What to do if the piece of cloth on the heel of the espadrilles becomes wrinkled

To solve the problem of wrinkled toe toe of board shoes, the materials that need to be prepared include: cotton swab sticks, cooking oil, paper towels, hand cream, and containers.

First, first of all, use a paper towel to wipe the shoes with high wrinkles.

2. Prepare a container and pour an appropriate amount of cooking oil into Qingyuan.

3. Take a cotton swab stick and dip it in an appropriate amount of cooking oil.

Fourth, wipe the wrinkled position.

5. Then squeeze out an appropriate amount of hand cream.

6. Apply to the wrinkled area and let it sit overnight.

Summary. First of all, we prepare an iron and two towels, the towel should be wet and then twisted slightly, and the other should be wet but not too dry, and then take the tide of the wool towel to the toe cap part, use the hand through the towel against the folds, force him in a tight state, and then we cover the wet towel on the toe cap, and finally iron it with an iron at high temperature, the time is not too long, and you can grasp the following about 10 seconds, if the effect is not satisfied for a long time, you need to continue ironing. Then we must pay attention when wearing new shoes and control the folds under intentional conditions, because some folds are not ugly.

But some folds affect the appearance. As soon as the new shoes are worn, the space in the shoes will increase, and the squeeze on the upper will be smaller, but in order to prevent the wrinkles from deepening, you need to put shoe braces in the shoes every day after wearing the shoes to flatten the folds, and then tie the laces tightly.

Hello, if there are wrinkles in front of the shoes, you can prepare an iron and two towels, iron at high temperature with a vertical hole iron, if the effect is not satisfied with the dry for a long time, you need to continue ironing, and then when wearing new shoes, you must pay attention to the fold control under intentional conditions, and every day after wearing the shoes to clean up, put shoe braces in the shoes to flatten the folds, and then tie the laces tightly.

First of all, we prepare an iron and two towels, the towel should be wet and then twisted slightly, and the other should be damp but not too dry, and then take the tide of the wool towel to the toe part of the shoe, use the hand through the towel against the folds, force him in a tight state, and then we cover the wet towel on the toe cap, and finally iron with an iron at high temperature, the time is not too long, and you can grasp the following about 10 seconds. Then we must pay attention when wearing new shoes and control the folds under intentional conditions, because some folds are not ugly. But some folds affect the appearance.

As soon as the new shoes are worn, the space in the shoes will increase, and the squeeze on the upper will be smaller, but in order to prevent the wrinkles from deepening, you need to put shoe braces in the shoes every day after wearing the shoes to flatten the folds, and then tie the laces tightly.

Hope it helps

You can find a professional service staff to do a beauty, leather shoes upper wrinkle solution:

1. The most trouble-free way to wrinkle leather shoes is to take them to a professional shoe store and let professional service staff do a beauty treatment for leather shoes, of course, this cost is relatively high.

2. There is a more cost-effective way to remove wrinkles from leather shoes, use a clean cloth or brush to remove the dust in the wrinkles on the surface of leather shoes, apply a little egg white to the folds of leather shoes, hold up the leather shoes, and then cover a dry cloth on the wrinkles, iron them with an iron, and wait for the surface of the leather shoes to be flat.

3. If the wrinkles on the surface of the leather shoes are deep and large, then the above methods are not applicable. At this time, it is necessary to fill the wrinkles of the shoes with paraffin, iron them with an iron, and then apply shoe polish.

4. Finally, leather shoes wrinkle removal should be based on the root to prevent leather shoes from wrinkling, pay attention to daily maintenance, usually leather shoes should be placed in a dry and ventilated place, do not be placed in the sun exposure, dust can be wiped off with a cloth, often wipe shoe polish. Do not touch acidic and alkaline items.

1. Egg white + ironing method to remove wrinkles, prepare an egg, break the egg and leave the egg white for later use.

2. Then the leather shoes to be wrinkled are propped up with shoe supports, and then covered with a dry cloth at the creases of the leather shoes, ironed with an iron, and used a low-temperature suspension ironing method, about 2cm away from the leather upper.

3. Paraffin wax + ironing + shoe polish, fill a little paraffin wax in the folds of leather shoes, and be sure to fill the gaps evenly until the folds are well recovered.

4. Vaseline, apply a layer of petroleum jelly to the folds, and then rub the shoe polish of the same color after absorption, the leather upper will become soft and the wrinkles will become lighter.

Here are some things you can try:

1. Prepare a little cooking oil, two or three cotton swabs, and apply cooking oil to the folds of the upper to make it smooth, as shown in the figure below.

2. Prepare a box of hand cream (any brand is fine), after the cooking oil is air-dried, apply another layer of hand cream to the folds, as shown in the figure below.

3. After 12 hours, wipe off the hand cream with a paper towel and you can find that the folds are much smoother, as shown in the figure below.

In addition, Vaseline repair methods can also be used. At this time, you can apply a layer of petroleum jelly on the folds of leather shoes, and wait until Vaseline is absorbed, and after wiping the same color shoe polish, the leather surface will become very soft, and the folds will slowly become lighter.

If the folds of the leather shoes are very deep, you can use animal oil to wipe them, such as chicken fat or pig fat, etc., after wiping, bake them over a slight fire, so that the grease can better penetrate into the surface of the leather shoes, and then put the grease-coated leather shoes in a ventilated place to dry, about two or three days, and then wipe the leather shoes with an alcohol cotton ball, apply shoe polish, and the wrinkles on the shoes will basically return to the original.

The solution to the creases in the upper is as follows:

1. If wearing leather shoes for a long time causes the whole shoe to be wrinkled and hard, then you can apply a layer of petroleum jelly (a mixture of paraffin, etc.) on the folds, and the leather upper will become soft and the wrinkles will become shallow.

2. For deep folds, you can take a piece of chicken fat or pork fat and wipe it repeatedly to make the fat penetrate into the skin surface. Then use an alcohol cotton ball to wipe the leather shoes and apply care shoe polish, so that the wrinkles of the leather shoes will basically disappear.

1. First of all, we need to prepare the materials we need, an electric iron, an old clothes, and a damp towel. These are the materials needed to deal with the creases of the upper.

2. Tuck the prepared old clothes into the shoes, the purpose of this is to fill the shoes and hold up the uppers.

3. Spread the moist towel flat on the upper that needs to be repaired.

4. Power on the iron and let the iron work to the required temperature.

5. Quickly put the heated iron on the towel, press the upper of the shoe hard, and slowly move the iron until the upper is ironed.

6. Finally, take out the old clothes in the shoes and dry the shoes to finish.

1.Deoxidizer (main ingredients: activated iron powder, activated carbon, table salt silica gel desiccant (can be used repeatedly, the desiccant is blue at the beginning, and the water absorption will turn red to a certain extent, at this time, the silica gel desiccant is dried in the microwave oven, and it can be used again when it turns blue).

2.How to use: Put each shoe in a sealed bag, and put 15g of oxygen absorber and 20g desiccant in each sealed bag.

3.The ratio of oxygen absorber and desiccant cannot be changed arbitrarily. The more desiccant you put the better, otherwise it will affect the efficacy of the deoxidizer, because the deoxidizer needs to react with water to deoxygenate.

4.And how much oxygen absorber needs to be put in, here is how to judge whether the amount is enough, the oxygen content in the air is 21 percent, so you put the oxygen absorber.

5.After a while, as long as the gas content in the sealed bag is reduced by about one-fifth, it means that the oxygen in the sealed bag is consumed and it is OK. At this time, the rest of the sealed bag is basically nitrogen, not to mention the preservation of shoes, and most of the high-end food used to preserve high-end food under the current technology is pure nitrogen.

6.The reason why the sealed bag is used again is to isolate the environment around the shoes from the air environment. Be sure to use a sealed bag, otherwise the validity period will be greatly reduced.

7.The sealed bag does not isolate the air, and I speculate that it may be because of the quality of the sealed bag used by that buddy. It can be put in water for experiments. Here it is recommended that you buy a sealed bag with a thickness of more than 20 wires.

How to repair the wrinkles of leather shoes:

1.Leather shoe beauty shop.

Nowadays, there are also shoe beauty shops, shops that specialize in repairing leather shoes, and if the surface of the shoes is wrinkled, they can be sent to the shoe beauty shop for repair.

2.Iron. If you have an iron at home, you can also wrinkle your shoes yourself, cover them with a cloth, and then iron them with an iron.

3.Egg whites.

You can also use egg whites to remove the wrinkles on the surface of the shoes, apply the egg whites to the surface of the shoes, and after repeated application and even application, the wrinkles of the shoes can be removed.

4.Shoe polish.

If it is an old pair of leather shoes, you can also wipe them with shoe polish to make the shoes newer and remove the wrinkles in the leather upper.

Normally, after walking for several weeks, when people walk, the foot will be bent after lifting the foot, and it is normal for the upper and instep to wrinkle after bending, but if you wear shoes for two days, the wrinkles should obviously be a problem with the workmanship of the shoes, the upper is not set enough, or the instep curvature is not enough, etc., it is recommended to re-set the last at high temperature.

Normal phenomenon mainly depends on their own usual maintenance.

1. Wine immersion method.

Pour the liquor (about 25 grams) into the new leather shoes, shake it a few times, and put it for an hour before wearing it, the leather will no longer be hard, and the shoes will no longer clamp the feet. If it is a leather shoe edge empty edge to grind the foot, such as the heel, you can dry the wet paper towel, then fully soak the liquor, fix it on the leather shoe part of the foot grinding place with a clip, leave it overnight, and wear it again the next day will not grind the foot.

2. Rolling method.

If the edge of the new leather shoe is partially rubbed on the foot, you can use a wet towel to cover the foot grinding area for a few minutes to make it wet and soft, and then use a cylindrical object (such as a glass bottle) to roll it out several times to press the foot grinding part smooth and flat, and the foot will not be rubbed again.

3. Wedge palm method.

If the new leather shoes are more serious, you can use a wet towel to cover the wet, and then use the shoe wedge to prop up, and it will be smooth to wear.

4. Hammering method.

If the sole shed of the new leather shoes is not used to grind the feet, you can put it on the shoe crutches, hit it hard with a hammer, and knock the grinding place flat, and what to do if the new shoes grind the heel. If you don't have shoe crutches, you can also use other iron tools instead.

1. Prepare a band-aid: If you want canvas shoes without grinding your heels, you can prepare your own band-aids and stick them on the heels of your feet, so that you won't grind your heels.

2. Softening the glue: When the shoes are made, a layer of glue is brushed to cause the upper to be hard and grind the feet, so we can use warm water to soften the glue on the upper, so that the heel will not be grinded.

3. Wear thick socks: If canvas shoes are unbearable, the quickest way is to wear a pair of thick cotton socks for heel protection, which not only protects the heel from the pain of grinding the foot, but also expands the space inside the shoe, so that the shoes become more and more fitted.

Newly bought mesh shoes are full of pores, and rubbing a layer of shoe polish to fill them up before wearing them can keep them smooth for a longer time, and they will shine brighter later. Whether it is durable or not has a lot to do with the maintenance of flat land silver.

Correct maintenance method for leather shoes: Recently, more and more people have been using the simple and convenient shoe polish of "Shine and Shine" dates. However, it is necessary to wipe carefully and without sloppiness in order to prolong the life of the shoes. The correct order is as follows:

Brush the entire shoe with a large shoe brush to see if the protrusions on the brim are stained?

For uneven parts such as shoe edges or seams, use a small shoe brush to brush off dirt and fine dust.

Loosen the laces and use a small shoe brush to remove dirt that is not visible from the outside.

Squeeze a little cleaning oil onto the cloth and coat the entire shoe, at this time, the most important thing is to thoroughly apply the old shoe polish that remains on the shoe.

Take another cloth (not to be mixed with a cloth that uses cleaning oil), dip a little shoe polish over the stool, and coat the entire shoe. Shoe polish is about the size of your little finger.

Once the entire shoe is coated, polish the entire shoe with a clean, soft cloth. The details must not be sloppy.

Finally, spray with a waterproof mist. The waterproof mist not only protects the shoes from water, but also makes them less susceptible to dirt.

After the waterproof mist has dried, place the last into the shoe.

Maintenance method after wetting: After the shoes are wet by rain, make appropriate disposal immediately, and the shoes can be destroyed early so that the shoes will not be deformed.

First, use a fabric with good water absorption to absorb the moisture from the surface of the shoe. If you wipe it too hard, the dirt attached to it will scratch the skin of the shoes, so you should pay special attention.

Put newspaper or toilet paper inside the shoes and replace them to absorb the moisture completely.

When it is dry, it should be put in the last to prevent deformation. Then place it in a ventilated place to dry.

After it is completely dry, it is maintained according to the general maintenance method.