How to cool down the CPU, how to cool the CPU, the master taught me!

Rapid cooling requires an electric fan, open the case cover and blow it directly, the temperature is immediate, but not a long-term solution.

If you want to do it once and for all, it's best not to believe in the so-called cooling software, which is nothing more than frequency reduction, but frequency reduction means that playing games will be stuck, this is a hard injury, and it needs to be solved by hardware, at most install a temperature and fan speed monitoring software like game plus.

Generally, when not playing games, it is normal for the CPU to be below 40 degrees, the graphics card to be below 40 degrees, the hard disk to be around 30 degrees, and the motherboard to be around 30 degrees, and the fan speed varies from individual to individual. If it is a large 3D game, the CPU and graphics card can reach 70 degrees or even higher, the hard disk is around 50 degrees, if the hard disk exceeds 70 degrees, there will be a risk of data loss and hard disk damage.

1: The radiator should be heat piped as much as possible, and the side blowing can blow most of the heat to the rear exhaust vent.

3: Increase the air duct fan in the case, Ma Yun has 30 pieces on the line, and the enhanced flow effect can quickly and effectively remove hot gas to avoid the heat island effect.

4: Check your CPU Thermal Power Consumption (TDP) online and buy a corresponding or higher specification heatsink.

Some users overuse the computer, resulting in the computer CPU temperature is too high and the computer crashes, so the correct use of the computer and cooling the CPU has become a problem for us. So how does the CPU cool down? Actually, the method is very simple.

One: The easiest way is to open the shell of the case and blow it with a fan, which is more practical Second: we can also increase the fan to cool down, because the fan is too small, and the ability to dissipate heat is less.

This is also a more fundamental method three: we can also solve this problem by reducing the CPU frequency.

It is recommended that you replace your CPU fan! You can also take your case! The panel is open in a ventilated place! This is better for heat dissipation!

It helps a little with the cooling base!!

1。Check the CPU occupancy.

2。If the occupancy rate is high in standby mode, please disinfect the virus.

3。In addition, the fever of 5000+ is already high, and it is even worse to catch up with the weak physique, so it is recommended to improve the air duct of the chassis.

4。Do not enable the motherboard BIOS in power-saving mode and overclocking mode.

5。Switching to water cooling (not recommended) is too wasteful of money.

6。Check the heat dissipation of the graphics card, the heat dissipation of the graphics card is large, and the wind blowing by the CPU fan will be higher than the CPU temperature. (In my case), the solution is referred to 3.

7。Look at the contact between the heatsink and the CPU, don't apply too much thermal paste. How much depends on the smoothness of the surface that the heatsink and the CPU are in contact with, the smoother the heat dissipation paste, the less it should be applied, and vice versa.

8。Check the motherboard capacitors for damage.

9。The ultimate method, remove the chassis on both sides as on the windowsill and then open the windows. Note that when it rains, the windows are closed (that's what I did).

Are you satisfied with the above?

Try to ensure that a single task runs and buy a good cooling fan. Don't beat the silicone too thick, it will be counterproductive if you hit too much. What's your CPU?

There is also the case air duct that is also very important.

Apply silicone grease. If necessary, use the air conditioner to induce air ducts to enter.

1. Replace a more powerful radiator, generally good at 150W heat dissipation and above 2. Plan the CPU independent heat dissipation air duct to avoid turbulence, directly introduce cold air, and discharge the hot air in time without any obstruction.

3. Replace the water cooling radiator.

4. Reduce CPU usage (it's not worth sacrificing performance for temperature) 5. Open the covers on both sides of the case and use a fan to blow it, the effect is immediate, and at the same time, adjust the BIOS appropriately to slightly reduce the CPU voltage and frequency, and it is not recommended to use cooling software.

6. Be sure to schedule the dust inside the case, especially the dust on the radiators and fans and case fans such as the CPU, graphics card, north-south bridge, MOS tube (some motherboards have), etc., which is conducive to heat dissipation.

Dust removal first, if this is still the case, consider whether the radiator is a copycat fake.

Yes, if you change to a 50-100 yuan brand product, you must overclock three series.

Generally, as long as you don't overclock, it's no problem to install a 100 quick money heatsink on a 1000 quick money high-heat CPU.

Clean the fan and heatsink, and replace it if it doesn't work.

Remove the radiator and reapply the thermal paste.

If the fan does not work properly, the fan is repaired or replaced with a new fan, and the frequency of the CPU will be automatically reduced when the CPU is idle, thereby reducing the heat generation.

Use Disk Cleanup to clean up the system junk files.

When there is too little thermal grease between the CPU and the heat sink, increase the thermal grease.

Check that the heat vents are clean.

Place the main unit in some places with relatively ventilation points, or place it in an air-conditioned room.

It is recommended to buy a *** cooling bracket to help the computer dissipate heat.

Turn off some useless running programs to lighten the load on the fan.

The CPU is removed and reinstalled, and the fan is not in good contact with the CPU.