The two computers of the telecom are used, there is no routing, and there is no need to go on at the

Install a network card on the desktop and use ICS (Internet Connection Sharing) mode to access the Internet.

To share your Internet connection using Internet connection sharing, the primary computer must have a network adapter configured to connect to the internal network and a network adapter or modem configured to connect to the Internet.

on the main computer.

On your primary computer, follow these steps to share The Internet connection:

Log in to the host as an administrator or owner.

Click Start, and then click Control Panel.

Click Network & Internet Connections.

Click Network Connections.

Right-click the connection you want to use to connect to the Internet. For example, if you're using a modem to connect to the Internet, right-click on the desired connection under dial-up.

Click Properties. Click the Advanced tab.

Under Internet connection sharing, select the Allow other network users to connect through this computer's Internet connection check box.

When sharing a dial-up Internet connection, if your computer is allowed to connect to the Internet automatically, select the Establish a dial-up connection when a computer on my network tries to access the Internet check box.

Click OK. You will receive the following message:

When Internet connection sharing is enabled, your LAN adapter will be set to use an IP address.

Address. The computer may lose from other computers on the network.

Connect. If these computers have static IP addresses, you should set them to:

Automatically get an IP address. Do want to enable the Internet

Is the connection shared?

Click Yes. The connection to the Internet is shared with other computers on a local area network (LAN). The network adapter connected to the LAN is configured to have a static IP address and subnet mask.

Yes, you can use the computer then, connect the network cable that came out of the cat to the computer, and then dial up

Buy a router with multiple excuses, smaller than the one in an Internet café, and one that can plug in two computers, and you will know it when you ask about it.

The route is not set well, check the instructions to set it, and secondly, the network card IP is not set well.

Follow the installation instructions of the router step by step. That's it.

691 wrong words.

It should be in arrears.

Ask him if he's changed his password.

Hello, this is possible, you need a router branch to two computers, through the router to achieve Internet access!

1. Telecom ADSL broadband, only one device dial-up Internet, if you want to make two or more computers access the Internet, you need to buy a wireless router for signal transmission (WiFi).

Second, the broadband cat is connected to the wireless router, and it is set up like this:

1. Plug in the wireless router, don't connect the cat first, and connect the computer to any LAN port of the wireless router;

2. Enter the gateway address of the router (on the label behind the router) in the address bar of the browser, and enter the login username and password to enter the settings page;

3. Set up according to PPPoE (ADSL virtual dialing) mode, enter the Internet account and password;

4. Set the SSID, encryption method and password;

5. Save and restart;

6. After setting, connect the network cable from the cat LAN port to the WAN port of the wireless router.

Buy a wireless network card for each of the two computers in the distance (if you don't have one) and use the wireless network card to connect to your home's wireless router.

Does your wireless router not have a LAN port? Generally, wireless routers for home use have 4 LAN ports, and the two desktops at home can be connected to the LAN ports with network cables. If your wireless router does not have a LAN port, you can buy 2 wireless network cards, and of course, you can also buy a wireless router with a LAN port.

j. To solve the long-distance problem, the only way to solve the problem is to add a switch on the road.

It is possible to use wireless APs, and we can also connect between the two buildings that are about 100 meters apart.

Set the IP address of each device on the router.

Buy a switch, the telecom cat has a road function, the network port is not enough and you don't need a router, the switch can be.

Local differences, I am also telecom, 3 mobile phones, 2 computers, can access the Internet at the same time, no problem, Chongqing.

First of all, you have to go to the router interface to set it up, and then you can use it.

What is the SSID number of your wireless router?

The situation of the landlord often happens, try to restore the router to factory settings, and set it again.

Pay attention to the setting of the ssid, do not set it to Chinese, the name is not set to be very long, without special symbols, simple point.

In addition, under the change of encryption method, change to other encryption methods, change passwords, etc.

There may also be a problem with the phone system, you try to set it up and troubleshoot it.

First of all, confirm, do you mean that you can't find wifi, or do you mean that you can't find it, but you can't connect. Or did you search for it, connect it, and can't it be online?

If there is a limit, the number of people is generally limited by the cat or wifi sent by telecommunications. There will be no restrictions on buying cats or wifi outside. You need to configure the settings to access the wireless router.

1. Connect the WAN port of the wireless router and the LAN port of the cat or wifi sent by the telecom with a network cable;

2. Log in to the wireless router, set the connection mode to "dynamic IP", and modify the IP address of the wireless router, for example, with the original telecom cat or wifi IP (generally not the same.) Once set, there will be no such restriction when saved;

3. The wifi name and wifi password of the wireless router are set normally.

Install the router router clone the MAC address and both of them can surf the Internet at the same time.

No cats. Telecom's broadband cat or fiber optic cat wants to have two laptops with N multi-socket in the back, and the mobile phone only has a wireless router.

You can install and use a wireless router to connect multiple devices to the Internet at the same time through the router, you can connect wired or wireless connection, please connect the device as shown below:

Refer to the router instructions, enter the router settings page, start from the setup wizard, follow the prompts to set up the router, and restart it after the setup is completed.

So why don't you buy a wireless router? In this way, the desktop can access the Internet, as well as wireless wifi, and the laptop and your mobile phone can also access the Internet.

Your computer's MAC address is bound to the Internet, your home is not the official telecommunications right, it may be renting a fiber optic network, like an Internet café, each person is only assigned you a line and an Internet login software. In this case, you can't get it, unless, you can ask them to provide a static IP address, you can buy a router, you can get it, but people won't pay attention to you in order to make money.

, use the U-port on the left to test that both items are undamaged.