Why does the phone keep showing that it is getting an IP address when it connects to wifi?

1.Router issues.

The easiest solution is to plug in the power port of the router and let the router restartMultiple devices are connected at the same time.

There are a lot of devices connected to the router, and the router connection limit is exceeded, which causes even if the router is connected, there is an IP conflict, and you cannot access the Internet, or you cannot connect to WiFi.

4.Wireless network card.

Fault. Some mobile phone wireless network cards have been eliminated or seriously aged, which will cause poor wifi signal reception.

5.The first thing to make sure is the wifi**, I'm a home wireless router.

With one and two notebooks. 2. Open Start-Connect to Wi-Fi on your laptop.

Click "Support" in the Wi-Fi status screen to find your IP address.

Wait. 6.Settings-Wireless and Network-WiFi Settings-Left Button of the Next Three Pieces (I don't know what to name)-Advanced can see the IP settings, just refer to the input of the notebook according to the prompts, Note:

The last set of digits of the IP address cannot be the same as that of a desktop or laptop. In this way, the problem is solved.

Generally, the Wi-Fi signal is not good or the DHCP service is not enabled, and the IP and DNS cannot be automatically assigned to the mobile phone, resulting in the mobile phone always showing that it is getting the IP address, but the IP address cannot be obtained.

Because the WiFi routing environment limits the number of users accessing at the same time and affecting the network speed, the number of users accessing at the same time is limited, and the IP address range is set in the router DHCP. Therefore, it is possible that the people around you can access the network normally, and at this time, the IP address has just been allocated, so you can't get the IP address, and you can't use the WiFi network.

Solution: Go to the system settings --- wireless and network --- wifi settings--- menu keys--- advanced --- check "Use static IP" in the IP settings below

2.The easiest way: cancel the wifi save and re-establish the connection; Restart your phone or router.

3.Press the router's factory reset button and reconfigure the router settings. After success, the router will automatically assign an IP address to the phone, if it still doesn't work, please try a few more times.

4.If the above methods still cannot connect to the wifi smoothly. You can try the following workarounds.

When the wifi we connect shows that the password is incorrect, the words "authentication problem" will appear, at this time, we have to press and hold the network connection, modify the network, and try to enter the correct password again.

5.We can set a fixed IP address for the phone - a static IP. It is to press and hold the name of the wifi network and select "Modify Network" in the pop-up page column.

Then click on "IP Settings", the default is "DHCP", now we change it to "Static". Restart your phone and router, still doesn't work, replace it with another router to try.

Solution: 1. First of all, let's take a look at the problem phenomenon of side liquid oak, as shown in the figure, when I connect to the designated wifi, I know the password next to the cloud, click on the connection to enter the password, it will display: "Authentication", that is, password verification.

2. After the password is correct, it is to obtain the IP address, and many times it is stuck here for a long time and cannot get the IP address.

3. The final acquisition failed, and it displayed: "Save", which proves that you have saved this wifi for next use.

4. Press and hold the SSID name of the wifi, pop up the menu, and select: "Modify Network".

5. Click the hook to select "Show advanced burial options", which is slightly different according to the brand and model of the mobile phone.

6. In the IP settings, the default is DHCP to obtain the IP address, which is now changed to static.

7. Enter a fixed IP address, or use it more often.

8. After the above are entered, I found that the save button is gray, I can't save it, enter the password again in the wifi password column, and the save button is not gray, and then you can go to reconnect and try it.

9. If the IP address is set correctly, you can connect to WiFi.

Because many wifi router can have limited users at the same time, otherwise too many users can access at the same time will cause the router to get stuck. Therefore, the IP address range is set in the router DHCP, as shown in the figure, only 10 users are allowed to be accessed at the same time, and it happens that the IP address is used up, and you can't get the IP address and connect to the wifi. <>

Hello dear, glad to answer for you! Here's the answer: just set it up.

Method 1Go to the mobile phone system settings--- wireless and network--- wifi settings--- menu key--- advanced --- check "Use static IP" in the IP settings below2Under Use a static IP address, set the following parameters

It is divided into three types, see the computer in detail) domain name 1: generally consistent with the above gateway address, directly Internet access must be modified to the network gateway address) domain name 2: do not fill in (fill in special circumstances) 3

Save! After that, you will find that your wifi will automatically reconnect after being disconnected, and then you don't have to restart the route, and you won't always see the "getting IP address" prompt.

Have you ever encountered such a problem? When I connected to the wifi with my mobile phone, I found that the WLAN kept scanning, but the network password of the WLAN was correct, but the network kept showing "getting the IP address", and I couldn't connect. Below, some workarounds will be introduced.

Operation method 01 The wifi password is entered correctly, but it keeps showing "getting IP address", and it can't be connected. As shown in the figure below, 02 On the WLAN settings page, click Advanced Settings at the bottom of the page. 03 In the advanced settings, check "Use static IP for key gripping", as shown in the figure.

04 Click "Open Network and Sharing Center" in the lower right corner of the brain, and then click "Local Connection" to enter the general information interface of local connection. 05 Then find "Details" on that page as shown in the image. 06 After clicking on the details, the page shown in the figure below will appear, and find the IP, gateway, and fill in the gateway and DNS correspondence on the computer into the mobile phone, but the IP address should be changed, only the last digit of the manuscript celebration digit will be changed, and the last digit can be changed between 1-255.

As shown in the figure below, the corresponding computer and mobile phone: 08 After setting up according to the above steps, connect to wifi from the mobile phone, and you can connect, as shown in the following figure

Summary. Hello, glad to answer for you

First of all, we click on the settings icon on the desktop of the mobile phone to enter the settings interface.

Then tap on the WLAN option inside.

Then click the button behind the WLAN inside to turn on the wireless function.

Then click on the wireless network where the IP address is being obtained to enter the configuration interface.

Then click on the button behind the static IP inside to turn it on.

Then manually enter the IP address and DNS in it, through the fixed address, you can surf the Internet normally, save the settings, and you can connect.

In addition, you can enter the router management interface, through the management of users, increase the number of people who use wireless at the same time, and you can also let us surf the Internet normally, and will not always prompt that you are getting IP, you can connect to the wifi network.

What should I do if my phone is connected to wifi and it prompts that it is getting an IP address all the time.

Hello dear, <>

You need to wait patiently for about three minutes, and the answer will be revealed for you immediately, so don't worry!

Hello, I'm glad to answer for you First of all, we click on the settings icon on the desktop of the mobile phone, enter the settings interface, then click on the WLAN option inside, and then click on the button behind WLAN inside, turn on the wireless function, and then click on the wireless network that is obtaining IP, enter the configuration interface, and then click the button behind the static IP inside, turn it on, and then manually enter the IP address and DNS inside, through the fixed address, you can surf the Internet normally, save the settings, You can connect to the router management interface, through the management of users, increase the number of people who use wireless at the same time, you can also let us surf the Internet normally, will not always prompt that you are getting IP, you can connect to the wifi network I hope it can help you!

1.Open Settings and tap Network.

Turn on the Wi-Fi.

Click Network to enter the configuration interface.

Enable the Static IP Address button.

5. Enter the information manually and save it.