What are the precautions when using burned honeycomb cinders to make flower soil?

It's pure nonsense, you know, the powder of the soil, the finer, don't plants grow on the earth? So when I do it, soak the cinders in water, drain the water several times, and use it directly when it is broken, so you can use it with confidence. Make it into kernel-sized pellets.

It can play the role of water permeability and breathability. And its small pores are also able to absorb some nutrients. If the capillary root grows, it will be absorbed directly here, which can also promote plant growth.

So how to deal with it? Honeycomb coal is really hard to find now, especially in recent years, when the country has controlled smog and many places have stopped burning coal. However, some remote places, or an early stall can still be found, and Dawn picked up some a few days ago, planning to give the succulent soil.

<> weakly alkaline soil. This is not conducive to the growth of flowers, because most flowers prefer weak acidity. Put it in clean water and soak it for two to three days.

Or, if you're about to use it right away, take it under the tap and rinse it for a few minutes. I'm lazy, just put it on the top floor to rain for a while, take it back when you want to use it, spray some water with a watering can, break it through the sieve, and mix the soil directly. Take as much as you want, so it is cleaner, saves time and effort, and the effect is the same.

It must be treated before it can be used to grow flowers, because the content of cinder sulfide left behind after the combustion of honeycomb coal is relatively high, and these sulfides are harmful to the growth of flowers and plants without treatment.

You don't need to spend money to buy it and take it home to plant flowers and plants, the effect will be better than what you bought, like the honeycomb cinder used at home can be used to make flower soil. Honeycomb cinder needs to pay attention to things, some places of coal, contains more sulfur, it is best to soak in water for a few days before use. Cinders are generally neutral, but also weakly alkaline, and acid-loving flowers generally need to adjust their pH.

The cinder produced after combustion contains silica, calcium oxide, iron oxide and some sulfides, which are weakly alkaline. So what do you need to pay attention to when using honeycomb cinder to make flower soil?

First of all, the honeycomb coal is dried for a few days, then the honeycomb coal is crushed, and the black coal inside is picked out, and then the cinder is soaked in water for three or four days, and finally it is washed and fished out.

Because this kind of soil is very soft, it can only be used after pressing, and it will be very dirty during the production process, so be careful, and there may be sparks at the same time, so be careful of the fire source.

The amount of calcium, potassium and other elements contained in the coal ash after coal combustion is very small, and the effect on increasing the fertility of the soil is not too large, and some coal also contains heavy metals, etc., if blindly used as fertilizer in the field, it will pollute the soil, and even cause harm to crops. However, this does not mean that coal ash should not be used as a fertilizer at all, it can be fermented with other manure to increase soil fertility.

The honeycomb coal should be soaked before being crushed. And after soaking, its alkalinity and some harmful substances will disappear without causing damage to the flowers.

In the first step, the remaining cinder after the coal has been used is packed in whole pieces, and we cannot directly use the whole cinder to grow flowers, so we need to use tools to crush the whole cinder. The second step, we have to prepare a sieve, the first step we have crushed the cinders, now you can directly put the cinders in the sieve, the result will be sieved out a lot of particles of different sizes, if you feel that the first sieve is not careful, you can sieve several times, and finally get cinders, these granular cinders are the key to planting flowers. In the third step, put the sieved cinder in a container and pour water to soak.

When pouring the water, just over the cinders. The fourth step, this step is the key to the whole process, we need to find a sieve with a diameter of millimeters to sift cinders in the water, why in the water? Because there is no interference of dust in the water, we use a millimeter sieve to screen out the cinders, put them in another container, and then we need to find a sieve with a smaller diameter, about 1 mm is OK, and screen again, this time we must screen out the cinders with smaller particles and put them in another container for preservation, and then, find a sieve with a smaller diameter again for screening, and select a smaller cinder to put in another container.

The remaining cinders are useless and can be directly discarded.

Benefits of raising flowers.

Clause. 1. Regulate the temperature and beautify the environment. Raising flowers on the balcony can make flowers welcome spring, green shade to protect summer, autumn red leaves, winter snow and pine, and beautify the environment in all seasons.

Clause. 2. Enrich life and invigorate spirits. When you are tired after hard work or free time, you will definitely feel relaxed and tired when you see red flowers and green leaves.

Clause. 3. Exercise to improve health. Raising flowers is a series of labor such as transplanting and changing pots, which can be properly exercised and is very beneficial to the human body.

Clause. 4. Increase knowledge and cultivate virtue. Learning the technique of raising flowers can increase knowledge and cultivate the virtue of cherishing human and material resources.

Clause. Fifth, flowers can convey beautiful feelings. Sending relatives and friends is sincere and meaningful.

You can make flower soil, you need to thoroughly grind cinders into powder, and you need to mix some other soil to make flower soil, pastoral soil, sand and so on to mix it will have a better effect.

Of course, it can be used as flower soil, and it is also very easy to use, because after adding cinder, it will become loose and breathable, and as for the use item, it only needs to be smashed into pieces to mix into the soil.

After honeycomb coal is fired at high temperatures. There will be many small holes in its residue, the air permeability is very good, and after high temperature firing, there are no germs in it. Make it into kernel-sized pellets.

It can play the role of water permeability and breathability. And its small pores are also able to absorb some nutrients. Soak the honeycomb cinder first and then crush it, if the size of the container can't put too large pieces of honeycomb cinder, you can crush and soak it again, basically soak for a week before you can use it.

Absolutely. First take out the cinders, then spread a layer around the flower, you can provide nutrients, and then watering can better keep warm, and then the flower grows better.

After being placed for a period of time, it is processed with a hammer and crushed into a crushed shape, and it is necessary to pay attention to it, not to put too much, otherwise it will not have an effect.

First of all, they have some residual sulfide after combustion, and at this time, they need to be crushed and left in the air to dry for more than a week. Then you can mix some soil or some weeds into the pot. Be sure to pay attention to the amount of weeds and the amount of soil must be small.

Mix it evenly with the soil in the pot, and stay away from the roots of the flowers, not too much, and mix it in a ratio of 2:1 between soil and cinder.

Honeycomb coal flowers must be soaked in water for a few days, and then the particles should be made smaller, and not too much.

It is completely possible to mix the soil to plant flowers, because the burned honeycomb coal is commonly known as briquette, which belongs to sandy soil according to the division of planting, and the pH value is neutral.

The honeycomb coal that has been burned can be directly crushed and mixed with soil to plant flowers, because the honeycomb coal that has been burned Bai is commonly known as briquette.

du, according to the kind zhi

The division of plants belongs to sandy soils, and the pH value is neutral.

1. The degree of dryness and wetness of cinder in each season is not the same, when the rainy day is too long, it dries very slowly, and when the weather is good, it dries quickly, so it is recommended to add some red jade soil to neutralize the medium of the soil, so as to make it dry and wet, the effect is good, not that the red jade soil is not good here, it is not good there, the red jade soil is not used well, the same plant is not good, the emphasis is on what kind of reasonable use of it.

2. Another tip is that when the cinder is mixed with soil, it is best to mix small and medium-sized particles together, so that the medium is easier to be loose and breathable, and it is more conducive to the growth of succulent roots.

The honeycomb coal burned is a very good flower soil, which is not only loose and breathable, not waterlogged, but also contains a lot of trace mineral elements.

It needs to be brewed with water or water mixed with a little vinegar for about half a day. When used, it needs to be mixed with garden soil and understory humus. The amount of coal ballast used is about 20% or less. Suitable for most flowers.