated by the fact that it can be caused by one of several failures. (1) First of all, it may be a circuit or electronic fault.

The faults of the circuit are: fuse blowing, high-voltage coil breaking, low-voltage circuit breaking, center ignition wire falling off, splitter head leakage, and spark plug damage. Electronic failure mainly refers to the loss of function of the brain control board of the ** hail high brain.

Oil pump failure, oil circuit failure, oil filter blockage, carburetor failure, nozzle damage, etc. Sometimes it happens that the fuel tank is empty and the owner doesn't know it, add a few liters of gasoline and solve all the problems. (3) Finally, it may also be a mechanical failure.

Common mechanical failures are: time band (chain) breakage, cylinder leakage without pressure, etc. The second scenario is when even the starter does not work or works barely.

The first thing that needs to be checked at this time is the battery. In addition to the battery, the reason why the starter does not work can be a damaged ignition switch, a damaged ignition relay, or a damaged starter itself. Also, check the ground line and fuse.

The steering wheel is lockedThe reason for this is that the car is a very basic anti-theft feature. The principle is that through the rotation of the key, a steel pin is controlled by a spring, and when the key is pulled out, as long as the steering wheel rotates, the steel pin will bounce into the hole left in advance, and then jam the steering wheel to ensure that you can't rotate. In the case of a locked steering wheel, the steering wheel will not turn, the key will not be screwed, and the car will not start, so as to achieve anti-theft.

How do I unlock a steering wheel?

It's simpleHit the brakes, hold the steering wheel with your left hand, shake it slightly, and shake your right hand at the same time to unlock it. When you are not proficient, it is possible that you will not unlock it successfully the first time, so you don't need to worry, pull out the key, and follow the above steps to repeat it several times.

If it's a keyless start model, how do you unlock it? In fact, the method is basically similar to having a key, except that the step of inserting the key is missing. Press the brakes, then turn the steering wheel left and right, and finally press the start button to start the car.

How to avoid locking the steering wheel

Locked steering wheels often appear on novice car owners, because after parking and turning off, it is foundThe steering wheel did not return to the center, and then habitually hit back directly with your hands, at which time the steering wheel immediately entered the anti-theft function. SoAfter the ignition is turned off, try not to touch the steering wheel again, and even if you want to return to the right steering wheel, start the engine to operate.