-
The hole is not straight, there is a bend in it, buy a special refrigerator dredge to pass it. It is of soft steel wire.
-
Poke down from the drain hole, there are ice cubes, and it will not poke the refrigerator.
-
The solution to the blocked outlet of the refrigerator is as follows: 1. If it is dirty, you can find a longer ** line and tick a section. Poke it until it doesn't move, and you can determine what the blockage is.
The solution is to cut off the power and wait for the ice to melt before dredging. If it is required to be thoroughly cleared, it is necessary to open the backplate and throw away the insulation layer, so that the blockage can be removed. 2. Check the lower drain pipe and find the leakage.
There are also refrigerators with a drainage rod at one end of the drainage hole, and the purpose of draining can be achieved by repeatedly agitating and pulling the drainage rod. Then it's just a matter of doing the daily maintenance work.
You can dredge it with a thin wire or a hard wire, and if that doesn't work, buy a suction ball and a 50 cm long pipe. Disconnect the power supply, open the back cover, and locate the water box and drain spout. Use a suction ball to absorb and flush so that there is a water pressure to clear the blockage of the drain hole.
It's also a blockage, so if it's frozen, just clean the ice. If the drainage hole is blocked, you can also use a pump with a small pipe to put pressure on the inside and forcibly press through the drainage pipe, which can also achieve the purpose of cleaning. The cold condensate generated in the cold room flows through the drain hole to the water tray on the compressor, and the compressor generates heat to evaporate the water when it is working.
The drain hole can drain the water in the refrigerator in time to prevent the freezer room from freezing, which will affect the refrigeration effect.
-
It depends on what is blocked, if it is an ice blockage, it is a quality problem of the refrigerator, and it will be blocked if it is passed, and it will be blocked, looking for after-sales;
If there is a foreign object falling in, find a steel wire that is not hard or soft, the structure of the drainage pipe is similar to that on the **, the foreign body should be stuck in the arc, don't use too much force to break the drainage pipe;
If you still can't figure it out, look for after-sales service.
-
The fridge drain hole is blocked! It doesn't make sense to pick things up! What to do! I'm going to show you a way to do it.
-
1.The solution is to use adhesive tape for temporary repairs: you can use some tape that is more water-resistant than a bucket ruler, attach the tape to the edge of the drain opening, and press the air thickness to make it fit well, thereby slowing down the flow of water.
2.Contact the after-sales service center: If your stool refrigerator is still under warranty, you can contact the manufacturer's after-sales service center to repair or replace the damaged drain opening.
3.Have a professional technician fix it: If you're not sure how to fix it, or if you're still having problems after using the tape repair method, contact a professional technician to repair your fridge.
Please note that if your refrigerator drain is damaged, it needs to be addressed promptly so as not to affect the normal operation of your refrigerator and cause more serious problems.
1. First of all, use pliers to remove the foreign matter in the drainage hole. If the drain hole is blocked by debris, you need to hook the sewer mouth (generally located at the lowest part of the sewer) with a wire, and then pull it up hard to make the debris fall off. >>>More
It can be dredged by using a general network cable to pass into the sewer hole.
1. When food residues enter the refrigerator and the leakage hole of the refrigerator is blocked, we need to cut off the power supply of the refrigerator when cleaning. >>>More
It is recommended that you can pull out the drain pipe to clean the drain hole directly, or you can contact the refrigerator maintenance personnel for repair.
1. Disconnect the power supply of the refrigerator, then open the door of the refrigerator and let it stand for a while to let the ice in the drain melt as soon as possible. 2. Find a pump to pump up your bike. Insert the air hose of the pump into the drain hole of the refrigerator, and then pump up the air to let the drain pipe of the refrigerator penetrate. >>>More