What can elementary school students make in eco friendly handicrafts? 20

Homemade flashlight.

The specific method of making it is to remove one end of the lid of a waste can (such as a Lulu beverage can) and knock the other end with a round hammer. Roll up two No. 1 batteries with thick corrugated cardboard and put them into the tank with the positive electrode facing up and the negative electrode facing down.

Find a suitable plastic lid (such as a magic big roll lid that can be fastened to Lulu cans) and dig a small circular hole in the lid** in such a size that the bulb is plugged in tightly. Insert the base of the bulb into the small hole. Take a piece of wire hunt and peel off the wire skin at both ends, wrap one end around the lamp base, and pierce a small hole through the side of the plastic cover with the other end.

Place the plastic lid over the can. Check that the bulb and battery are in close contact. At this point, the disposable flashlight is ready.

When using, use your thumb to press the wire threaded from the side wall on the weld that is not painted from the can, the flashlight will glow, and the thumb will jump off the wire, and the flashlight will go out, which is very convenient to use.

Eco-friendly small bucket (pen holder):

Materials: one red and one white plastic bag and one paper cup.

Steps: Cut two straps from the white plastic bag, at least five cm wide, from the middle. Twist them into strings and finally knot them together to form a rope.

Remember to tie a knot first, twist the two ropes and tie a knot, otherwise the rope will not succeed. When the rope is finished, glue it with clear glue. Twist a rope from a red bag, tie it into a bow and stick it to it, and you're done (if you have time, you can draw on the cup).

I've done it, it shouldn't be difficult... You try it.

You can make a pen holder out of a useless soap box, make a big snowman out of paid newspaper paper, and make a big hole in it to put in useless items.

Some of the above can be used to give it a try.

Have you used it ?

Use waste cloth to make eco-friendly shopping bags.

Waste paper can be folded into boxes.

The primary school is low-carbon and environmentally friendly, which is not only environmentally friendly, but also very delicate and practical.

Use beverage bottle caps and waste pen barrels to make environmentally friendly small handicrafts, simple and good-looking, let's do environmentally friendly small handicrafts.

01 Prepare six bottle caps, a waste pen barrel, a green colored pencil, a bottle of white latex, a piece of paper, and a pair of scissors.

02 Glue two caps on both sides of the barrel as two petals of a flower.

03 Glue the smallest cap to the top of the pen as the center of the flower, and then glue the other three caps to the top of the center as the other three petals.

04 Draw two leaves on the paper with a green colored pen, paint them green, cut off the leaves with scissors, glue the two leaves to the barrel with white latex, and a beautiful little flower is made.

Eco-friendly handmade practices, old jeans and tape paper tubes handmade jewelry storage box steps are as follows:

Material tools: tape paper tubes, old jeans, cardboard, super glue, brushes or dukes, scissors, pencils.

1. Put the tape paper tube on the cardboard, draw two outer circles and two inner circles, and cut them out. <>2. According to the size of the outer circle and the inner circle, the disc is also cut out on the denim, and the margin should be enlarged by 1cm. Then, according to the height of the tape tube, enlarge it by 2cm and cut out 2 rectangular denim pieces.

3. Attach the round denim to the round cardboard, and then wrap the rectangular denim on the inside and outside of the tape paper tube.

4. Cut out the gap along the extra denim, and then glue and paste.

5. Paste the bottom of the box and the body of the box together. Lay flat on the table, press on the heavy shirt and leave the book overnight.

6. Finally, stick a button in the middle of the lid, and this beautiful round storage box is complete.

The steps to make a simple piggy bank for potato chip buckets are as follows:

1. Prepare the potato chip bucket, of course, you have to clean it inside, otherwise there will be oil and debris.

2. Paste colored paper of your favorite color on the outside of the potato chip bucket.

3. Make a hole in the middle of the lid of the potato chip bucket.

4. Cut out a long, slender hole that can be used to put coins.

5. Wrap a circle of ribbon near the mouth of the potato chip bucket as a decoration, and then cover the lid to fix it, and a piggy bank is completed.

Eco-friendly handmade production method:

1. Prepare paper tube cores, glue sticks, colored pencils, scissors and colored paper.

2. Use scissors to cut a long strip from the colored paper.

3. Wrap the long strip of chalk paper under the core of the paper tube as the body of a small butterfly.

4. Use a black pen to draw the butterfly's eyes on the top of the paper tube core, and use a red pen to draw a broken line to indicate the mouth.

5. In this way, the environmentally friendly handmade butterfly is completed.

Manual refers to the mass production of non-machine equipment but manual production. At the dawn of industrialization, the term manual became synonymous with low productivity and uneven quality. However, in the era of highly developed industrial production in the modern era, people gradually got tired of the undifferentiated and distinctive products produced by the factory assembly line, and handmade products were revitalized.

Tools Raw materials.

Old t-shirts (preferably without large patterns or letters).

Scissors sewing machine.

Pin elastic band (m).

Step 1: Make the bottom of the t-shirt.

1. Cut the elastic band that matches the size of your chest.

2. Turn out the inside of the T-shirt and cut a small piece of the welt at the bottom.

3. Fix the bottom of the elastic band with a pin, and insert a heading pin into the small cut opening.

4. Thread the elastic band around along the welt and sew the ends together to turn the front of the T-shirt out.

Step 2: Make the upper part of the T-shirt.

1.Hold the cloth in place with some pins and cut off the excess so that it will look flat at the top of the t-shirt at the end, making sure you lose the excess collar.

2.Pin the sleeves of the T-shirt to the front of the garment with some pins and sew the notches in the collar with a sewing machine.

3.Turn the inside of the t-shirt out, sew the sleeves near the opening of the t-shirt, and turn the front of the t-shirt out.

4.Cut two small openings out of the welt of one sleeve, and when folded over, the cut should be at the bottom of the sleeve.

5.Cut a section of elastic that is shorter than the width of the cuffs, and with the help of pins, thread the elastic through the welt of the sleeve and sew it through the bottom end of the elastic. (The other sleeve is made in the same way).

6.Finally, the sleeves are sewn onto the T-shirt, and the outer pockets are placed at the bottom of the skirt, or you can make them into an inside pocket if you like. Such a beautiful bandeau dress is made, energy saving and environmental protection!

If you are environmentally friendly and handmade, you can make a shopping bag, make a shopping bag, it is very simple.

When it comes to eco-friendly handmade, the first material to make must be. Environmental protection, for example, use environmentally friendly paper to make environmental protection manuals, then you must promote some environmental protection. benefits, such as sorting garbage.

If you make it by hand, you can make a vase from a waste bottle, which is good. It is not only environmentally friendly but also can be used as a vase.

Of course, the environmentally friendly handicraft still has to make some corn stalks, or corn leaves, and we have corn leaves in the northeast.

The booklet must promote some environmental benefits, such as sorting garbage. If you're in there, you're doing something with eco-friendly paper or leaves or whatever. As some small gifts, or yes, actually. It's better to use something.

Elementary school students can do paper-cutting, origami, tearing paper, mud, Chinese cut, woodworking and tumbler handicraft, among which the tumbler is made as follows:

Materials: table tennis balls, rubber balls, white latex, rags or shredded colored paper, plasticine.

The production process is as follows:

1. Open a hole with a diameter of 3 cm at the top of the rubber ball, and load about one-third of the plasticine equivalent to the bottom of the ball from the hole to the bottom of the ball as the body of the tumbler;

2. Use white latex to glue the table tennis ball to the small round hole of the rubber ball as the head of the tumbler;

3. Use a cloth corner or colored paper to cut out the facial features and limbs of the tumbler and stick them on the head and body respectively.