What is the sequence of operations to properly start the car?

Correct steps: 1. After getting into the car, adjust the seat to suit you, and then fasten your seat belt.

2. Start the car, then press the clutch with your left foot and hang up the first gear.

3. Turn the left turn signal and honk the horn to signal.

4. Step on the accelerator with your right foot, slowly lift the clutch with your left foot, stabilize the steering wheel with your left hand, and hold the front end of the manual brake with your right hand; Wait to hear the throttle sound by"Expensive"Shift to"Calm", quickly lower the hand brake.

Precautions: The car must be started correctly in order to achieve a relatively smooth start, so the steps and skills of the correct starting operation are required, and three key points must be followed.

Look, it is to go around the car, mainly to see the appearance and environment of the car, to see if there are obstacles in front of the car and behind the car, whether there are suspicious oil or water stains on the ground in the parking position, whether the front and rear lamp assemblies are damaged, and whether the tire pressure is enough.

Check is to know whether the engine oil and cooling water are sufficient, and whether the front and rear lights, signal lights and instruments are working properly, mainly to check the technical status of the car. Lift the hood, pull out the dipstick to see if the oil height position is normal, and unscrew the water tank cover to see if the water level is normal, because the oil and cooling water belong to the engine"Life Shield"If they have problems, the engine is prone to problems, and it is necessary to check the condition of the oil and water frequently.

Don't forget to take a look at the coolant and brake fluids, most of which are transparent and visible at a glance. Then, turn the ignition key to the open position to see if the dashboard gauges and indicators are displayed properly. Turn on and off the small lights, headlights, meeting lights, fog lights, turn signals, fault lights, reverse gear lights and brake lights, etc., especially pay attention to turn signals and brake lights, regardless of day and night, these two kinds of signal lights are the most related to driving safety, and they must be kept in good condition at all times.

Start, that is, in the first two are normal to turn the ignition key to start the engine, each start time should not exceed ten seconds, here pay attention to the cold start, the throttle should be gentle and gradual, do not start immediately increase the throttle to increase the engine speed, because the crankshaft speed rises instantaneously during the cold start, the oil is too late to deliver to the bearing position, easy to cause bearing damage. After the engine starts, pay close attention to the changes in oil pressure, water temperature, charging gauge or gauge light, and when the gauge meets the normal value or the gauge light goes out, you can start the car in gear.

Manual transmission car start sequence.

1. The clutch is fully stepped on.

After starting the car, the clutch is fully depressed with the left foot, which is ready for the semi-clutch state.

2. The gear is hung to the first gear.

Push with the palm of your right hand and put the gear lever gear into 1st gear as the starting gear.

3. Turn left signal.

With your left hand, gently press down on the turn signal lever and turn on the left turn signal to indicate the front and rear of the car.

4. Honk the horn to remind.

Press the horn button in the middle of the steering wheel to alert the pedestrians in front of the vehicle and prepare to start.

5. Release the handbrake.

Press the button in front of the handbrake with your right hand, then lift the handbrake to completely press down the handbrake and release the handbrake.

6. Lift the clutch lightly with your left foot.

The left foot is slowly lifted up until the clutch is in a semi-clutch state, according to the different sensing points of the clutch, the semi-clutch height is different, generally raised between 30-45 degrees, the vehicle begins to vibrate slightly, which means that the vehicle power is enough.

7. The vehicle starts to start.

At this time, it should be noted that the clutch of the left foot should be stabilized, and there can be no pressure or lifting operation, avoid turning off the ignition, and slowly release the clutch after 3 seconds of stability, and at the same time, the front foot of the right foot lightly steps on the accelerator, and the vehicle completes the start smoothly.

The correct order to start the car: turn on the switch, start the engine, and press the clutch.

Before getting into the car, make sure that there are no obstacles or people around the vehicle, adjust the seat and fasten the seat belt after getting into the car. Insert the key into the ignition lock, turn on the ignition switch, start the engine, if the instrument is not working properly, the engine should be turned off immediately, check and eliminate the fault before starting the engine again.

Then press the clutch pedal and hook the gear lever into 1st gear; Lift the clutch lightly, slowly lift the left foot up until the clutch is in a semi-clutch state, according to the different induction points of the clutch, the half-clutch height is different, generally raised between 30-45 degrees, the vehicle begins to vibrate slightly, which means that the vehicle has enough power to start.

Precautions for driving

1. Novices should fasten their seat belts before going on the road, and then familiarize themselves with the accelerator and brake position, and don't mistake the accelerator as a brake. Familiarize yourself with the usual traffic rules before driving.

2. Slow down when crossing the intersection, look left and right, develop the habit of looking left and right and slowing down when crossing the intersection, observe the situation of vehicles on the cross lane, and confirm that no car is passing.

3. When turning and decelerating, you should see clearly, whether it is in the suburbs of the city, you should pass slowly when you are driving, you should develop the habit of decelerating and decelerating, observe non-motorized lanes and sidewalks, and take the initiative to avoid battery cars and sidewalks on non-motorized lanes. When you turn right in the city, you should politely give way to passers-by and the battery car, confirm that there will be no accidents, and then pass slowly.

The correct order to start the car: 1. Turn the key to the ON position; 2.

Press the foot brake and pull the gear from P to N; 3.Release the foot brake, turn the ignition key to the ignition gear, and start the engine; 4.Press the foot brake, release the handbrake, and pull the gear from N to D; 5.

Slowly release the foot brake, add some gas, and start the car forward.

Before getting into the vehicle, make sure there are no obstacles or people around the vehicle. Once in the car, adjust your seat and fasten your seatbelt. Correct starting sequence for manual transmission:

1.Insert the key into the ignition lock, turn on the ignition switch, and start the engine. If any instrument is not working properly, turn off the engine immediately and restart it after checking and troubleshooting.

2.Press the clutch pedal and hang the gear lever in 1st gear; 3.Gently lift the clutch and slowly lift your left foot upwards until the clutch is in a half-clutch position.

According to the clutch sensing point of the clutch, the height of the half-clutch is also different. Generally, the position between 30-45 degrees is raised, and the vehicle begins to vibrate slightly, indicating that the vehicle has enough power to start.

Millions of car purchase subsidies.

The correct order to start the car is to turn the key to the ON position, step on the foot brake, pull the gear from P to N, release the foot brake, turn the ignition key to the ignition gear to start the engine, step on the foot brake, release the handbrake, pull the gear from N to D, slowly release the foot brake, add some fuel to start the car and go forward.

The working principle of the car gear is rotten sail: the car gear mainly applies the principle of gear transmission speed reduction, there are multiple groups of gear pairs with different transmission ratios in the gearbox, and the gear shift behavior when the car is driving is to work the different gear pairs in the gearbox through the control mechanism, and the gear pair with a large transmission ratio works at low speed, and the gear pair with a small transmission ratio works at high speed.

The correct sequence for automatic transmission vehicles to start the vehicle: press the one-button start button by pressing the brake, start the engine, step on the brake to engage the gear, and release the handbrake. Manual transmission vehicles start the vehicle in the correct order:

Insert the key into the key slot, press the clutch and turn the key to the ignition switch, step on the clutch gear, and put down the handbrake.

Precautions for starting the vehicle: to get on the car to prepare, generally you need to go around the car before getting on the car, and then go to the car after confirming that there are no problems. Then check that there are obstacles in front of the car and behind the car; Check if the tire pressure is normal; Check whether the dashboard and indicator display are normal; Check if the oil level is sufficient; Adjust the position of the seat dregs; wear a seatbelt; adjust the rearview mirrors; Check whether the engine is abnormally noisy; Turn left and honk your horn.

The correct starting sequence of an automatic transmission car:

1. Turn the ignition key to the second grid, to the power gear, and let the town finger noise car computer system start self-test for at least 6 seconds;

2. Press the foot brake and pull the gear from P gear to N gear;

3. Release the foot brake, turn the ignition key to the ignition gear to start the engine;

4. Step on the foot brake, release the handbrake, and pull the gear from N gear to D gear;

5. Slowly release the foot brake and start.

Correct starting sequence for a manual transmission car:

1. Insert the key into the ignition lock, turn on the ignition switch, observe whether the instruments are working normally, and start the engine. If the instrument is not working properly, the engine should be turned off immediately, and the engine can be restarted after checking the side-by-side cover to remove the fault;

2. Step on the clutch pedal and hang the gear lever into the 1st gear position;

3. Turn on the left turn signal, honk the horn, and observe the front, left and right, above and rearview mirrors of the vehicle at the same time to see if there is any obstacle to starting;

4. Release the handbrake and hold the steering wheel steadily;

5. Gently lift the clutch, slowly lift the left foot up until the clutch is in a semi-clutch state, according to the different induction points of the clutch, the semi-clutch height is different, generally raised between 30-45 degrees, the vehicle begins to vibrate slightly, which means that the vehicle has enough power to start.

Millions of car purchase subsidies.

Steps to start the car correctly: 1. After getting into the car, adjust the seat to suit you, and then fasten your seat belt. 2. Start the car, then press the clutch with your left foot and hang up the first gear.

3. Turn the left turn signal and honk the horn to signal. 4. Step on the accelerator with your right foot, slowly lift the clutch with your left foot, stabilize the steering wheel with your left hand, and hold the front end of the manual brake with your right hand; Wait to hear the throttle sound by"Expensive"Shift to"Calm", quickly lower the hand brake.

After the engine starts and runs normally, after confirming that there is no obstacle around the car and has all the conditions for the car to start, press the clutch pedal to the end with your left foot to completely disengage the clutch. If the clutch pedal is not pressed to the end, the clutch can not be completely separated, and the power output of the engine is semi-linked with the transmission.

Put the transmission shift lever into gear, and if the first shift is not smooth, pull the shift lever back into neutral and then make a second shift until it is successfully completed. The gear shift action is required to be accurate and fast, and the position of each gear of the transmission must be clearly identified to prevent unnecessary losses caused by hanging the wrong gear.

Before the car starts, be sure to observe the surrounding conditions to further determine whether it is safe. The front of the car can be observed from the front window, which is clear at a glance, and the side and rear of the car can be observed through the rearview mirror, or the window glass can be lowered to stick your head out of the window.

After the car starts smoothly, the left foot should be moved down from the clutch pedal, so that the clutch pedal is completely relaxed, do not idle the foot on the clutch pedal, because the left foot sometimes involuntarily slightly downward force, it is easy to cause the clutch semi-linkage, in the long run, quickly wear out the clutch friction plate. (Photo by Zeng Caihong).

1. Check the surroundings of the vehicle before getting on the bus to confirm that there are no small animals or children around, or whether there are iron nails, glass and other items that hinder the safety of the car. The first thing you do when you get inside the car is to fasten your seatbelt.

2. The brake on the left and the accelerator on the right, this order must be remembered. Start by pressing the brake pedal on the left before starting the car.

3. Insert the car key and rotate the key clockwise while stepping on the brake, then you will hear the sound of the car engine starting.

4. Put down the handbrake again.

5. Keep the brake on the state and pull the gear from the stop position [P] to the forward gear [D]. (The other gears are almost not used except for the reverse gear [r].)

6. Release the brake, lightly press the accelerator pedal on the right side, slowly refuel, start the car, and always pay attention to the surrounding car conditions, you can drive on the road without any situation.