Whether the house decoration is the first to paste wallpaper or lay floor tiles, after reading what

First of all, the ideal order is to first floor, then wallpaper, and then baseboards. Because, when the floor is laid and cut, the dust is relatively large, and it is easy to stain the wallpaper. The baseboard is behind because the baseboard can press down the wallpaper, so you don't have to worry about the wallpaper warping.

In the process of decoration, the general baseboard and the floor are almost at the same time, and many workers are unwilling to come to the door twice, and the time and road expenses are costs. So if you meet a good worker, you can follow the steps above. If this is not possible, it should be considered according to the actual situation.

Depending on the type of wallpaper, if the wallpaper is difficult to clean, such as pure paper wallpaper, it is recommended to install the floor first and then paste the wallpaper. When laying the wallpaper, pay attention to check whether the edges of the wallpaper are firm to ensure that there will be no warping. Also, be sure to protect the floor from glue and the like.

If you paste the wallpaper first, it is best to take certain protective measures for the wallpaper when laying the floor, so as not to get too much dust and it is difficult to clean. When installing the baseboard, the lower edge of the wallpaper is pressed against the edge of the corner line, so that it is not easy to roll up.

Therefore, you need to choose the installation method according to the actual situation. Hope the above is helpful to you.

Paste the wallpaper first, then the floor, and the baseline, so that you can just press the edge of the wallpaper.

When decorating, it should be the first to paste the first tile can be such a problem, maybe for many people, they do not consider it in their daily life. However, if it comes to the situation that your home needs to be renovated, you may not know for a while whether you should choose the bricks on the wall or the bricks on the ground. But in daily life, in fact, there is no certain rule for such a mutual order, in fact, it is okay.

Start from the bottom and stick it upAnd many people will choose to paste wall tiles first, because when they choose to paste wall tiles, they can start from the bottom layer first. And if you stick the bricks on the floor after pasting, the difficulty of the whole construction is relatively small. And for the quality of this tile, its hollow drum rate will be smaller, so in this case, everyone will also choose the brick on the wall first.

In addition, some tiles that stick to the floor may also have some disadvantages, that is, its waterproof effect is likely to be a little worse.

The waterproof effect is at its best, if there are more gaps left or there are some inappropriate situations in the process of filling, it may be easy for the tiles on the floor to form some leaks with some temperature changes. It may also lead to some defects in the whole decoration process, in addition, many people have better space to play when they paste floor tiles, and this method also has many advantages, which can make the waterproof effect reach the best state.

Nowadays, many people decorate with wall tiles first, and doing so will shorten their time, and then it is more convenient to take care of.

Of course, these floor tiles, because if you put wall tiles first, the gaps left may not be enough to stick to the floor tiles, and there is a high probability that there will be large gaps, which will cause additional problems in the future.

When decorating, it must be better to stick the floor tiles first, because it may be more convenient to lay the wall tiles after laying the floor tiles, and if the wall tiles are laid first, it may cause the ground to be uneven.

It is better to paste the wall tiles first, because it is very convenient to paste the wall tiles and then paste the floor tiles, if you paste the floor tiles and then paste the wall tiles, it is very difficult to take care of, and there is a lot of garbage, which will damage the floor tiles.

Paste the wall tiles first, because if you stick the floor tiles first, and then paste the wall tiles, the cement used to stick the floor tiles may not be completely solidified, which will break the floor tiles and stain the floor tiles.

I think it's better to stick the wall tiles first. Because if the floor tiles are pasted first and then the wall tiles, it will cause some damage to the floor tiles, and it will also make the floor tiles very dirty.

In fact, there is not much difference between the two, but generally everyone paves the floor tiles first, which is easier to operate and more convenient.

Wall tiles should be applied first. Because we put the floor tiles first, it will be easy for us to stain and damage the floor when laying wall tiles.

Stick the wall tiles first. Because it is more convenient in this way, and it is likely that some materials or concrete will fall when tiling, it is also easier to deal with.

Stick the floor tiles first, so that you can have a good judgment on the distance of the ground, if you stick the wall tiles first, the scale may not be very accurate when you stick the floor tiles on the ground.

The wall tiles should be pasted first, and after the wall tiles are pasted, some sundries on the floor can be cleaned up, and then the floor tiles should be pasted, which is more convenient.

There are many processes in the decoration that must be constructed in order, otherwise there will be problems if the installation is wrong. For example, most people don't know what is the right order to stick wall tiles or floor tiles first, and they often ignore it, and they know that they are miserable when something goes wrong.

After all the tiles are laid, the carpenters do the modeling, and then the walls are painted.

Stick the wall tiles first or the floor tiles first, this is what everyone usually calls the wall pressing the ground or the ground pressing the wall. In the past, there was this emphasis on tiling, because the gap retention method was different. Nowadays, the process has changed with each passing day, so the past set should be eliminated.

So whether the wall presses the ground or the ground presses the wall, it depends on the experience of the workers you are looking for. In fact, it is okay for workers to get used to any kind of practice, and it has nothing to do with quality gaps.

Approximate sequence of construction:

Hydropower transformation, this part is the hidden project in the basic decoration, we must choose a good product, because hydropower is the most important thing we need in our daily life!

Secondary waterproofing, many owners have asked me, the developer has done waterproofing before, do you still have to do it when decorating? I tell you to do it! And the closed water test must be done for more than 24 hours! Because waterproofing is really important, leaking water is troublesome!

Bricklayer construction, is to lay bricks, the details of the bricklayer is very important, such as floor drain, before laying bricks must be sealed, to prevent blockage, as well as chamfering parts, we must still pay attention!

The carpentry ceiling is the gypsum board ceiling in the dining room and living room, which can be before or after the bricklayer, depending on the process connection!

Wall construction, is to brush the wall, wall construction attention is ground protection, wall construction ends, basic decoration construction part ends, down is the start of custom installation!

If wooden floors are laid, then the order is to paint the walls first, and then to lay the wooden floors before the furniture comes in.

If the tile is laid first, the floor tiles are laid, and then the tile floor is protected, and then the wall construction is carried out, which must be paid attention to, because many of them do not have tile floor protection in the construction, and the ground cleaning is very troublesome in the later stage, which must be remembered!

Therefore, the decoration is generally to paste the bricks first and then paint the walls.

Because materials such as cement mortar will be used for tiling, accidentally splashing on the wall during the construction process will cause the situation of reconstruction.

Precautions for laying floor tiles are:

1. Ensure that the bottom is level to avoid some uneven places in the future, and then you can use cement mortar to pave the road. Kitchens and bathrooms are also in the future should tend to drain properly.

2. After making the floor of the room rougher, it is necessary to brush the cement slurry again, and the drainage slope should also be controlled according to the corresponding slope pull line.

3. When there are no scratches on the surface of the veneer, such as missing corners, expired and agglomerated cement cannot be used.

4. The tile should be immersed in water first, not only the angle should be correct, but the interface should also be correct. Once the floor tiles are laid, they need to be covered with cardboard and at least a day before they can be walked around.

5. Before laying the floor tiles, pull a crosshair on the transverse and longitudinal directions, and at the same time ensure that it will not penetrate when paving horizontally, and do not allow sewing.

For most home decoration, it is to paste the floor tiles first and then brush the wall putty, so the construction sequence is also the order of the construction of the hydropower tile wood and oil type in the decoration, the bricklayer enters the construction in front of the oilman, so the floor tile paving will be completed first. There are certain advantages to this order, which are as follows:

It will not destroy the wall putty: for the first floor tile, the wall is often in a blank state, and there is no putty on the wall, so even if there is cement mortar on the wall when the floor tiles are pasted, there is no effect, and only need to be removed in the later stage, and the finished wall will not be damaged;

It will not affect the entire construction period: for the first floor tiles, the floor tiles can have a good natural drying and curing process after being paved, and there is no need to worry about the floor tiles not drying thoroughly and need temporary construction, which will affect the entire construction period. By sticking the floor tiles first and then brushing the wall in the construction sequence, the construction period of the entire decoration can be guaranteed to be completed within a reasonable construction time, and the entire construction period will not be affected;

It will not destroy the finished decoration: for the first floor tiles, the whole decoration is still in the early stage of brickwork, and the decoration only does the preliminary construction of water and electricity, and does not do a good job of finished decoration, so when the floor tiles are pasted, they will not worry about affecting part of the finished decoration because of moisture;

It can meet various construction sequences: for the decoration masters, they all hope that their events will be completed at one time, not to run back and forth for two constructions, and the first paving of floor tiles is a good way to meet this requirement, so that the overall decoration construction sequence can be completed at one time for each type of construction.

Can meet the decoration company's team stage acceptance: for the decoration company will achieve a phased acceptance link, then the first floor tile can be used to complete the construction of the bricklayer part at one time, to achieve the acceptance of the bricklayer part, after the acceptance of the carpentry construction link, in line with the phased construction management of the decoration.

Precautions for brushing the wall after the first floor tiles: for the first paving of floor tiles and then brushing the wall, wait until the floor tile paving is completed, to carry out acceptance, if there is an unsuitable part to immediately rectify, and after the rectification is completed, the special protective film for floor tiles should be used to protect the integrity of the floor tiles, so as to ensure that the floor tiles will not be destroyed in the decoration process, and the thickness of the protective film used must meet the standard. If there is no floor tile protection film, you can also use cheap gypsum board instead of protection, which can also meet the standard of floor tile protection.

When it comes to interior decoration, in general, we will paint the walls first, and then lay the floor tiles. This order is based on several reasons. First of all, if the floor tiles are laid first and then painted, there may be paint drips on the newly laid floor tiles, which will require additional work to clean up, increasing the workload.

Secondly, it takes some time for the wall to dry after painting, and during this time, if the floor tiles are laid, it may have an impact on the drying of the wall.

With the decoration device, you only need to enter the area + city, and calculate the most affordable local market in 3 seconds**: [Tuba Rabbit Big Platform Counts**].

No longer worry about the company's price increase, omission and price increase.

In the local market, the ** wall painting ** is generally between 30-60 yuan per square meter, and the specific ** will vary according to the brand and type of paint selected. The ** of floor tiles is between 50-200 yuan per square meter, and it will also vary because of the quality, brand and specifications of the bricks.

When it comes to renovation, it is recommended that you first consult with a professional renovation company, who will provide you with the most suitable renovation plan according to your specific needs and budget. At the same time, it is also necessary to pay attention to the selection of environmentally friendly materials in the decoration process as much as possible to ensure the health of the family's living environment. After painting and laying floor tiles, there is also a need for enough time to allow them to dry and dissipate odors so as not to cause adverse effects on the body.

Kunming - [Kunming Decoration Strategy Guide].

Suzhou - [Suzhou Decoration Strategy Guide].

Hefei - [Hefei Decoration Strategy Guide].

Fuzhou - [Fuzhou Decoration Strategy Guide].

Beijing - [Beijing Decoration Strategy Guide].

Dalian - [Dalian Decoration Strategy Book].

Hangzhou - [Hangzhou Decoration Strategy Guide].

Shanghai - [Shanghai Decoration Strategy Guide].

Tianjin——[Tianjin Decoration Strategy Guide].

Paint the wall again. Because when tiling cement mortar.

If you accidentally get it on the wall that has been painted, it is basically difficult to remove, and if you have brushed the latex paint.

If you accidentally drop it on a brick, it will be easier to clean up. For the paving of floor tiles, you must pay attention to soak the bricks in water first, because there are many tiny gaps inside the bricks, and the water absorption is strong. If there is no soaking water, it is easy to absorb the moisture in the cement mortar after paving, resulting in a gap between the brick and the cement, resulting in hollowing.

Abscission. In addition, we must pay attention to leveling, and first pave the ground with mortar, which can effectively reduce hollowing.

1.Different sequences have different advantages and disadvantages in the home improvement process. Lay the tiled floor tiles first.

The advantage of repainting the wall is that it can better protect the wall, and if the shielding of the ground is in place, it can also protect the ground from damage and pollution. However, this method takes a long time and requires waiting for the floor to be fully completed and secured. The advantage of painting the walls first and then laying the floor tiles is that it takes less time than the former.

After painting the wall, you can wait for the wall to dry completely before directly laying the floor decoration materials.

2.During this period, it is also necessary to shade the ground to prevent the dust generated during the decoration process from falling on the ground, which brings difficulties to the cleaning work in the later stage; However, if the wall decoration is carried out first, and then the floor tiles are laid, the man-hours required are relatively short, and the floor can be laid after the wall is dry. But you need to be careful not to touch the newly painted wall so as not to damage the wall.

3.Before decorating the house, it is necessary to wire the water and electricity in the home as a whole, and at the same time do a good job of the waterproofing system in the home, especially the kitchen and bathroom. There are also many finishing materials to choose from. Combined with the overall decoration style of the home.

and economic budget, choose the right decoration materials. The above is the answer to the question of whether to paint the wall or paste the floor tiles first when decorating.