How to solve the new Bora starting meat

Updated on Car 2024-07-21
12 answers
  1. Anonymous users2024-02-13

    Hello, it would be nice to give more fuel when you started. Or clean the throttle.

  2. Anonymous users2024-02-12

    The naturally aspirated engines you buy are like this, you have to press the throttle to the end, don't be reluctant.

  3. Anonymous users2024-02-11

    Hello, if the car starts meat, you can give more gas.

  4. Anonymous users2024-02-10

    The displacement is there, and there is a little meat for household use, just give more oil.

  5. Anonymous users2024-02-09

    This can't be helped, the Bora model is mainly for home use, and the power output is average.

  6. Anonymous users2024-02-08

    There's no way to fix this. The engine is tuned this way at the factory. I care about the power that should have been chosen.

  7. Anonymous users2024-02-07

    This can only be more oil, and if the displacement is small, you must be willing to give oil.

  8. Anonymous users2024-02-06

    The displacement of this car is there, and there is no way to start meat, so give more fuel.

  9. Anonymous users2024-02-05

    This small displacement engine, that's it, don't choose a small displacement if you like to drive fiercely.

  10. Anonymous users2024-02-04

    In terms of the displacement of the car, especially when the air conditioner is turned on, the starting power is normal.

  11. Anonymous users2024-02-03

    The new Bora is positioned as a car, and the start is indeed meaty.

  12. Anonymous users2024-02-02

    Four-valve engineLow torsion is a common feature, and if the effect of low rpm and high torque cannot be achieved by using the short-term linkage development of the two valves, it will feel meaty. When an automatic transmission car is moving, the driver is in D gear, so press the gas pedal if you want to accelerate.

    But if you want to overtake, you can switch to the S gear known as Sport, which will make it easier to overtake. After overtaking, you can shift into D gear again. If you want to make the automatic car fast, you have to make it upshift fast.

    When accelerating to a certain speed, lower the throttle slightly, then the gearbox will move up to first gear, and then slowly press the throttle angle just now to make the vehicle accelerate faster.

    The configuration of the new Bora

    The all-new Bora is equipped with Volkswagen's advanced 7-speed DSG dual-clutch automatic transmission, which controls the gears in groups and can command the shift gear to be on standby at a higher gear at any time to achieve uninterrupted rapid gear shifting.

    The 7-speed gear design has shorter shift intervals without frustration, and the gear ratio is more refined, driving smoothly and comfortably, and the control is handy. The 7-speed DSG transmission also has the advantage of low fuel consumption of manual gear, and the timing of shifts is more reasonable, and the transmission efficiency is higher, resulting in greatly reduced fuel consumption. The advanced engine technology of the new Bora makes the new Bora more powerful, economical and environmentally friendly.

Related questions
9 answers2024-07-21

You should slow down the clutch at the same time (the clutch is lifted to a certain extent, you will feel that the car is a little started, that is, in a semi-linkage state), and then slightly give the throttle, the car is not easy to turn off, the car goes forward, and then you can lift the clutch, and refuel. Or, you give the throttle a little bit (don't give it too much), then slowly lift the clutch, and the car moves forward, and you lift the clutch all the way up. >>>More

6 answers2024-07-21

As a novice, it is better to be a little more rigorous, and when you are proficient, you don't need these passwords, slowly lift the clutch when you start, wait until you reach the separation point of the clutch, and then gently step on the accelerator and wait for the car to move when you slowly lift the clutch completely (note that the action should be slower at the beginning to avoid stalling), and then quickly lift the left foot after the clutch is completely separated, and use the clutch to shift a password is "two fast and one slow". Pressing the clutch should be fast, before reaching the separation point and passing the separation point, it should be fast, and when it is time to travel at the separation point of the clutch, it is necessary to slowly lift the clutch and press the throttle lightly. When changing gears, you must remember to press the clutch to the end in the gear, and it is strictly forbidden to step on the clutch for a long time after completing the gear shift or during driving, which will lead to excessive wear and tear of the clutch! >>>More

3 answers2024-07-21

Condition analysis: First of all, it is best to ask a pedicure master to repair it first. >>>More

7 answers2024-07-21

Hello, this step for your reference:

Star, hang a gear, slightly increase the throttle, loosen the clutch, loosen to a certain extent, the car walks up, increases the throttle, and the car starts quickly. Pay attention to the coordination of the throttle and the clutch, people who have just started to practice, generally like to put the throttle first, and then the clutch does not dare to put it, the engine is buzzing, but the car does not move! I'm also very nervous! >>>More

10 answers2024-07-21

Hello, the motorcycle start is very simple, first of all, you have to put your mind right, don't see it as difficult, the more panicked you are, the more difficult it is to operate. >>>More