Why does the face of the electric stove sometimes light it twice before it can be lit?

The gas stove is not good to ignite must be lit twice, first of all, it depends on whether the gas stove you use is equipped with a battery or not, the ignition mode of the gas stove with the battery is pulse ignition, and the ignition mode of the gas stove without a battery is the ignition of the pressed ceramic, and the two ignition methods are different and the problems are different.

First, the battery pulse ignition gas stove is not good, and the reason is the solution.

1.Installing the battery pulse ignition twice before it can be ignited may be caused by insufficient battery power, insufficient power ignition spark is weak, it will cause a difficult ignition phenomenon, the solution can be to replace two No. 1 batteries.

2.The damper is not adjusted well, the damper is not adjusted well, the fire hole of the inner ring can not be completely ignited, if it is just the ignition of the air hole does not gas, it is easy to cause ignition is not good ignition, the solution, there are two damper paddles at the bottom of the gas stove, the damper paddle can be adjusted left and right, the left damper is adjusted to adjust the center fire, the right side of the adjustment of the outer ring fire, like this case to adjust the left damper can be.

3.Some gas stoves are equipped with flame-out protection safety devices, this kind of stove needs to press the knob for three to five seconds after ignition before you can let go, and it will be extinguished immediately when you let go.

Second, the reason why the gas stove that does not install the battery pressing ceramic ignition method is not good ignition is the treatment method.

1.The distance between the needle position at the bottom of the gas stove is wrong, and the ignition needle should be about 3 mm to 5 mm away from the ignition nozzle, too tight, too far, the solution, adjust the distance of the ignition needle.

2.The ignition assembly nozzle at the bottom of the gas stove is not at the right height, and the solution is to adjust the height up or down until the ignition is good.

That's probably the flint and steel gone. Find someone who understands to help him.

Observe whether the spark when the gas stove is lit is soft and weak, and the discharge frequency is significantly slower than before. If this is the case, it means that our battery is running low, and replacing it with a new battery will solve the problem. The ignition needle is a white porcelain needle, and it is also very troublesome to replace the ignition needle, first of all, the gas stove is disassembled, the panel and the bottom shell are separated, and then the stove head of the gas stove is removed, and then the ignition needle can be removed, and then replaced with a new ignition needle.

Broken skin leads to poor insulation and sparks from the metal next to it. The high-voltage line needs to be replaced!

<> the battery is insufficient to cause the ignition to become weak, the spark is against the stove in the middle of the ignition process, and the gas stove comes out to ignite it, this process is normal, if the spark is under it, the ignition clock may be broken, pay attention to replacement, first check whether the gas valve is open, even if the battery is insufficient, even if the battery is replaced, the aging of the spark parts or the blockage of the combustion hole in the stove will directly affect the ignition effect! This reason may be that the high-voltage line is aging, resulting in a large contact with the discharge needle, and then the spark will overflow from the junction of the electricity and the needle and discharge in other places, resulting in low ignition efficiency.

Stove fire