Where is the Peugeot 508 automatic transmission oil filler

The Peugeot 5008 transmission oil filler is under the engine compartment and above the transmission housing. The length, width and height of the Peugeot 5008 body are 4670mm, 1855mm and 1650mm respectively, and the wheelbase is 2840mm.

Generally, the position of manual transmission oil replacement is on the upper and lower bolts in the automobile gearbox housing, the upper bolt is the oil filling hole, and the bottom bolt is the oil drain hole. The automatic transmission has two bolts, one large and one small, on the bottom shell of the automobile transmission, the large bolt is the oil drain, and the small bolt is the fuel filler.

The position of the oil filler of the Peugeot 5008 gearbox can be drained by unscrewing the bottom oil drain screw, but due to the internal structure of the gearbox, the old oil is often not clean, and the oil change rate of this method is relatively low, but the automatic transmission is more recommended to use an oil change machine, and the oil change machine can be injected into the gearbox while injecting new oil and silver into the gearbox, while pumping out the new and old mixed oil, until the oil in Sun Bohui's gearbox becomes clear.

This method needs to consume more new oil, the consumption is twice as much as the manual one, generally about 12 liters, but the oil change rate is very high, the old oil can be basically drained clean, and the performance of the new oil can be guaranteed.

Photo by Q&A) @2019

Summary. Dear, this question is up to me, it takes a little time to type, please be patient, thank you!

Dear, this question is up to me, it takes a little time to type, please be patient, thank you!

Like this model, the front rubber is equipped with a 6-speed Huihui side AT gearbox, so if you change the transmission oil later, you only need to choose a 6-speed ATF. Personally, I recommend that you choose ZF's ZFJK6 model, like this model, if you use the gravity method to replace, you only need to use Bidram.

Then ask if the second change of transmission oil gravity change is not the same brand.

Is this model the second time right?

This can be used, the brand is different, but the model is the same, no problem.

There is no clean oil in it, so there is no problem mixing it with this new oil, right?

That's fine.

Okay, thank you, master.

You're welcome, if you find it helpful, please give a thumbs up, thank you!

Automatic transmission oil needs to be changed every two years or every 40,000 kilometers driven.

In the environment of high temperature and high friction, the lubrication performance, heat dissipation, bridge energy, cleanability and other properties of transmission oil will continue to deteriorate with the time of work. At the same time, the acidity and alkalinity of the variable tank oil also changes. Therefore, when the gearbox has been used for a certain period of time, the transmission oil needs to be replaced.

The gravity oil change method can be used to change the automatic transmission oil

Gravity oil change is generally to remove the oil bottom slippery orange shell after the car is lifted, and the oil drain screw is unscrewed, and the old oil will be released. Due to the internal structure of the gearbox, this oil change method can only release 60% of the old oil, and the old oil will remain in the gearbox, and after filling the new oil, it will cause secondary pollution of the new oil. The disadvantage of this oil change method is that it is not thorough, and the amount of old oil residue is large, resulting in secondary pollution of new oil.

The advantage is that the new oil filling is small, which is more economical.