What is the reason for water seepage when circulating water in the bottom filter fish tank?

If you don't turn on the pump normally, it means that your fish tank, including the bottom filter tank, is not leaking, and the tank is good, then look at the pipe and edging, and there is the filter cotton. The pipe interface will be leaked; Wrap the edge to see if there is a good glue, whether it is possible to seep out; There is also to see if the filter cotton has not been washed for a long time, and the water is full from the side, which should be the only possible way.

There may be several reasons for water seepage when circulating water in the bottom filter fish tank:

1.The filter is not tightly sealed, causing water to leak out of the gaps.

2.Improper placement of the filter media, or too much blockage in the filter, resulting in too much water accumulation inside the filter, which can overflow.

3.Cracked, broken, or aged filter pipes can lead to water leakage.

4.If the filter water flow is too large or too small, it may cause water to overflow through the gap or water cannot be circulated inside the filter.

5.Improper filter installation, uneven installation position, unstable plugs, broken wires, etc. may cause the filter to leak.

6.The water level in the fish tank is too high, causing water to leak through the gaps.

7.Faults inside the filter, such as a damaged pump or damaged electronics, can also cause a water leak.

Please check and troubleshoot the problem based on these possible causes. If the problem persists, it is advisable to seek professional help.

Triple overflow theoretically how much water into the fish tank beyond the overflow plate on how much water, after the power outage stopped the water, the water is blocked by the overflow board waterline, so if the water has not stopped after the power outage, there are two possibilities, one is that the water flow exceeds the water (the sewer pipe is too thin to empty the water in time to replenish the water into the fish tank), the other may be the triple overflow layer leakage, if the power outage is more than 10 minutes and still non-stop flow, it is recommended to check whether the overflow layer is damaged, cracked and leaking, If there is no water after a few minutes after the power failure, it is caused by the water pipe is too thin and the water flow is too large, it is recommended to reduce the flow, too large flow and head for the player except to waste electricity.

1. How to deal with slight water seepage at the bottom of the fish tank.

If there is a slight water seepage in the fish tank, you must pay attention to it, because if it is not dealt with in time, the situation may become more and more serious. First of all, find the place of water seepage, drain the water in the tank, put it in a ventilated place to dry, and then use a glue gun to apply glass glue to the leaking place.

And wait for it to air-dry. Usually, the fish tank can be reused one day after gluing. Of course, if the situation is not serious, it can also be repaired directly from the outside during use.

2. How to clean up the fish feces at the bottom of the tank.

1. Installation filtration: If there is fish feces at the bottom of the tank, the best way to clean it is to install filtration, as long as the power of filtration is sufficient, the water flow will suck the fish feces into the filter material, and then decompose it. If the outlet of the filtration is relatively small, a wave maker can be installed, which can break up the fish feces, so that it is more convenient to filter out.

2. Regular water change: In addition to filtration, you can also clean up when changing water. Usually change the water once a week or half a month, prepare a water pipe, pass it to the bottom of the fish tank, and use the siphon method to pump out the water at the bottom of the fish tank, so that some dirt can also be sucked away, and then mix in new water from the tank wall after pumping.

3. Reduce feeding: Feeding fish needs to be fed bait, but it is often difficult for fish to have a sense of satiety, so they will eat all the time, and the digestion is fast, so the fish are easy to increase. If you want to reduce fish feces at the root, the best way is to reduce feeding, and you can feed until you are seven or eight minutes full at a time.

After the power failure of the fish tank with the bottom filter, the water below generally does not overflow.

There are two main types of bottom filter fish tanks, and these two fish tanks will not overflow after a power failure.

The first is overflow drainage, that is, the water in the main tank overflows into the bottom filtered tank. When the power goes out, the water from the bottom filter will not be pumped up, and the fish tank will not overflow.

The second type is the siphon type, which will block the siphon after a power outage, so there will be no water overflow.

There are many filtration methods for fish tanks, such as upper filtration, back filtration, waterfall filtration, bottom filtration, etc., and different fish tanks can choose different filtration methods. If it is a small fish tank, you can choose waterfall filtration or upper filtration, these two filtration methods do not have high space requirements, and the filtration effect is also okay. If you are a large fish tank, you can choose a back filter, a side filter or a bottom filter, the bottom filter is the best, but you need to add it when you need to make a fish tank.

Back filtering and side filtering can be added by yourself.

What happens if the bottom filter fish tank only pumps water up and doesn't flow down?

Hello dear. The pipe is clogged or the valve is broken. Find a wire poke, 1 first check whether the key is leaking and the siphon cannot work.

2.Whether it is a siphon or a triple siphon to see if there is an air leak and whether the overflowing pipe is blocked. Triple overflow, need to reach the upper inlet of the overflow pipe where the water will be launched, in the check that the sewer switch is not turned off, the bottom filter is by the above water level full overflow out of the tank, the water pump is pumped up so that the circulating bottom filter fish tank is not immediately pumped when it is pumped, because the height of the horizontal plane is not raised above the height of the sewer pipe, after pumping for a while, it is about 1 to 2 cm beyond the original water level and then gradually launched, if there is no water in the bottom filter during this period, water should be added to meet the water pump. After the start of the water, the pump will stop filling the water as soon as the submersion water pump is submerged, and the amount of water added is the most appropriate.

The way the water comes out of the bottom filter tank is generally overflow. There will be an overflow area in the bottom filter of the fish tank, and the water in the fish tank will flow into the filter area at the bottom of the fish tank after reaching the overflow area.

Once the water has passed through the filtration zone, it enters the pumps, where they recirculate the water again.

The bottom filter is one of the better filtration methods, but this kind of filtration system is generally built by the fish tank, and it is more troublesome to transform it yourself.

Most of the bottom filter fish tanks will have a water hole at the bottom, which can be controlled by a drain valve. When the keeper wants to change the water, he can connect the water pipe at the location of the drainage hole, drain the water inside, and then add new water. However, when draining, the pump needs to be turned off to avoid damage to the pump's motor.

If there is no drain hole at the bottom of the bottom filter fish tank, then it is necessary to place the pipe in the fish tank according to the normal water change method, first pump out the old water, and then use the water pump to inject new water.

<> bottom filter fish tank pump is stopped and the water is reversed, indicating that there is too much water and some water needs to be discharged. This type of fish tank generally has a large volume, a lot of fish are raised, and the filtration effect is very good, so there is no need to worry about the deterioration of water quality. It should be noted that it is precisely because of the large volume that the requirements for the pump are also very high, and if the power is insufficient, it cannot achieve the effect of maintaining water quality, so it is more power-intensive.

If the bottom filter cabinet of the fish tank seeps water, it means that there is damage in some places and must be dealt with immediately, otherwise the tank may burst. First of all, the fish should be fished out, then check the location of its leakage, and after finding it, you can put the water away, and in the leaky place, use a glue gun to hit the glass glue on it. After the glue is repaired, it can not be filled with water immediately, but it should be put in a ventilated place to air dry, wait until it is fixed, and then try to leak again, and then you can re-raise fish.

If the bottom filter cabinet of the fish tank seeps water, it means that there is damage in some places and must be dealt with immediately, otherwise the tank may burst. First of all, the fish should be fished out, then check the location of its leakage, and after finding it, you can put the water away, and in the leaky place, use a glue gun to hit the glass glue on it. After the glue is repaired, it can not be filled with water immediately, but it should be put in a ventilated place to air dry, wait until it is fixed, and then try to leak again, and then you can re-raise fish.

1. Uneven bottom: The main reason for water leakage is that the bottom is uneven, which will cause the fish tank to be overstressed in a certain aspect, which will lead to the cracking of the glass. In view of this situation, you must pay attention to the position of the fish tank, fill it with water to see if there is any difference in the water level, and if so, you need to put something in a lower place.

2. The material is not good: if the material of the fish tank is not very good, there will also be water seepage. The more recommended glass is generally float glass or ultra-clear glass, which not only has sufficient hardness, but also has high transparency, which is easier to watch when raising fish, and is generally not easy to damage, so ordinary glass has a certain risk.

3. Uneven force: If the fish tank is unevenly stressed, it will also be damaged, which will lead to water seepage, which may be caused by heavy objects above the fish tank, or the area at the bottom is smaller than the fish tank.