How do you make the bathroom floor level and drain effectively? What s the solution?

Nowadays, most of the toilets are sunken before handing over the house. Therefore, before paving the ground tiles, the construction of the ground waterproofing project is carried out first, and then the corresponding raw materials need to be backfilled(Some use carbon slag, but also effective other materials to make backfill), and deal with the flatness of the foundation cushion. Selection of wall tiles.

The wall tiles of the bathroom must be selected with good quality, and the surface should be leveled, and there is no edge, seven arches and eight warped arches. At the same time, the water absorption capacity of the glaze layer should be tested.

The key link is to have a dedicated and conscientious construction management personnel and operators, which is also very important to maintain the flatness of the toilet. The flatness of the bathroom is not the flatness of ability, but there must be an inclination, that is, the inclination of adding water. Only with the inclination of the water can the water inside be quickly drained and kept clean.

Therefore, the on-site operation staff of brick laying, on the basis of the foundation cushion, need to do a good job of adding water before laying bricks, and then begin to maintain the end of the project construction according to this inclination. The inclination of the bathroom floor tiles is all mastered by experienced masters, <>

Generally, the pavement should be 1% and 3% of the slope slope to prevent odor floor drain (the lowest place); The pavement of the toilet should be no less than 3 cm lower than the indoor floor. The tilt will affect the assembly of sanitary ware such as toilets, and the tilt will not be effective for the drainage pipe. The most essential factor of water storage in the shower room is that the ground is uneven and its water can not be released, because the water flows to a low place, so the drainage hole or the area of the anti-odor floor drain must be if the lowest place in the shower room, the area that avoids the odor-proof floor drain can be slightly higher, and then the floor drain of the drainage pipe is reduced to its relative height, so that the water can be easily discharged from the field, and it is not easy to lead to the situation of water storage.

If the road surface is particularly uneven, and the distance between the odor-proof floor drain is also very far away, you can consider finding a minimum value in this uneven area and installing an odor-proof floor drain, so that the water can be discharged as soon as possible, and it is not easy to cause water seepage. You can draw a small groove on the floor tile, make the depth of this groove a little lower, and lead the water to a low direction, so that the stored water can be discharged to the odor-proof floor drain according to the drainage method of this groove.

I think it's best not to do this, because most bathrooms will do some slopes in the process of renovation, so that they are also for better drainage, and these slopes are not felt in our daily life, it is just a slight slope, which will not affect our normal life.

In the process of bathroom decoration, the floor level and drainage of the bathroom are very critical, and only by doing these two things can the bathroom be used better.

Fault treatment can be carried out, and now the vast majority of bathrooms are sunken before delivery. Therefore, before laying the floor tiles, the waterproof layer construction should be carried out first, and then the corresponding materials should be used to backfill (some use carbon slag, and some use other materials as backfills) to deal with the flatness of the cushion. By doing so, the bathroom floor will be flat and easier to drain.

The ground can be planned to ensure the leveling of the ground. You can bury some pipes next to it, you can also increase the slope of the bathroom, adjust the slope, you can also adjust the pipes of the bathroom, and you can also open some slots.

The floor of the restroom can be tilted, and some ditches can be set up so that rapid drainage can be achieved. The slope of the toilet can be increased, some channels can be set up, the area of the drain can also be expanded, and some drainage grooves can be set up.

You can install several more drains. Increase moisture and water protection measures. Tiles do not choose too large.

First of all, when making the ground, you should use a spirit level to make an angle, so that the ground not only looks flat, but also easy to drain.

Professional decoration team, professional staff, plan in advance, choose the furniture you want, choose your favorite materials.

Be sure to pay attention to the use interval during the watering process, as this will make full use of the heat of the hot water to thaw the frozen pipes without reducing the life of the sewer pipes. In addition, all alkaline substances (basic oxides + alkaline hydroxides) + active metals (metals reflected with water: sodium-potassium-calcium-barium) + concentrated sulfuric acid - concentrated nitric acid + nitrogen dioxide - sulfur trioxide - phosphorus pentoxide - phosphorus trioxide will encounter water after heating.

It is possible to generate heat in this way and then dredge it, but only if you know what the sewer pipe is and find out the alkaline substances that will not react with it before you can use this method. In the cold winter, turn on the faucet a little at night to let the small flow of water continue to flow, which can achieve a good anti-freezing effect and can effectively prevent the water pipe from freezing.

<>Of course, the amount of water should not be too large, otherwise it will be a waste of water. If the frozen part of the pipe is long, or even inaccessible underground, it can only be handled by the maintenance personnel of the property department. Generally, they will have a good thawing method, and after the pipeline is dredged, they will also take reasonable and effective anti-freezing and thermal insulation measures to prevent the water pipe from freezing here.

Clever setup. When we decorate the bathroom, the ground of the bathroom must have a slope, but this slope, do not let others see that it is a slope, in its lower part near the 1 point of the floor drain, the drainage is not high so that the bathroom is flooded, and there must be a correct choice when choosing its floor drain, you can choose the floor drain well, or you can make the drainage poor.

There is a sink on the ground. Now the decoration is particularly novel, a sink in the bathroom, it can form a convex groove in the middle on both sides, so that the position of the floor drain is in the groove, so that it will naturally lead out of the groove, for such a design the drainage speed is much faster than the tile, and its water will not appear, now renting a house is such a design. Drain on all sides.

There are two ways to make a toilet drainage design on all sides, one is to make a groove on the marble, Dali ordered to let the workers make a groove after the water is cut off around, and there is to use tiles in the middle to leave the bedding around him, free design is the best effect that can bring the water out. The design of the surrounding water allows the water to flow faster, and will not affect our lives due to the stagnant water environment, so our home will not be wet.

Effective wet and dry separation will definitely drain better than a bathroom without wet and dry separation.

When doing dry and wet separation, in addition to making a partition in the longitudinal space, it is also necessary to pay attention to the use of water retaining strips on the ground - water retaining strips, which can prevent water from running around on the ground.

The floor of the bathroom must be level, and the flatter the better. First of all, when laying floor tiles, you have to find professional workers, I have seen the owner of his own construction, the ground is potholes, and it is called a strange thing if there is no water accumulation. The greater the slope of the ground, the faster the water flows to the floor drain, and the faster it can be discharged.

The slope of the ground is 2% to 3% commonly, and the maximum may be 5%. If the slope is too large, it will affect the normal standing of people on the ground (there will be a significant sense of inclination when standing on the ground) - if there are elderly people and children, it is easy to be dangerous.

At this time, you should pay attention to the slope design of the bathroom, you can choose a centimeter of slope, to determine the direction of the sewer in advance, to choose the best floor drain, you can make a groove in the bathroom room, in the early stage of decoration should pay attention to the laying of water and electricity pipelines, to ensure the smooth flow of the sewer.

What are the requirements for using the bathroom? The toilet is an important place for family members to carry out personal hygiene work, and it is a specific environment with the dual functions of defecation and cleaning, with strong practicability and high utilization, and every inch of area should be used reasonably and skillfully. Sometimes, some cleaning and sanitation tasks in the home are also included, such as the placement of washing machines, washing basins (consider cleaning dirt), storage of cleaning tools, etc.

2. What are the basic principles of bathroom design? (l) The design of the toilet should comprehensively consider the use of the three functions of cleaning, bathroom and toilet. (2) The decoration design of the toilet should not affect the lighting and ventilation effect of the bathroom, and the selection and setting of wires and electrical equipment should comply with the provisions of the electrical safety regulations.

3) The ground should be made of waterproof, dirt-resistant, non-slip floor tiles, granite and other materials. (4) The wall is directly made of smooth and elegant tiles, and the ceiling should be hung with plastic plates, glass and translucent plates, and can also be decorated with waterproof coatings. (5) The bathroom utensils in the bathroom should have hot and cold water faucets.

Bathtubs or showers should be separated by movable partitions. (6) The floor of the toilet should be inclined to the drain. (7) The selection of sanitary ware should be coordinated with the overall arrangement.

3、。The floor decoration of the bathroom should meet the requirements of four aspects: first, it should have good waterproofness; second, to have good drainage; Third, it should have good slip resistance; Fourth, it should be neat and beautiful.