Upstairs flush toilet leak what can be done without knocking on the floor tiles?

How to solve the upstairs toilet leakage and don't want to knock on the floor tiles? First of all, you need to determine the cause of the water leak. There are generally three forms of toilet leakage.

1* The toilet is cracked and leaking. 2* Glue aging and seepage of the toilet bowl and the joints of the pipe and the ground 3* The pipe under the toilet is leaking.

The second is the solution. 1* If the toilet is cracked and needs to be replaced, there is generally a gap between the toilet and the tile, remove the adhesive part, and directly ask the master to remove the entire toilet bowl and replace it. 2* If there is water seepage at the seam between the toilet bowl and the ground, you can buy a tube of glue to put it on, if it doesn't work, it means that it is not this problem.

3* If there is a problem with the pipe under the toilet, then the toilet must be unloaded and repaired, and the floor tiles must be knocked when necessary.

In addition, if you live in a city building, the upstairs bathroom leakage can first open your own bathroom ceiling to see if the glue of the lower half of the pipe interface is aging and seeping, and then find the property to help repair it.

The flush toilet is installed on the tile, and it can be lifted directly that is the glass glue coated in a circle, and the glass glue can be removed to take it off.

If the toilet is leaking, can you take a look at the waterproofing upstairs directly? Or will it affect you? If it affects your home, you can ask them to give you compensation, or repair the house, etc.

Here is a very realistic example, my father has a friend who rented out a commercial house, and there was no problem in the first few years, and then the tenant reminded him many times that there seemed to be a problem with the flush toilet in this houseBecause it is a waste of water, the monthly water bill has been on the high side, but my father's friend didn't take the issue seriously.

If there is a ripple on the surface of the toilet water, it is running water.

Later, the tenant said goodbye and directly owed more than 3,000 yuan in water bills, what is this concept? It is almost equivalent to the water bill of a normal household for several years. And what's even worse is that after discovering this problem, my father's friend didn't even remove the toilet to check the problemInstead, he only replaced a component to prevent water from running inside the toilet, and rented out the house again

As a result, it wasn't until the downstairs residents came up to them that they found out that the waste of water in the toilet was not only a problem of aging internal components, but also a failure to install it at that time. To put it simply, because the edge of the toilet drain is not waterproof, the toilet has been automatically repeating the actions of leaking, draining, leaking and drainingLater, as the damage to the inside of the toilet deepened, it not only caused the water bill to soar, but also seeped more toilet water downstairs

The roof of the bathroom is leaking.

What's more interesting is that the downstairs residents not only transformed the original bathroom into a warehouse, but also used aluminum alloy gusset in the ceiling, so that there is little attention in the space; On the other hand, the upstairs seeped down, and almost all of it was preserved in the aluminum alloy gusset of the entire ceiling. That is to say,It was not discovered until the water leakage was very serious, and the water in the aluminum alloy gusset overflowed and flowed to the goods (electronic equipment).

To sum up, when the property staff finally came up to check, they had just uncovered the aluminum alloy buckle plate downstairs, and the water flowed down like a waterfall. This shows how serious the water leakage was upstairs at that time. Long story short, just because a flush toilet didn't fit, Dad's friendNot only did it take a lot of time and energy to restore the original upstairs decoration facilities back and forth, but also finally compensated for the property damage of several thousand yuan downstairs, directly makes an originally small thing become a big thing, and the typical gains outweigh the losses!

Yes, a lot of our maintenance work is to solve this problem. It usually leaks down the perimeter of the drain pipe on the ground.

If the waterproof is not done well, it will leak.

The reasons why a flush toilet leaks are as follows:1. The rubber ball valve is broken: once the rubber ball valve is broken, the sealing of the entire water tank is not good, just like there is a hole in the wooden barrel, so the water will continue to flow out.

2. Aging of the rubber gasket of the mixing port: After long-term use, the rubber gasket will become thinner and thinner, and eventually it will be completely aged.

3. The link between the floating ball and the water inlet switch is loose: open the toilet tank, we can see a small ball floating on the water surface, and the small ball is connected to the water inlet with a water pipe, check whether the connection between the two is tight, if it is loose, just tighten the connection.

4. The water tank is damaged by external force: the water tank may be damaged by external force, resulting in water leakage.

Leaky toilets are a very common problem, but if not dealt with in time, it can lead to a lot of trouble and inconvenience. Here's how to deal with a leaky toilet:

1.Check for leaks: Start by checking the leaks, sometimes just a drop on the outside of the toilet, sometimes water leaking from the bottom. If it is water leaking from the bottom, it needs to be checked more closely.

2.Adjust the seat or screws: If the bottom is leaking, it may be that the seat is not installed properly or the screws are loose, and you need to loosen the mounting screws and reinstall the seat seat. If the seat cover is badly worn, the seat will need to be replaced.

3.Replace the seal: If the bottom seal of the toilet is leaking due to aging or damage, you need to replace it with a new seal. This process requires the entire toilet bowl to be removed, so a professional is required to operate it.

4.Check the water tank: If the water is flowing from the tank to the toilet bowl and is not stopping, then you need to check if there is a problem with the float and filling valve of the tank. It may be necessary to adjust the float and filling valve, or even replace the entire filling valve.

5.Repair minor damage: If the toilet has small cracks or leaks caused by chips, you can use toilet sealants, sealants, etc. to repair them. However, this method can only be used as a temporary measure, and once the damage is severe, the toilet still needs to be replaced.

In short, Weidan toilet leakage is a problem that needs to be solved urgently, for some small problems can be dealt with by yourself, for the need to replace some parts or replace the toilet with serious problems, you need to ask professional maintenance personnel to complete.

Hello dear, let you wait for a long time, which means that your toilet has a leaking situation, the toilet leaks, mainly consider the following two situations 1The flange ring between the toilet bowl and the pipe is damaged, and there is a leak 2The sewer pipe is leaking in your home, I personally think that there is a high probability that there is a problem with the flange ring connecting the toilet and the pipe, you can find a professional master to check it out, I hope my answer will be helpful to you, if you have any questions, please continue to ask, thank you