-
Anonymous users2024-02-11It may be that there is a problem with the power management program, it is recommended to update or reinstall the driver, the driver of the Dell computer is recommended to go to the official website of Dell for the driver**, the address is as follows, please install **according to your computer model and system.
If this is still the case, it is recommended that you go to the more regular Dell Chinese mainland maintenance service outlets to overhaul and see, not the professional's misoperation is likely to damage the computer, the nearest Dell Chinese mainland maintenance service outlets can be found on the following ** web page.
-
Anonymous users2024-02-10It may be that the power adapter is in bad contact, try it again!
-
Anonymous users2024-02-09It is recommended to update the driver, if it is good, it will be fine. If you don't have a trumpet, you need to reset the signal. The problem is not very big.
-
Anonymous users2024-02-08You can turn it on first and then connect the charger.
-
Anonymous users2024-02-07Why does the Dell laptop not turn on the charger when it is unplugged, and it can be turned on when plugged in, and the screen power display is fully charged, ask God for advice.
Hello dear, this one is because the laptop battery is broken. Because, if the battery is broken, it will not store electricity. Therefore, it can only be used if the core is connected to alternating current.
As soon as the alternating current is unplugged, the computer will be disconnected and then shut down. The solution is to change the mountain trail and replace it with a new laptop battery. Of course, there is another reason, which is caused by poor contact between your battery and the laptop.
-
Anonymous users2024-02-06OneAbout the above thisDell computer charging shows that the power supply is connected and not charging?
To solve the above problem, first check whether the power adapter is normal.
Check the inside of the entire data cable on the power adapter for problems such as poor contact.
Check the charging cable plug and the Dell computer charging port to see if there is any poor contact between the two.
Check if the battery inside the battery is normal(If necessary, it is best to ask a professional master to test the battery).
After the above thorough inspection,For example,If it's normal, it's still not good, then this situation may be,The charging control circuit on the motherboard has a hardware failure.
-
Anonymous users2024-02-051.Laptops may not charge after a power supply is exhausted, and the laptop is shut down or otherwise abnormally shut down. 2.
At this time, restart the computer first to try if it is okay, if it doesn't work, turn it off, and then turn the laptop over. 3.Take the battery out, and when the battery comes down, set it aside and wait 10 minutes.
4.Then put the battery up, and the installation process is to press it first. Restart your computer again.
5.Then turn on the power of the laptop and you will find that the power supply shows that the battery is charging. 6.
If it still can't be charged, send it to a repair shop for treatment.
-
Anonymous users2024-02-04Hello! This should be the current battery is sufficient, not low to the charging threshold, it is recommended that you use the battery alone, when the power is lower than a certain level and then connect to the power supply.
-
Anonymous users2024-02-03All steel is the battery of the laptop is fully charged, in order to protect the battery, at this time directly use the charger to power the computer The battery will not be charged.
-
Anonymous users2024-02-02Contact the problem, try to plug it in a lot, and it should be fine.
Dear Lenovo users, hello:
It is recommended that you try to update your power management driver, and please try to release static electricity. >>>More
1. Activate the new battery.
When a new laptop battery is first turned on, the battery itself should have more than 70 charges (this is also a common practice for manufacturers). If you open the laptop you bought for the first time and find that the battery is fully charged or more than 70% charged, it means that the manufacturer has done a factory test). At this time, you should fully charge the battery, the charging time must be more than 12 hours, and then set the battery to turn off when the battery is 5% power, and repeat it three times, so that the battery can be completely activated, which can effectively improve the service life of the battery. >>>More
1. First of all, unplug the battery and use the adapter directly to see if the adapter is easy to use. 2. Use battery calibration to see if it solves your problem. 3. You can use a battery testing tool to test whether there is a problem with your battery. >>>More
1. After flashing, due to the change of most of the content of the system, there is a situation similar to the inability to read SD. It can be reverted to the official system to solve the problem. http://63351335 >>>More
This is the first thing to check whether the battery and the notebook are in good contact, if the contact is not good, although you can read the communication data of the battery, you can not charge the battery, at this time you can take out the battery and test the machine more, insert the battery into the computer If you hear a beep, you can think that the contact has been good, try a few more times, you can rule out the problem of poor contact between the computer and the battery, especially when using IBM computers, pay attention to this problem. If it is confirmed that the contact between the battery and the computer is good, but the battery still cannot work normally, then it is possible that the battery itself has a quality problem, and the possibility of the problem is twofold: first, the circuit board of the battery is damaged or has been short-circuited protection; Second, the battery produced by the company may not match the computer you use, incompatible, please correct the battery, or you can come like this, you put you and the battery to someone else's book to try it, to see if this is the case, there will be more relevant information about the use and maintenance of the battery Jimo, I hope mine can help you.