In winter, when the temperature is more than ten degrees below zero, can you still lay the floor?

No, the reason why the national standard stipulates that the temperature of indoor tiles is not less than 5 is to avoidcement mortarIn the process of pasting tiles, the moisture in the cement mortar freezes after the temperature is lower than zero, resulting in the volume increase of the cement mortar in the absence of dry solidification, and when the temperature rises above zero, the ice in the cement mortar melts into water, resulting in the shrinkage of the volume of the cement mortar, and the curing strength of the blending material will be reduced and the bonding effectiveness will be reduced in the process of volume increase and decrease.

It depends on the actual temperature, if the temperature is higher than 5 degrees, the harm is not great; If it is more than 5 degrees or even less than 0 degrees, then it must not be pasted, otherwise the temperature will rise next year and the tiles will be hollow.

Arching, resulting in repair, due to small loss of big. The first hazard winter paving tiles.

The element is that the temperature in the room is too low, and in some cases, there is a sub-zero situation. If the temperature is too low, there will be two kinds of bad hazards: the first hazard is to cause the cement mortar and other materials to pave the floor tiles in the winter is not very good, the temperature is low, the solidification speed of cement mortar is relatively slow, and it is very easy to produce hollow drum conditions, if the brick joints are small, the thermal expansion coefficient of ceramic tiles.

If the heat rises and shrinks, it will arch when the temperature is high in summer.

The requirements for paving tiles are actually very high, relative to the hollow walls and floor tiles.

Hollow drums are less difficult to maintain, so try not to be too cold when laying floor tiles. Before the tile is solidified, do not walk on the wall tile and trample the tile paving to carry out the project acceptance, and check whether there is a problem of hollowing. Everything is normal, and just the seams are basically not a problem!

Our home is a winter sticker! Nowadays there is no problem with tiling in the rooms in the southern region.

Places with warm winter weather are not affected, such as Guangdong, Guangxi, and Hainan provinces. In winter, the area with low temperature is minimized, because the temperature rises and shrinks in summer, and the higher the temperature in summer, the easier it is to arch. Similarly, in order to better ensure that the temperature difference between tiles is too large, you can add some antifreeze to the raw materials.

When mixing cement mortar, the temperature of the water should not exceed 80.

This is also a common problem of tile paving in winter, in advance to prepare the interior decoration of the tile to freeze and keep warm, generally moved to the room to make its temperature to the indoor temperature. At the same time, the tiles must be soaked in sufficient water to prevent the original dry temperature and add new processing technology of ceramic tile paving, because the whole process does not use all the cement mortar, there is nothing to worry about, due to the thorough selection of foot pedal installation, the adhesive of the tiles, there is no strict management of the temperature, the only thing that must be considered is the cold of the tiles.

I don't think it is possible to lay the floor in this case, because it is not conducive to the firmness of the floor tiles. There are also some other issues that may arise. There may even be icing.

It is not allowed to lay the floor, because the temperature of the indoor floor should not be lower than 5, so that it can be well adhered to.

In this case, the floor cannot be laid, because the weather is too cold, which will cause the floor to freeze, which is not conducive to the durability of the floor.

OK. Wooden floors can be laid in winter. It's just that the wooden floor is a little different from the summer and the winter. Due to the physical factors of thermal expansion and cold contraction, the wooden floor is easy to burn and deform, and even obvious cracks will appear.

Therefore, the room temperature of the wooden floor should not be lower than 10 in winter. And in winter, it is necessary to increase the indoor relative humidity (60-70%), which can avoid the quality problems of the paved wooden floor due to the influence of the climate.

Precautions before paving the floor:

1. Ground standard: the ground should be dry and flat, there should be no sanding phenomenon, if the ground sand is serious, it should be covered with a layer of cement filial piety slurry to fix the sand particles under the ground under the premise of a flat ground, and it is best that the ground is self-leveling, with a height difference of 5mm within 2 meters.

2. Door stone standard: bathroom, kitchen, balcony (room with water often) door stone can block water and moisture, and its height should be consistent with the thickness of the wooden floor after paving as much as possible (please consult the sales consultant for details of the reserved height of the door stone).

3. Wall paint standard: it must be scraped downward, and the wall is painted 5cm from the ground, which can avoid exposing the cement wall when installing the foot line.

4. Door and door cover: It should be installed before paving the floor, because the baseboard and the door strip are installed close to the door cover, and the edge of the floor should be under the door cover.

5. Lamp: It is also best to install it in advance, and there are ladders and holes falling on the ground when installing the lamp, which is easy to cause floor wear.

In winter, the outdoor temperature is close to 0, and the northern region is even lower than 0, and the temperature difference between indoor and outdoor is very large. After the floor is transported to the pavement site by long-distance transportation, it should not be opened and paved immediately, because the floor temperature is low at this time, and the indoor temperature is relatively high, and the floor will be condensed when the package is opened, which is easy to cause deformation. The whole package should be "raised" for a few days to allow the floor to adapt to the surrounding environment before opening the package.

Moreover, the moisture-proof film must be in place, the ground moisture-proof film must be thickened and laid, isolated from the floor, and often ventilated and dehumidified, and the floor must be maintained.

In winter, you can lay wooden floors, but you should keep the ground dry and flat, so as not to absorb water and bulge in the future, it is best not to enter the room for 24 hours after paving, open doors and windows to let it ventilate freely to adapt to the temperature and humidity of the home, but before laying must leave enough expansion joints to allow it to expand and contract freely.

Yes, but it is necessary to pay attention to the dry air in winter, when workers pave wooden floors, expansion joints of about 2 mm are essential, otherwise it is easy to bulge and suspend in the future. If you encounter heating leakage, water accumulation on the wooden floor, etc., you must dry it in time, and do not let it be directly exposed to the sun or baked with an electric stove, so as not to dry too quickly and crack the floor. To prevent deformation, the floors on both sides of the wall can be disassembled and reinstalled after the moisture has dissipated.

Hello, of course, wooden floors can be laid in winter.

Wood flooring is divided into paint-free and non-paint-free types.

For the paint-free type, because the finished paint board is used, as long as the gap of thermal expansion and cold contraction is considered. The specific approach is to appropriately increase the indoor temperature, turn on the air conditioner or use heating or use small sun lamps to create an artificial small environment, and control the indoor temperature at about 14 degrees, which is equivalent to the average annual temperature.

For non-paint-free wood floors, the temperature should be maintained during paving and painting processes, so that the floor gap and the dryness of the paint can be effectively controlled.

Hello friends. We do wood floor installation. By the winter we were busy. How can it not be pretended?