What glue is used to repair the vacuum tire, and how to repair the vacuum tire?

Fire repair glue and quick-drying glue can be used.

When using, pay attention to the sizing to achieve a thin layer and uniformity, the product is stored in a cool and ventilated place with dark packaging and avoid direct light, and the product should be stored in a cool and dry place to avoid sunlight or ultraviolet rays.

Light contact, seal the bottle after use. Unopened original product, under 25 conditions, the storage time can be up to more than eight months, this product does not contain any pathogenic substances, if it accidentally causes temporary redness after contact with ** during use, it should be washed with soap.

First the tires must be removed from the rims.

Disassemble and disassemble and then decide whether it can be repaired after being inspected by a professional tire dealer. Michelin.

It is recommended that the tire cannot be repaired in the following cases:

1. The sidewall cannot be repaired.

2. If the diameter of the hole penetrated by the crown exceeds 6 mm, it cannot be repaired.

3. If the bead is damaged or deformed, the tread is deformed, the rubber is corroded by chemicals or the tire is damaged by air failure.

4. Other abnormal conditions cannot be repaired. For example, if there are traces of airless driving on the tires (e.g. crushing marks on the sidewall, blistering of the inner liners, etc.), it is not worth repairing because the tire structure may have been damaged and can no longer be used.

In addition, if some damage has caused the tire to be unusable, it is not worth repairing.

Mushroom nail repair and patch cold repair are our recommended repair methods.

Mushroom nail repair: the inner liner and the carcass are repaired as a whole, and the carcass wire will not be eroded by water. It is a method of repairing tires as a whole, repairing the inner liner and carcass from the inside to the outside of the tires that can be repaired, which is the most professional tire repair method now;

Patch cold repair: repair the inner liner with patches to ensure that there is no air leakage, but the carcass is not repaired. The holes in the carcass can ingest water and corrode the steel wires of the tire.

YH-315 glue for vacuum tires.

1、Remove the tubeless and find the spot where the nail is pierced. The specific method is shown in the following figure:

2. Use a wrench to stretch it up and pull out the nail with pliers. The specific method is shown in the following figure:

3. Use a grinder to polish the position of the piercing, and apply the glue to the position just polished. The specific method is shown in the following figure:

4. Use the corresponding tools to smash the skin evenly to complete. The specific method is shown in the following figure:

Precautions for use:

Tubeless has many advantages, but it is not perfect, and there are still some things that need to be paid more attention to when choosing and using them.

1. The specified air pressure must be maintained.

2. It is not pressure-resistant, and it is not suitable for overload.

3. Tubeless tires should also avoid being punctured and punctured by sharp and hard objects in use, and avoid contact with acid and alkali, as being stained by oil will also accelerate the decomposition of rubber. Tires should be kept clean to prevent rubber aging and prolong their service life.

Strip up: Striping is the most common way to repair tires, stuffing special strips into the holes in the tire, the biggest advantage of this method is that it is quick and convenient, it only takes a few minutes, and there is no need to pry the tire off the steel rim. Defects are not durable and can cope with large wounds, and can usually only be used as a temporary remedy, and if you want to continue to use the tire, you need to make up for it.

Cold Patch:During cold repair, the tire is removed from the wheel hub, the hole is found, the foreign matter around the hole is removed, and a special tire repair film is attached to the inside of the tire to complete the leak repair. This method is similar to the tire repair method of bicycles, except that it requires a special tire scraper and tire repair film to complete.

In this way, although it is possible to repair large damaged surfaces on tires, it is not durable.

Precautions are taken when using vacuum tires.

The prescribed air pressure must be maintained. The vacuum tire is made of high-quality rubber, with good elasticity and strong flexibility, and has a wide range of adaptability to air pressure.

In addition to being punctured, vacuum tires generally do not deflate themselves, so when inflating, they should be checked with an air pressure gauge and maintain the specified pressure.

"How about the tonic method of putting the liquid into the tire"It can corrode the rims, especially the aluminum alloy rings.

Generally, mushroom glue (rubber strip) is used to repair tires.

The best thing is to use a tire scraper to remove the tires and make up for them from the inside

There are two kinds of car tires: hot repair and cold repair, of which the effect of hot repair is better, of course, the cost is relatively high.

You don't have to know this, a professional car mechanic knows how to be good, but you have to tell him that you want to be better. That's it.

It depends on the damage of your tire, the small normal repair can be, vacuum and non-vacuum are actually the difference between the gas inside, and the others are the same.

The easiest way to repair the vacuum tire with a gun, you can operate it by yourself after watching the motorcycle!

The vacuum bucket trembling tire repair rubber nail is good.

If the vacuum tire is damaged, the owner still chooses the method of repairing the tire with rubber nails, because the repair effect of this method is better, and the tire empty source is used for a longer time.

The method of repairing the tire with rubber nails is actually the method of repairing the tire with mushroom nails, and the ** of the mushroom nail tire repair is higher than the ** of the rubber strip tire repair, but its repair effect and durability are higher than the method of the rubber strip tire repair.

The method of repairing the tire with rubber strip is to stuff the tire repair strip coated with glue into the damaged part of the tire to repair the tire. If the vacuum tire is repaired with rubber strips, it can only last for 3-5 months, even if the technology is better, it can only last for 1-2 years, and the damaged position of the tire in the later stage will also have air leakage.

Tubeless has some advantages in digging holes

1. Super wear-resistant = saving money - vacuum tires.

The rim has a larger diameter than a normal rim and is not affected by the heat of the brake drum while driving. Since there is no inner tube and lining, the tire and the wheel rim are sealed as a whole, and when the vehicle is driving at high speed, the high temperature generated by the friction between the tire and the road surface can quickly reduce the tire temperature through the direct heat dissipation of the steel rim inside (hot air), thereby prolonging the service life of the tire.

2. Anti-puncture = safety - the surface of the vacuum tire is a layer of high-quality rubber, the surface tension increases after inflation, forming a certain pressure on the inner surface, improving the self-sealing ability of the break, once punctured, unlike ordinary tires, the gas is all discharged in an instant, and it will last for a certain time, ensuring the safety of high-speed driving.

3. Low fuel consumption = making money - vacuum tires are flat tires in metric units of 315, 295 and 275, and the crown angle of the tire is zero, so the adhesion is strong. It can maintain good driving stability and less friction, which is conducive to shock absorption and increase vehicle speed. The high positioning of the belt layer, the radial runout of the wheel is small, and the drag is small, thus saving 3% of fuel.

It is good to use self-replenishing fluid for vacuum tubes. Because the self-replenishing fluid can quickly repair the leakage point, some self-replenishment fluid is mixed with gas, which is very suitable for long-distance motorcycle travel friends, often jogging gas can not find the leakage point, it is also very convenient to use, the disadvantage is that the rim is very corrosive, especially the aluminum rim.

Although the rubber strip can effectively and quickly repair tires that have been punctured by foreign objects, the disadvantage is that the large holes are not completely repaired, and the area repaired by the rubber strip may leak again when the surface temperature is high in the summer.

Principle and functional use of self-rehydration solution:

Microscopic holes in the tire rubber and poor contact between the tubeless tire and the rim can cause slow deflation. When the vehicle is moving, the tires will be punctured by nails or sharp hard materials on the road surface, causing acute deflating.

However, long-distance high-speed driving, especially in the hot summer months, on scorching roads, can also cause higher and higher temperatures to accumulate in the tires, and eventually a puncture may occur.

Each has its own advantages and disadvantages:1. Self-replenishment fluid can quickly repair the air leakage point, some self-replenishment fluid is mixed with gas, very suitable for long-distance motorcycle travel friends, often jogging gas can not find the leakage point, it is also very convenient to use, the disadvantage is that the rim is very corrosive, especially the aluminum rim.

2。The disadvantage is that the large holes are not completely repaired, and the place where the rubber strip is repaired may leak again when the surface temperature is high in summer.

3。The best I personally think is good for internal supplements, except for the troublesome points, the effect is not to say.

The above three tire repair methods are for bile tubeless tubeless, don't misunderstand.

Hello dear! Yes, the vacuum tire can use self-replenishing glue in winter! First, the vacuum tire is pierced can also use automatic sealant to repair the tire, but the automatic sealant has corrosive damage to the wheel, and some car owners will recommend not to use automatic sealant.

Second, the automatic sealant can be used in an emergency, the method of use is relatively simple, connect the valve, destroy the liquid in the automatic sealant into the tire, the tire will automatically find the loophole, form a layer of sealing film in the place of the loophole, to make up the leakage.